Is the Excelle Equipped with a Three-Cylinder Engine?

How to Maintain a Car Generator?

Car generator maintenance methods: 1. Pay attention to the wear of the bearings. If insufficient lubrication is found, a few drops of oil can be added from the oil cup opening, but be careful not to let it seep into the rectifier, as this may affect the electrical transmission efficiency; 2. If the rectifier accumulates dirt, it can be polished with fine sandpaper; 3. If the contact surface of the brush is uneven, it can be leveled with fine sandpaper. If the spring's elasticity is insufficient or the brush is excessively worn, replace them with new parts. If the brush is too short but not damaged, a shim can be inserted into the bracket to ensure tight contact with the rectifier; 4. If the brush bracket insulator is damaged, replace it with a new part; 5. If the generator's pole terminals are loose, they must be tightened immediately. If there is poor insulation, remove and repair it.

4

3

Share

What items are included in the second car maintenance?

The second car maintenance includes the following items: 1. Replace the three filters and engine oil; 2. Check whether the brake fluid, transmission oil, and power steering fluid need replacement; 3. Inspect the brake pads, tires, shock absorbers, and suspension; 4. Check the spark plugs, throttle valve, and fuel supply system; 5. Rotate the front and rear wheels and perform routine checks (lights, battery, etc.). After replacing the engine oil and oil filter during the second maintenance, it is important to reset the vehicle's maintenance reminder to prevent it from lighting up after driving for a while. Check the vehicle's tire pressure and inflate if necessary. The air filter and cabin air filter should not be dirty; clean them with compressed air. Inspect the vehicle's chassis for any scratches from daily driving and check for oil or water leaks, addressing any issues promptly. Check the levels of coolant, brake fluid, and power steering fluid to ensure they are between the high and low marks, and top up if they are below the minimum level.

12

3

Share

What transmission does the Hyundai Elantra have?

Hyundai Elantra is equipped with a 6-speed manual and 6-speed automatic transmission. In terms of power, the currently available Hyundai Elantra is powered by a 1.6L naturally aspirated engine, with a maximum power output of 93.8kW, maximum torque of 156Nm, and maximum horsepower of 128PS. The Hyundai Elantra has body dimensions of 4570mm in length, 1775mm in width, and 1445mm in height. It is a global model from Hyundai that was first launched overseas. The car features a multifunctional steering wheel with abundant buttons, integrating audio controls, cruise control, Bluetooth phone buttons, etc. The arc-shaped design not only adds a sporty touch but also complements the center console design.

5

4

Share

How Many Kilometers to Clean the Fuel Injector and Throttle Body?

3 to 50,000 kilometers to clean the fuel injector and throttle body, throttle body cleaning is not based on mileage, but determined by the local environment. When maintaining the car, remove the intake pipe to check if it is dirty. The fuel injector should be cleaned every 20,000 kilometers, or you can add fuel injector cleaner to the fuel tank for cleaning. There is a specific ratio for how much cleaner to add based on the amount of fuel. The throttle body is a controllable valve that regulates air entering the engine. After entering the intake pipe, the air mixes with gasoline to form a combustible mixture for combustion and power generation. The throttle body connects to the air filter at the top and the engine block at the bottom, known as the throat of the car engine.

19

3

Share

How to Remove the Rear Tail Light of a Car?

Steps to remove the car rear tail light: 1. Open the trunk lid, which can be done using the vehicle's electronic key or the operation switch inside the car to lift the trunk lid; 2. Remove the trunk liner padding; 3. Unscrew the tail light fastening screws; 4. Disconnect the rear tail light wiring; 5. Remove the tail light and detach the lens cover. Disconnect the wires to take off the lens cover. Hold both sides of the lens cover with both hands and gently pull outward to separate the lens cover from the car body, then remove the tail light. The car tail light includes the lamps and bulbs at the rear of the vehicle. One of the functions of the lamps is to gather and emit the light from the bulbs, enhancing the brightness and range of the light emitted by the bulbs.

7

4

Share

What is the maximum speed limit on urban roads without center lines?

When driving a motor vehicle on urban roads without center lines, the maximum speed should not exceed 30 kilometers per hour. The following are relevant introductions: 1. Article 45: For roads without center lines, the speed limit is 30 km/h for urban roads and 40 km/h for highways. For roads with only one motor vehicle lane in the same direction, the speed limit is 50 km/h for urban roads and 70 km/h for highways. 2. Article 46: The maximum driving speed must not exceed 30 km/h, among which tractors, electric vehicles, and wheeled special machinery vehicles must not exceed 15 km/h.

3

0

Share

Is the Excelle Equipped with a Three-Cylinder Engine?

How to Maintain a Car Generator?

What items are included in the second car maintenance?

What transmission does the Hyundai Elantra have?

How Many Kilometers to Clean the Fuel Injector and Throttle Body?

How to Remove the Rear Tail Light of a Car?

What is the maximum speed limit on urban roads without center lines?

What are the octane ratings of 92 and 95 gasoline?

Is Heavy Steering Wheel a Common Issue for the Excelle?

How to Replace the Carbon Brushes of a Car Generator?

What are the reasons for a car making a squeaking noise?