Is the green button for taking the card for small cars?

3 Answers
DeAddyson
07/30/25 1:18am
Yes, it is the green button. When taking the card, drivers should park their cars properly. Many drivers frequently travel on highways, and those who do can apply for an ETC. ETC is an electronic toll collection system, and there are dedicated ETC lanes at highway entrances. The electronic toll collection system is very convenient; vehicles equipped with this system do not need to stop to take a card when entering highways. Below are the specific benefits of ETC: 1. Time-saving: Vehicles passing through ETC lanes only take 2 to 3 seconds, eliminating the need to queue for payment. In contrast, traditional manual toll lanes take 20 to 120 seconds for vehicles to enter, wait, and complete the payment process under normal traffic conditions. 2. Fuel-saving: Since vehicles using ETC can pass without stopping, the frequency of starting and braking is reduced, lowering fuel consumption and vehicle wear. 3. Cost-saving: Using ETC can provide a 5% discount on toll fees in many places. 4. Environmentally friendly: With ETC, fuel consumption is reduced, and vehicle wear is minimized, naturally decreasing exhaust emissions and environmental pollution.
Was this review help?
16
2
Share
Rita
08/15/25 6:54am
I've been driving for many years and often take cards at parking lots or toll booths. Generally, the green button is designed for taking cards, as green usually indicates start or confirm operations on common devices. However, not every machine is the same; in some places, the red button is the card-taking button, or no button is used at all, relying on automatic card dispensing. For safety, when parking, stay about 30 centimeters close to the machine but not too close to avoid scratching the car; shift the engine to neutral, pull the handbrake, and then reach out to operate. Once, I hastily pressed the green button, but the machine didn't respond—it turned out the light wasn't on, and I had to wait for manual assistance. Nowadays, electronic payments like the ETC system are much more convenient, avoiding the hassle of taking cards. In short, before taking a card each time, I make it a habit to check the machine's indicator lights or screen prompts first to ensure no misoperation delays time or causes accidents. Driving safety is always the top priority.
Was this review help?
1
5
Share
Expand All
LeLincoln
10/20/25 6:18am
As a young driver who recently got my license, I was quite nervous the first time I had to take a card on the highway. Back then, I pressed the green button when I saw it, and the card came out smoothly. Later, I noticed many places use this green button design for card dispensing. However, experience has taught me this isn't always the case; once in a mall parking garage, the green button was for emergency assistance, and I had to press another button to get the card. When operating, it's essential to park at the right distance and reach out steadily, otherwise the machine might not detect your hand and delay dispensing the card. Usually, I slow down, read the instructions carefully before pressing any button to avoid panic and pressing the wrong one. New drivers are advised to install a navigation app that reminds you of entrance operation details. Also, don't rush to accelerate after taking the card—first, make sure the barrier is fully raised to prevent scratches.
Was this review help?
1
2
Share
Expand All
More Forum Discussions

Which is On and Which is Off?

"ON" means on, and "OFF" means off. Here is some related information: 1. ON and OFF are very common buttons, not only in cars but also in many everyday electrical appliances. You will see ON and OFF on the car light lever. 2. The "SEL" button is the menu selection confirmation button, usually found on the multifunction steering wheel. The "OK" button has exactly the same function as the "SEL" button, but some cars use "SEL" while others use "OK". 3. The "A/C" button is the compressor switch, the full name is Air-Condition, which is the air conditioning cooling switch, because car air conditioning heating does not require the compressor. 4. "VOL+/-" are the buttons for adjusting the volume up and down. VOL is the abbreviation of the word "volume", translated as volume, and can adjust the volume of the car audio.
19
0
Share

Why Can't the Car Door Window Roll Up?

There are several reasons why a car door window may not roll up: 1. The window lift function is disabled. Most cars are equipped with a feature to disable independent control of the passenger side and rear door windows. When this function is activated, the window lift switches on the doors will not work. 2. Obstruction in the window guide channel. Foreign objects in the guide channel, aging rubber seals, or excessive dust accumulation can trigger the anti-pinch protection, preventing the window from rolling up. 3. Overheated window lift motor. Frequent window operation can cause the lift motor to overheat, activating its thermal protection mode. 4. Faulty control switch. In older vehicles with extensive use, the window control switch may fail due to repeated operations.
13
3
Share

What is the function of car spark plugs?

