Is the Driver's License Medical Examination Report Nationally Valid?

1 Answers
DiFaith
07/30/25 5:36am
Driver's license medical examination reports are not nationally valid. Below are some relevant details about driver's licenses: Driving requirements: According to the "Regulations on the Application and Use of Motor Vehicle Driver's Licenses," the scope of a C1 driver's license covers small and micro passenger vehicles, light and micro cargo vehicles, as well as light, small, and micro specialized operation vehicles. Small passenger vehicles must have a seating capacity of 9 or fewer people. Based on this standard, a C1 license does not permit driving vehicles with more than 9 seats. Requirements for test vehicles: The vehicle must be a light general cargo vehicle with a length of no less than 5 meters, or a small general passenger vehicle with a length of no less than 4 meters, or a sedan with a length of no less than 4 meters.
Was this review help?
3
2
Share
More Forum Discussions

Can a lithium battery still be used after being stored for three years?

Whether a lithium battery can still be used after being stored for three years mainly depends on whether it has been properly maintained during storage. If well-maintained, it can still be used. The ideal voltage for long-term storage of lithium batteries is 3.6-3.8V, so it is recommended to check at least twice a year and perform two charging maintenance sessions. High-quality lithium batteries may not be damaged even after three years of storage due to self-discharge, while low-quality lithium batteries with high self-discharge rates may get damaged over time. Below are some methods for properly maintaining a car battery: 1. Regularly clean the battery: Pay attention to the battery's condition during daily use. Over time, the battery may accumulate dust, powder, oil stains, etc. To ensure normal operation, promptly clean the battery's panel and the dirt on the positive and negative terminals to extend its lifespan. 2. Avoid prolonged parking: If the vehicle is left unused for a long time, the battery will self-discharge. Therefore, even if the car is not used regularly, it is recommended to start it once a week and take it for a short drive to keep the battery fully charged. 3. Regular inspection: The typical lifespan of a car battery is 3-4 years. For high-end models with more electronic systems, the battery's lifespan may be shorter. Regular inspections of the battery's charge retention can help maintain it in optimal working condition.
6
1
Share

What is the intermittent hissing sound from the car air conditioner?

Car air conditioner intermittent hissing sound is the noise of refrigerant flowing in the radiator. Here is the relevant introduction about car air conditioner refrigerant: 1. Working principle: When the air conditioner is operating in cooling mode, the low-temperature and low-pressure refrigerant gas is compressed by the compressor into high-temperature and high-pressure refrigerant gas. The high-temperature and high-pressure refrigerant gas releases heat in the condenser (generally air-cooled, i.e., the heat dissipation copper pipe of the outdoor unit) and turns into medium-temperature and high-pressure liquid (the heat is carried away by the outdoor circulating air). The medium-temperature and high-pressure liquid then passes through the capillary tube to expand and reduce pressure, becoming low-temperature and low-pressure liquid. The low-temperature and low-pressure liquid refrigerant absorbs heat in the evaporator (indoor unit copper pipe) and evaporates into low-temperature and low-pressure gas (indoor air is cooled by passing through the heat exchanger surface). 2. Refrigerant charging method: Under normal temperature and pressure, R410A is a chlorine-free fluorinated alkane non-azeotropic mixed refrigerant, appearing as colorless gas stored in steel cylinders. Based on the characteristics of R410a, an application practice was conducted to replace HCFC22 with R410a in a room air conditioning system, including theoretical analysis and system matching. Experimental results show that under the same conditions, compared with HCFC22, the heat transfer coefficient increases, flow resistance decreases, and after system optimization matching design, the performance (COP) is significantly improved, reaching the European market Class A energy efficiency level.
13
1
Share

How to Deal with a Heavy Truck Speeding Less Than 10%?

