Is the Geely Boyue equipped with a wet or dry dual-clutch transmission?

How to align the timing of Chery Arrizo 5?

Timing alignment refers to adjusting the working angles of the intake camshaft (controls intake valves), exhaust camshaft (controls exhaust valves), and crankshaft (controls piston height in the cylinders). Camshaft alignment method: Open the valve cover, and you'll find a straight slot at the rear of each camshaft. Align both shafts horizontally and insert the special tool. Crankshaft alignment method: There is a hexagonal bolt to the right of the oil filter. Remove it and insert a thick screwdriver. Slowly rotate the crankshaft to locate the fixing hole (the fixing hole is on the crank - feel carefully as there are several holes on the crank, with the fixing hole being deeper while others are balance holes). Once found, the crankshaft should not rotate left or right. Normally, a special tool is used for this procedure.

11

1

Share

What Are the Usage Tips for the LaCrosse?

LaCrosse usage tips are mainly as follows: Acceleration techniques: When climbing a steep slope, using only the D gear, the driver will clearly feel that the car is weak and cannot accelerate. At this time, it is advisable to switch to manual mode. The car will not only run more powerfully but also drive more briskly. If you want to continue accelerating, you can shift gears in the order of 1, 2, and 3. When the tachometer reaches a certain value, immediately shift to a higher gear. This way, you can fully utilize the engine's power to achieve the fastest acceleration effect. Timely use of low gears: The driver needs to choose an appropriate gear from 1, 2, or 3 based on the slope and road conditions, allowing the transmission to remain stable in this gear while driving. Timely release of the accelerator: In congested traffic or areas with many traffic lights, if you release the accelerator and step on the brake only when you are very close to the car in front, the brake pads of an automatic transmission car will wear out severely, and it will also consume more fuel. Passengers will feel unstable and think the driving skills are mediocre. Therefore, to save fuel, reduce maintenance costs, and increase driving comfort, an automatic transmission car should release the accelerator in advance when seeing a red light or congestion ahead. Early upshifting: After the car starts smoothly, first accelerate the car to a certain speed with a larger throttle, then release the accelerator and maintain it for two or three seconds. At this time, the automatic transmission can shift from first gear to second gear. When you feel the upshift, press the accelerator again to continue accelerating.

16

3

Share

What brand is the X-Trail CVT transmission?

The X-Trail CVT transmission is manufactured by JATCO. Comparison between old and new X-Trail CVT transmissions: The older X-Trail model was equipped with a JATCO CVT transmission with the model code CVT8JF016E, featuring a gear ratio range of 7:1 and a maximum torque capacity of 250N.m. The new generation X-Trail is equipped with a CVT transmission that can simulate 8 gears, with the gear ratio range increased from 7:1 to 8.2:1, and a maximum torque capacity of 330N.m. The performance improvement is significant when comparing the old and new models. Advantages of CVT: In addition to excellent smoothness, the CVT transmission also has a manual mode, allowing for simulated gear shifts. For experienced drivers, manual shifting can enhance driving pleasure and improve fuel efficiency.

15

0

Share

Can the odd clutch pressure of Haval H6 be adjusted if it's too low?

Haval H6 clutch can be adjusted if it's too low. Adjustment method: The clutch of Great Wall Haval H6 is a hydraulic clutch. When the clutch pedal is depressed, it is mainly controlled by hydraulic pressure, where the hydraulic refers to "brake fluid (brake oil)". The adjustment of the hydraulic clutch also requires the owner to inquire at a professional repair shop or 4S shop. Introduction to car clutch adjustment: If the free travel of the clutch pedal is too large and cannot completely disengage the clutch, it will cause difficulty in shifting gears. During inspection, depress the clutch pedal until resistance is felt. This travel is the free travel of the clutch pedal. The free travel must be within the specified limit range of 6-13mm. If it does not meet the requirements, it should be repaired at a maintenance station. Use a ruler to measure the free clearance of the clutch pedal, which is the B distance, with a standard of 6-13mm. If it does not match, adjust the length of the clutch master cylinder push rod to the standard value and then tighten the push rod lock nut.

5

Share

Does using 92 octane fuel instead of 95 octane affect the Volkswagen Sagitar?

Using 92 octane fuel instead of 95 octane in a Volkswagen Sagitar has the following effects: Impact on fuel anti-knock performance: The fuel octane rating refers to the octane number, where a higher octane number indicates better anti-knock performance. Therefore, 95 octane fuel has better anti-knock performance than 92 octane fuel. The main component of gasoline is 92 octane, which is what most car models use, while higher-end vehicles typically use 95 octane fuel. Impact on spark plugs and cylinders: If a car normally uses 95 octane fuel and is filled with 92 octane fuel, severe problems may occur during combustion, affecting the spark plugs and cylinders to some extent, and may even lead to engine failure. Therefore, different car models require different types of fuel, and it is essential to follow the vehicle's manual for refueling requirements.

18

4

Share

What are the disadvantages of installing a front splitter on a car?

Installing a front splitter can easily cause it to be knocked off or scratched when driving on rough roads. Here are the specific disadvantages of installing a front splitter: 1. Legal restrictions: Changing the body color, modifying the engine, or altering the external structure of the car requires approval from the traffic department to be legal. Depending on the situation, it may also require updating the driver's license for record-keeping. Although the latest "Motor Vehicle Inspection Work Regulations" allow and relax some car modification projects, including installing roof racks, side steps, modifying the grille, and wheels, these projects must not change the vehicle's length and width. Therefore, modifying the front splitter is still illegal. 2. Impact damage: Although adding a front splitter can make the car look more stylish, it is prone to scraping when going over speed bumps or entering underground garages.

16

3

Share

Is the Geely Boyue equipped with a wet or dry dual-clutch transmission?

How to align the timing of Chery Arrizo 5?

What Are the Usage Tips for the LaCrosse?

What brand is the X-Trail CVT transmission?

Can the odd clutch pressure of Haval H6 be adjusted if it's too low?

Does using 92 octane fuel instead of 95 octane affect the Volkswagen Sagitar?

What are the disadvantages of installing a front splitter on a car?

What is the reason why the fuel gauge of Chery A3 keeps lighting up?

What is the pink fluid in a Volkswagen car?

Where is the crankshaft position sensor on the Audi 1.8t?

What is the Mercedes-Benz 211?