Is the GLC compliant with China VI emission standards?

1 Answers
VanMia
07/30/25 10:04am
The Mercedes-Benz GLC complies with China VI emission standards. China VI refers to the national sixth-stage emission standards for motor vehicle pollutants, which are established to prevent environmental pollution caused by exhaust emissions from compression-ignition and gas-fueled spark-ignition engine vehicles, protect the ecological environment, and safeguard human health. Below is a brief introduction to the Mercedes-Benz GLC: Vehicle Exterior: Taking the 2021 Mercedes-Benz GLC as an example, it belongs to the mid-size SUV category, with body dimensions of: length 4764mm, width 1898mm, height 1642mm, and a wheelbase of 2973mm. Vehicle Performance: The 2021 Mercedes-Benz GLC is equipped with a 2.0T turbocharged engine, delivering a maximum horsepower of 197PS, a maximum power of 145kW, and a maximum torque of 320Nm, paired with a 9-speed automatic transmission.
Was this review help?
18
3
Share
More Forum Discussions

Where to Add Windshield Washer Fluid for Emgrand GL?

The windshield washer fluid reservoir for the Geely Emgrand GL is located on the left side of the engine, with a blue plastic cap that features a snap-on mechanism. Before opening the snap-on cap, clean any dust on it. After opening the cap, fill it with diluted windshield washer fluid until the fluid level is between the MIN and MAX marks. Notes for adding windshield washer fluid are as follows: 1. Due to the relatively dry climate in autumn and winter, there tends to be more dust in the air. Before driving in these seasons, use a damp cloth to wipe dust off the windshield. If dust accumulates again while driving, use the car's windshield washer fluid and wipers. 2. Consistently use the same brand of windshield washer fluid to ensure the physical properties of the added fluid remain consistent. 3. In winter, consider using antifreeze windshield washer fluid. If the local temperature drops below 0°C, choose a higher-grade antifreeze fluid. Be careful not to overfill the reservoir, as the fluid may expand when heated and damage the container.
7
2
Share

How to Determine if a Wheel Hub is Out of Round?

Methods to determine if a wheel hub is out of round: 1. The direct impact and sensation of an out-of-round wheel hub on driving experience is that the vehicle's direction will deviate, and the body as well as the steering wheel will vibrate severely, with the vibration increasing as the speed rises; 2. An out-of-round wheel hub can also cause significant impact on the chassis suspension, and in severe cases, it may lead to deformation or even fracture of the suspension control arms. Currently, most car wheel hubs are made of aluminum alloy, making it extremely difficult to repair once they become out of round. Even after repair, the wheel hub cannot return to its original factory condition. Therefore, it is recommended to seek specialized wheel hub repair. However, from a safety perspective, it is generally advised to replace the wheel hub directly if it becomes out of round.
16
0
Share

How to Adjust the Air-Fuel Mixture on a Vacuum Carburetor?

Vacuum carburetor air-fuel mixture adjustment method: 1. First check the tightness of all carburetor-related connections to ensure normal carburetor intake without air leaks or intake obstruction. 2. Turn the carburetor mixture screw clockwise all the way in, then turn it counterclockwise 2 turns. 3. Start the engine and let it warm up for 10 minutes until it reaches normal operating temperature. 4. Adjust the carburetor idle speed screw to achieve the lowest possible engine speed without stalling. 5. Repeatedly adjust the carburetor mixture screw left and right to reach maximum engine speed. 6. Repeat steps 4 and 5 until the engine idles smoothly. 7. Quickly twist the throttle handle to accelerate sharply, then release the throttle. Observe whether the engine accelerates and decelerates smoothly during this process. If smooth, the adjustment is successful; if not, repeat steps 4 through 6 until the engine acceleration and deceleration become smooth.
9
4
Share

What type of battery does BYD use in its vehicles?

BYD vehicles utilize BYD's lithium iron phosphate (LiFePO4) battery. The total voltage is 500V with an energy capacity of 13 kWh. Each lithium iron phosphate battery cell has a voltage of 3.2V, and the battery system adopts a parallel connection method with a single cell capacity of 26Ah. Below are some additional details about BYD: 1. Equipped with Starlight LED headlights, flowing rear turn signals, and 16-inch Photon Star aluminum alloy wheels. 2. The powertrain system: the fuel version is equipped with a 1.5L+CVT power combination, with the engine delivering a maximum power of 80kW (109Ps) at 5800rpm and a maximum torque of 148Nm at 4800rpm. 4. The EV model is equipped with a motor that delivers a maximum power of 100kW (136Ps) and a maximum torque of 180Nm, offering an NEDC range of 421km and a 0-50km/h acceleration time of just 4.5s.
10
4
Share

How to Replace the Remote Control Battery for Trumpchi GS4?

The method to replace the remote control battery for Trumpchi GS4 is as follows: 1. Press the button on the back of the remote battery in the direction indicated by the arrow and pull out the mechanical key; 2. After removing the mechanical key, use your fingernail to open the remote key along the gap on the side; 3. Once opened, you can see the battery compartment on the back cover. Follow the instructions to remove and replace the battery. The dimensions of the first-generation Trumpchi GS4 are 4510mm in length, 1852mm in width, 1708mm in height, with a wheelbase of 2650mm; the second-generation model measures 4545mm in length, 1856mm in width, 1700mm in height, with a wheelbase of 2680mm. The second-generation Trumpchi GS4 is powered by a 1.5T high-power engine, paired with a 6-speed automatic transmission, delivering a maximum power of 124kW and a peak torque of 265Nm.
2
0
Share

What is the round button under the seat of the Hongqi HS5 for?

It is used to adjust the lumbar support of the backrest. The following is an introduction to the Hongqi HS5: 1. Product features: The new Hongqi HS5 has numerous highlights, which can be briefly summarized as mH5, where m stands for numerous, H stands for highlights, and the 5th power represents the five major features: core to enjoy nobility, core to enjoy exquisiteness, core to enjoy comfort, core to enjoy intelligence, and core to enjoy safety. 2. Product power: The Hongqi HS5 is equipped with a low-power version of the CA4GC inline four-cylinder turbocharged direct injection engine, with a rated power of 165kW and a maximum torque of 340N·m. This engine is independently developed by FAW Group and adopts ten industry-leading technologies, including high compression ratio Miller cycle combustion technology, 350bar precise fuel injection technology, full MAP intelligent thermal management technology, all-aluminum lightweight engine technology, etc., with a thermal efficiency of 39%.
5
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.