A heavy truck speeding less than 10% will result in a warning reminder for the driver. Below are the relevant regulations on driving speed: 1. Driving at night or in adverse weather conditions: The speed must not exceed the maximum speed indicated by the speed limit signs. On roads without speed limit signs, a safe speed should be maintained. When driving at night, on dangerous road sections, or under weather conditions such as sandstorms, hail, rain, snow, fog, or icy roads, the driving speed should be reduced. 2. Driving on roads with more than two motor vehicle lanes in the same direction: The left lane is the fast lane, and the right lane is the slow lane. Motor vehicles driving in the fast lane should adhere to the speed limit specified for that lane. If the speed does not meet the fast lane requirement, the vehicle should move to the slow lane. Motorcycles should drive in the far-right lane. If there are traffic signs indicating the speed, drivers should follow the specified speed. Vehicles in the slow lane may use the fast lane to overtake the vehicle in front. 3. Motor vehicles driving on roads: The speed must not exceed the limits indicated by speed limit signs or markings. On roads without speed limit signs or markings, motor vehicles must not exceed the following maximum speeds: (a) On roads without a central dividing line, the speed limit is 30 km/h in urban areas and 40 km/h on highways; (b) On roads with only one motor vehicle lane in the same direction, the speed limit is 50 km/h in urban areas and 70 km/h on highways.
2
4
Share

What is the process of Chongqing Subject 3 driving test?

Subject 3 test process is as follows: 1. Pre-start vehicle inspection: In-vehicle test preparation (adjusting seats, mirrors, etc.). In these two steps, it is important not to forget to wear the seat belt. The seat belt buckle has two interfaces; find the one with wires. Quickly adjust your mindset during these steps. 2. Starting: Once you are ready, the examiner will start the test software, and you need to follow the voice commands. When starting, turning on the signal light and honking are essential, and you must also check the rearview mirrors. The clutch feel may vary between cars, so you can use the throttle to start and slowly release the clutch once the car moves. 3. Road driving: Road driving includes shifting gears, driving straight, turning, making U-turns, changing lanes, etc. These tasks are relatively simple, but you need to operate according to actual road conditions. Stopping midway is also allowed. 4. Overtaking: Usually, the computer prompts overtaking, and often there are no cars ahead. The main focus is executing the overtaking steps. 5. Intersections, schools, bus stops, etc.: This task mainly involves slowing down before reaching an intersection and checking for oncoming traffic or traffic lights from both sides. Drive according to the actual situation. Note that you cannot stop while passing through an intersection. 6. Night driving: In some places, this is simulated before departure, while in others, it is an actual test conducted at night. The main task is to repeat the above items at night and include light operations. 7. Pulling over: Once all tasks are completed, the examiner will instruct you to pull over.
14
1
Share

Where is the Audi Menu Button Located?

Audi menu button is located on the control panel of the instrument cluster, marked with "CAR", which serves as Audi's menu button. Introduction to the CAR button: The Audi CAR button provides access to the vehicle system settings interface, featuring functions including seat and air conditioning adjustments, checking oil level, viewing maintenance mileage, electronic stability control system, driving mode selection, parking assist settings, and other services related to vehicle components and driving. Audi MMI System: Through the MMI system, drivers can control every electronic device and functional component in the vehicle. From adjusting audio volume to utilizing GPS navigation, Audi's comprehensive range of luxury and comfort features can be perfectly realized via the MMI system.
17
1
Share

What Causes an Automatic Transmission Car to Stall at Idle While Waiting at a Red Light?

Engine auto start-stop function automatically shuts off the engine when the vehicle comes to a temporary stop during driving (such as waiting at a red light). When it's time to move forward again, the system automatically restarts the engine. Below is relevant information: Disadvantages: The initial design purpose of auto start-stop technology was to save fuel. When the auto start-stop function is activated, the engine enters a "dormant" state during brief stops, the pulley stops rotating, and the system minimizes engine idling. Working Principle: The auto start-stop system is an onboard computer-controlled system that automatically starts and stops the engine. This system requires the installation of a starter with auto start-stop capability on the engine.
3
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.