Car spark plugs introduce high-voltage electricity into the combustion chamber and cause it to jump across the electrode gap to generate sparks, thereby igniting the combustible mixture in the cylinder. Spark plugs mainly consist of a terminal nut, insulator, terminal stud, center electrode, side electrode, and metal shell. Spark plugs are installed on the side or top of the engine. Early spark plugs were connected to the distributor via ignition cables, but over the past decade, most car engines have adopted direct connections between ignition coils and spark plugs. Working principle of spark plugs: The ground electrode of a spark plug connects to the metal shell, which is threaded into the engine block via the cylinder head. The insulator primarily serves to isolate the metal shell from the center electrode. The terminal nut is the part that contacts the high-voltage coil. When current passes through the terminal nut and center electrode, it breaks down the medium between the center electrode and ground electrode to produce sparks, thus igniting the air-fuel mixture in the cylinder.
20
1
Share

Can Gasoline Cars Use Methanol?

Typically, gasoline cars cannot use methanol. Only dedicated methanol-fueled vehicles can use methanol as fuel. The disadvantages of directly using methanol in ordinary gasoline cars are as follows: 1. Methanol is corrosive. During combustion, methanol produces formic acid and formaldehyde, which can corrode the metal and rubber components of the engine system. These materials are typical in gasoline-fueled vehicles. Minor issues may include difficulty starting the car or fuel leaks, while severe cases can lead to the complete scrapping of the vehicle. 2. Methanol fuel is toxic. Methanol can irritate the conjunctiva of the eyes and enter the human body through the respiratory tract, digestive tract, and skin, stimulating the nerves and causing symptoms such as dizziness, headaches, nausea, vision impairment, and metabolic acidosis. Methanol is not easily excreted from the body and can accumulate. Ingesting more than 4 grams can lead to poisoning reactions, and severe cases can result in death.
12
0
Share

How many days do I have to wait for the make-up test of Subject 2?

Subject 2 make-up test interval is 10 working days. More information about Subject 2 is as follows: 1. If you fail the first test of Subject 2, you can take a make-up test on the spot. If you do not take the make-up test or fail the make-up test, the test will be terminated, and the applicant should make a new appointment for the test after ten days. Within the validity period of the driving skill test permit, the number of test appointments for Subject 2 and Subject 3 road driving skill tests shall not exceed five times. If the fifth test appointment is still failed, the results of other subjects that have passed the test will be invalidated. 2. Subject 2, also known as the small road test, is part of the motor vehicle driver's license assessment and is the abbreviation for the field driving skill test subject.
2
1
Share

Does Vehicle Transfer Require Driving the Car Back to the Local DMV?

Vehicle transfer requires driving the car to the local DMV. For out-of-town transfers, it is not necessary to drive the car there. The process for out-of-town transfer without the vehicle is as follows: First, apply for an out-of-town inspection authorization to the other party's DMV for vehicle inspection. After the other party's DMV inspects and approves the vehicle, they will send the materials back to the vehicle's registered DMV for verification. Pay the used car transaction tax, obtain a temporary license plate, register the mailing address, and then seal the file and mail it back to the other party's DMV. Once the file arrives at the other party's DMV, proceed directly with the filing and registration procedures. Below is relevant information about vehicle transfer: Vehicle Transfer Notes: When transferring, the new owner's identity proof must be provided, and the vehicle must be present. Before both parties exchange all files and verify them, if the original insurance is still valid, an insurance change must be made. If the original insurance has expired, remember to purchase temporary insurance. Vehicle Transfer Process: The DMV verifies the file, the vehicle inspection point collects images and inspects the vehicle, the DMV accepts the application, returns the original license plate, and collects fees. The DMV then issues a temporary license plate and the vehicle's file. Documents Required for Vehicle Transfer: Original "Motor Vehicle Change Registration/Record Application Form"; Original and copy of the vehicle owner's identity proof; Original vehicle registration certificate; Original vehicle license; Vehicle license plate; Vehicle Identification Number (VIN) rubbing; Original "Motor Vehicle Inspection Record Form"; If an agent applies for vehicle registration and related business, the agent must submit the original and copy of their identity proof (if the agent is a company, the original and copy of the handler's identity proof must also be submitted), as well as the original written authorization from the vehicle owner.
11
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.