Is the Hongqi HS5's Eco Mode Fuel-Efficient?

What does the teapot symbol on the dashboard mean?

A teapot symbol illuminated on the car dashboard indicates the engine oil pressure warning light. Here are the reasons why the oil pressure warning light may stay on: 1. Insufficient lubricating oil in the oil pan, unsuitable lubricating oil grade, or too low viscosity; poor anti-foaming performance of the lubricating oil, causing air to mix into the oil circuit; 2. The oil pump diaphragm is broken, allowing gasoline to leak into the oil pan, or due to a damaged cylinder head gasket or cracked liner, cooling water leaks into the oil pan, diluting the lubricating oil. Here is more information: The main reason the oil pressure warning light comes on is insufficient engine oil pressure. The most common cause of engine oil pressure failure is insufficient oil volume. If the oil volume is insufficient, the oil pump's pumping volume decreases or fails to pump oil due to air entering, leading to a drop in oil pressure. The crankshaft and bearings, as well as the cylinder liner and piston, will experience accelerated wear due to poor lubrication.

8

1

Share

How to Remove Paint from Car Body?

Here are five methods to deal with paint on the car surface: 1. Banana Oil: Commonly known as thinner, dip a towel in banana oil and gently wipe the paint spots. It can dilute the paint and effectively clean the spots, followed by rinsing with clean water. However, banana oil is toxic, volatile, and slightly corrosive, which may damage the car paint, so extra caution is needed during use. 2. Gasoline: Gasoline can dissolve paint effectively with minimal corrosion. The steps are the same as with banana oil. 3. Alcohol: Paint can be removed by wiping with alcohol (industrial alcohol). Use a soft cotton cloth dipped in alcohol and gently wipe the paint. 4. Essential Balm: Essential balm has a paint-dissolving effect and can also be used to clean paint spots, following the same steps as with alcohol. 5. Tar Remover/Paint Thinner: Tar remover can also dissolve paint. Spray it evenly on the paint spots, wait for a while to soften and dissolve the paint, then wipe with a towel and rinse with clean water.

6

1

Share

Can Cars Use Aviation Kerosene?

Cars cannot use aviation kerosene. Aviation kerosene has much lower volatility compared to gasoline. Using it in an unmodified gasoline engine system will result in ignition difficulties, causing abnormal operation of the engine cylinders. More details are as follows: 1. Aviation kerosene is one of the petroleum products. Its English name is Jet Fuel, also known as odorless kerosene. It mainly consists of hydrocarbon compounds with different distillation fractions. 2. Aviation kerosene has a suitable density, high calorific value, and excellent combustion performance. It burns rapidly, stably, continuously, and completely, with a small combustion area, minimal carbon deposits, and low tendency for coking. It also has good low-temperature fluidity, meeting the requirements for fuel fluidity in cold regions and high-altitude flights. It possesses excellent thermal stability and oxidation stability, suitable for supersonic high-altitude flights. It has high cleanliness, free from harmful substances like mechanical impurities and water, with low sulfur content, especially low mercaptan sulfur content, resulting in minimal corrosion to engine components. 3. Aviation kerosene is suitable for gas turbine engines and ramjet engines, meeting the requirements for supersonic aircraft with low saturated vapor pressure and good thermal stability. Additionally, because kerosene is less volatile and has a higher ignition point, gasoline is often used for starting gas turbine engines. Aviation fuel also contains various additives to improve certain performance characteristics of the fuel.

13

5

Share

Which one is the turn signal fuse for the Sylphy?

The fuse for the Nissan Sylphy's turn signal is located in the fuse box in the front engine compartment. The specific position of each component's fuse is recorded on the inner side of the fuse box cover. If the fuse is damaged, you need to locate it according to the repair manual and then replace it. The turn signal is an indicator light that alerts vehicles and pedestrians when the vehicle is turning. It uses a xenon tube and is controlled by a single-chip microcomputer circuit, with the left and right lights flashing alternately without interruption. The method to check if the turn signal is not working is as follows: Check if there is power at the hot wire terminal of the flasher relay. If there is no power, check for any open circuit between the wire and the power source. If there is power, use a screwdriver to connect the two terminals of the flasher relay. If the turn signal lights up, it indicates a fault with the flasher relay, which should be replaced promptly. Open the cover of the flasher relay and check if the coil and resistor are intact. The method to replace the turn signal is as follows: Open the engine hood and locate the soft cover behind the headlight assembly. The two covers on the left and right are for the low beam and high beam lights. There is another cover below; remove it and place it in a suitable position to avoid dropping it into the engine compartment. There is a turn signal socket with a handle; unscrew and pull it out, then rotate the bulb to remove and replace it.

2

1

Share

Do I need to pay for a driving test retake?

You need to pay the exam fee again for a driving test retake. 1. The driving school tuition covers the first exam fee. If you fail the first attempt, you will need to pay the retake fee yourself for the second attempt. 2. Fees vary by region, so you can consult the local vehicle management office or driving school for specifics. Additional rules for driving test retakes: 1. Each subject can be taken once, with one retake if you fail. If you don't take the retake or fail it again, the exam ends, and you must reschedule. For Subject 2 and Subject 3, rescheduling must be done at least 10 days later. 2. If you fail the Subject 3 safety and civilized driving knowledge test, the passing score for the road driving skills test remains valid. 3. Within the validity period of the driving skills test permit, you can reschedule Subject 2 and Subject 3 road driving skills tests up to five times. If you fail the fifth attempt, all previously passed subjects will be invalidated.

8

3

Share

What is the suitable tire pressure for highway driving?

Generally, the tire pressure of a car should be maintained at around 220-260Kpa. Before driving on the highway, it is recommended to inflate the tires to around 250 or 260Kpa. If the tire pressure is too low, it can easily cause excessive compression and deformation of the tire cord layer during highway driving. As the speed increases, it may even lead to the phenomenon of standing waves in the tire, and in severe cases, it may cause a tire blowout. Here is more information about tire pressure: 1. Tire pressure refers to the air pressure inside the tire. The level of tire pressure has a crucial impact on the performance and power of the car. 2. Before driving, it is essential to check the condition of the vehicle, especially the tires. If the tire condition is poor, even the best car performance will be useless. If the tire pressure is too low, the tire may be squeezed and deformed during driving, which can also cause a sharp rise in tire temperature, making it more prone to a blowout.

7

2

Share

Is the Hongqi HS5's Eco Mode Fuel-Efficient?

What does the teapot symbol on the dashboard mean?

How to Remove Paint from Car Body?

Can Cars Use Aviation Kerosene?

Which one is the turn signal fuse for the Sylphy?

Do I need to pay for a driving test retake?

What is the suitable tire pressure for highway driving?

Are Off-Road Vehicles SUVs?

Is it okay to shift to neutral at a red light with an automatic transmission?

How to Tell When Car Brake Pads Need Replacement

Is an annual inspection required for B2 license?