···
Log in / Register

Is the Fista's exhaust sound loud?

1Answers
MacMackenzie
07/29/2025, 02:20:30 AM

The Fista's exhaust sound is not loud in normal mode. For this car, its exhaust sound is judged based on the engine's RPM. Generally, the higher the engine RPM, the louder the sound will be. Therefore, the exhaust sound is not loud in normal mode, but it is louder in sport mode. Below is an introduction to the model: The Fista LAFESTA is a new compact sedan under Hyundai, with an official guide price ranging from 119,800 to 154,800 RMB. Positioned as a compact car, it offers three powertrain options (1.4T and 1.6T high/low power) across five trim levels. The Hyundai Fista is equipped with a 1.4T and 1.6T high/low power engine. The 1.4T engine delivers a maximum power of 103kW (140PS) and a peak torque of 240N·m. The 1.6T low-power engine produces a maximum power of 140kW (190PS) and a peak torque of 265N·m, while the 1.6T high-power engine offers a maximum power of 150kW (204PS) with the same peak torque of 265N·m, paired with a 7-speed dual-clutch transmission. The 1.6T high-power version achieves an official 0-100km/h acceleration time of just 7.6 seconds. For suspension, it features a front MacPherson strut independent suspension and a rear multi-link independent suspension.

Was this review help?
116
Share
More Q&A

What are the symptoms of a bad car top mount?

Symptoms of a bad car top mount: 1. Reduced ride comfort - when going over speed bumps or rough roads, you may hear a "bang" sound accompanied by a direct impact felt through the body; 2. Increased tire noise - in severe cases, you can hear a roaring sound from the tires; 3. Vehicle pulls to one side during straight-line driving - even when the steering wheel is held at the same angle, the car cannot maintain a straight path and will automatically drift; 4. A "squeaking" sound when turning the steering wheel while stationary - in severe cases, this can also be felt through the steering wheel, which is caused by the top mount losing elasticity due to aging and being squeezed; 5. Severe damage can affect the service life of the shock absorber.
108
Share

How many cylinders does the Lavida engine have?

The Lavida is equipped with a four-cylinder engine. It comes with a 1.4T turbocharged engine and a 1.5L naturally aspirated engine, with maximum power outputs of 113 horsepower and 150 horsepower, and maximum torques of 145 Nm and 250 Nm, respectively. It is paired with a 6-speed automatic transmission or a 7-speed dual-clutch transmission. The Lavida is a compact sedan launched by SAIC Volkswagen, with body dimensions of 4605mm in length, 1765mm in width, and 1460mm in height, and a wheelbase of 2610mm. The front suspension type is MacPherson independent suspension, the rear suspension type is torsion beam non-independent suspension, the steering assistance type is electric power steering, and the body structure is unibody.
106
Share

What is the normal range for wheel alignment parameters?

The normal range for wheel alignment parameters is: single-wheel camber should not exceed 110 on either side, total camber should be around 0.50; single-wheel toe should be approximately 0.15 on either side, total toe should be around 0.30. The instrument will display green to indicate the normal range. The purposes of adjusting wheel alignment data are: 1. Caster angle: ensures straight-line stability and steering return; 2. Kingpin inclination: ensures steering return stability; 3. Wheel camber: increases tire contact area and offsets adverse effects; 4. Toe: counteracts the negative effects caused by wheel camber. Steps for wheel alignment: 1. Drive the vehicle onto the four-post alignment lift and check tire pressure and vehicle height; 2. After lifting all four wheels, inspect the tires for irregular wear or deformation. If wear meets standards, check for looseness in the steering ball joints and ensure the lengths of the left and right tie rods are consistent; 3. Inspect the upper and lower suspension, stabilizer bar, subframe, and chassis for deformation or looseness; 4. Check the rear axle, transverse assist rod, and rear tie rod for deformation and whether the rubber bushings are loose; 5. If no abnormalities are found, lower the vehicle and shake it several times to confirm the suspension system is in normal condition, then remove the wheel alignment locking pins.
105
Share

What is the standard tire pressure for small cars?

Small car tire pressure is standard between 2.2 and 2.5 bar. Air pressure is the lifeblood of tires, and both too high and too low will shorten the service life of the tire. Low pressure will increase the deformation of the tire body, making the tire side prone to cracks, while generating flexing motion, leading to excessive heat, promoting rubber aging, fatigue of the cord layer, and breakage of the cords. It will also increase the tire's contact area with the ground, accelerating wear on the tire shoulder. Excessive pressure will cause the tire cords to undergo excessive stretching deformation. At the same time, driving with excessively high tire pressure will reduce the tire's own shock absorption effect, thereby increasing the burden on the vehicle's shock absorption system. Over time, this will cause damage to the engine chassis and suspension system. Uneven tire pressure can also easily cause the vehicle to pull to one side during braking, similarly increasing wear on the suspension system.
104
Share

How to resolve the wrench symbol display on Mercedes-Benz smart?

Solution for the wrench symbol display on Mercedes-Benz smart: 1. Turn on the ignition; 2. On the multifunction display of the instrument panel, there is a maintenance indicator, which is the odometer adjustment button. Press this button multiple times consecutively within four seconds, pressing quickly—usually twice—to access the maintenance countdown screen; 3. Within 10 seconds, turn off the ignition. At this time, the screen will still display the countdown numbers and the wrench symbol; 4. Hold down the maintenance indicator on the instrument panel while turning on the ignition, moving the switch from O to 1; 5. Continue holding the button for about 10 seconds until it starts flashing, then wait further. The countdown and wrench symbol will disappear, indicating the maintenance indicator has been reset; 6. Release the button and turn off the ignition. The Mercedes-Benz smart is a product of the collaboration between Germany's Mercedes-Benz and Swiss watch giant Swatch. The 's' in the name represents Swatch, 'm' stands for Mercedes-Benz, and 'art' signifies the artistic nature of their collaboration.
117
Share

How many years can a normal car battery last?

Normal car batteries can last 2 to 4 years. Car batteries are divided into maintenance-free batteries and regular batteries (lead-acid batteries). Currently, most car models use maintenance-free batteries, while many Japanese cars use regular batteries. The electrodes of regular batteries are made of lead and lead oxide, with the electrolyte being a sulfuric acid solution, and their lifespan is generally about 2 years. Therefore, replacing them every two years is reasonable. Maintenance-free batteries are relatively more durable and usually need to be replaced every 3 years. To extend the battery's lifespan, regular maintenance is required, along with good driving habits. When the electrolyte is insufficient, the battery won't hold a charge, so it's necessary to replenish it promptly.
101
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.