Is the Lynk & Co 03 Front-Wheel Drive or Rear-Wheel Drive?

1 Answers
OJonathan
07/30/25 12:08am
Lynk & Co 03 is front-wheel drive. Here is the relevant introduction about Lynk & Co 03: Dimensions: Lynk & Co 03 is a compact car under the Lynk & Co brand, with a length, width, and height of 4639 mm, 1840 mm, and 1472 mm respectively, and a wheelbase of 2730 mm. Engine: Lynk & Co 03 is equipped with three engines in total, which are the low-power version 1.5L turbocharged engine, the high-power version 1.5L turbocharged engine, and the 2.0L turbocharged engine. The low-power version 1.5L turbocharged engine has a maximum power of 115 kW and a maximum torque of 245 Nm. This engine is equipped with direct injection technology and uses an aluminum alloy cylinder head and block. The high-power version 1.5L turbocharged engine has a maximum power of 132 kW and a maximum torque of 265 Nm. This engine is equipped with direct injection technology and uses an aluminum alloy cylinder head and block. The 2.0L turbocharged engine has a maximum power of 140 kW and a maximum torque of 300 Nm. This engine is equipped with direct injection technology and uses an aluminum alloy cylinder head and block.
Was this review help?
18
3
Share
More Forum Discussions

What to do if you haven't taken the test after the six-month suspension of your driver's license expires?

Within 15 days, register at the original vehicle management office and other designated places to participate in a seven-day study of road traffic safety regulations as required. Within 20 days, take the exam organized by the traffic safety regulations. If you pass the exam, you can then retrieve your driver's license from the traffic police department. If you fail the exam, you will need to continue with the study and retake the exam. Failure to participate in the study and exam as required may result in the vehicle management office suspending your driver's license.
13
0
Share

Why did the oil light flash a few times and then go off?

The reason the oil light flashes a few times and then goes off is due to low pressure during cold engine start-up. Here are the reasons for the oil light illuminating: 1. Insufficient oil level: Normal oil consumption reduces the oil pump's output as the oil volume decreases, eventually leading to low oil pressure and triggering the warning light. 2. Engine overheating: Prolonged aggressive driving keeps the engine under high temperature and load conditions. Even with sufficient oil, elevated temperatures thin the oil, causing it to leak through component gaps and resulting in low oil pressure. 3. Oil pump failure: Wear or improper assembly of oil pump components creates excessive clearances, causing the pump to malfunction by either not delivering oil or delivering insufficient oil, which activates the warning light.
15
4
Share

How to Deal with Bubbles in Rear Window Car Film?

Here are the solutions for bubbles in the rear window car film: 1. Bubbles appearing immediately after installation: If bubbles appear shortly after applying the rear windshield film, and the bubbles contain white spots, it is usually due to improper handling of moisture between the film and the glass during installation. The moisture will evaporate and form small white bubbles the next day or over time, but these bubbles will not be large or numerous. This situation does not affect normal driving, and the bubbles will disappear once the moisture evaporates. 2. Bubbles appearing long after installation: If bubbles appear several years after installation and gradually increase in number and size, it might be due to the use of low-quality film. Over time and exposure to UV rays, inferior films can release toxic gases like formaldehyde, causing bubbles. In such cases, the car film should be replaced immediately, as continued use can pose health risks.
16
0
Share

What are the temperature conditions for engine oil storage?

Engine oil should be stored at a temperature between 23-30 degrees Celsius. Below is relevant information about engine oil: 1. Four-stroke engine oil: The winter oil grades in the SAE lubricant viscosity classification are 0W, 5W, 10W, 15W, 20W, and 25W. The symbol W stands for winter, and the smaller the number before W, the lower the low-temperature viscosity, the better the low-temperature fluidity, and the lower the applicable minimum temperature. 2. Two-stroke engine oil: Two-stroke gasoline engine oil has two viscosity grades, namely SAE20 and SAE30. Generally, SAE30 is selected. If it is separate lubrication, used in cold regions, or for ultra-light load two-stroke engines, SAE20 is used.
5
4
Share

Does Tire Oil Damage Tires?

Tire oil can indeed damage tires. Gasoline has a swelling effect on rubber, and when gasoline molecules penetrate the tire's cord structure, they can separate the cords from the rubber, creating voids and thereby reducing the tire's strength. Used engine oil contains impurities that not only fail to maintain the tire but can also damage it, being highly corrosive and accelerating the aging process of the tire. Instead, applying tire wax is recommended. Its primary function is to restore the tire's original new appearance, block UV damage, prevent rubber from aging, cracking, and fading, effectively extending the tire's lifespan. It can thoroughly remove oil stains and dirt from the tire and provides a protective layer to prevent the tire from hardening. After application, it restores the tire's original black color, leaving it clean, shiny, and resistant to dirt.
9
5
Share

Is Neutral Gear the Same as P Gear?

Neutral gear is not P gear; N gear is the neutral gear. Automatic transmission vehicles are equipped with both P gear and N gear. Both P gear and N gear can be used when parking, but they are different, and their usage scenarios also vary. The structures of N gear and P gear differ: P gear has a locking mechanism, while N gear does not. When P gear is engaged, the locking mechanism can lock the transmission gears, which indirectly locks the wheels. In this state, the car cannot move even without applying the handbrake. When N gear is engaged, there is no locking mechanism to secure the transmission gears, so the car can move if the handbrake is not applied. N gear is used for short-term parking without turning off the engine, while P gear is used when parking and turning off the engine.
4
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.