Is the bx5 a joint venture or domestic brand?

How to Drain the Water from the Radiator?

Drain the existing water from the radiator. There is a drain valve at the bottom of the radiator. For some vehicle models, it is also necessary to drain the water from the engine block, where there is a drain plug. There is a drain valve at the bottom of the radiator. After draining the water, tighten it and add antifreeze. Simply open the drain valve at the bottom of the radiator. "Antifreeze" is a chemical solution with a low freezing point, which can drop below -60 degrees Celsius. It will not freeze due to low temperatures and will not damage the engine.

4

2

Share

How to Repair a Flood-Damaged Car?

Remove the seats and the entire floor carpet. Generally, there is a thick layer of sponge beneath the carpet. Use a vacuum cleaner to suck out the water until no more can be extracted, then place the car in a paint baking room to dry. It is recommended to use the tube heating method and avoid using fuel-fired heating. Adjust the temperature to 55 degrees Celsius, as this temperature will not damage the interior or leather. After drying, do not rush to reassemble. Use a fan to blow for several hours to remove any odors. Assemble carefully and professionally, and there will be basically no harm to the car.

10

3

Share

Can You Drive on the Highway with a Spare Tire?

You can drive on the highway with a spare tire, but non-full-size spare tires should not exceed 80 km/h. Below are the classifications for using different types of spare tires: 1. Full-size spare tires have no restrictions on mileage or speed and can replace any temporarily or permanently unusable tire, as they are the same size as the original tires. 2. Non-full-size spare tires can only be used on non-drive wheels and must not exceed a speed of 80 km/h, as their diameter and width are slightly smaller than the other four tires, making them suitable only for temporary use. 3. Run-flat tires (commonly known as "puncture-proof tires") do not lose air or lose air very slowly when punctured, maintaining their shape and keeping the tire bead fixed to the rim, allowing the car to drive stably for a long or short distance to a repair station.

20

2

Share

What is the function of the Jetta intake sensor?

The function of the Jetta intake temperature sensor: It detects the intake air temperature and provides the data to the ECU as a basis for calculating air density. Below is an introduction to the intake sensor: 1. Modern cars can classify sensors based on their functions, such as measuring temperature, pressure, flow, position, gas concentration, and speed. 2. The intake temperature sensor is a negative temperature coefficient thermistor. When the temperature rises, the resistance decreases; when the temperature drops, the resistance increases. The change in resistance in the circuit leads to a change in voltage, thereby generating different voltage signals to complete the automatic operation of the control system. 3. When the engine is cold, the signal from the intake temperature sensor is basically the same as that from the engine coolant temperature sensor. When the engine is warm, its signal voltage is approximately 2~3 times that of the coolant temperature sensor.

2

0

Share

How to Use Exhaust Brake and Where is the Switch?

The exhaust brake switch for heavy trucks is usually integrated with the wiper control; light trucks do not have this equipment. Methods for using the exhaust brake: 1. Integrated with the wiper switch, lift this switch, release the clutch pedal and accelerator pedal, and ensure the transmission is in a gear other than neutral for the exhaust brake to take effect. 2. To deactivate the exhaust brake, simply press the exhaust brake switch again. 3. The exhaust brake is typically activated via a manual switch. To prevent engine stalling when stopping and exhaust brake engagement during fuel injection, the exhaust brake automatically deactivates when the accelerator or clutch pedal is pressed. 4. Since fuel supply is cut off during operation, the exhaust brake cannot be used in gasoline vehicles. Proper use of the exhaust brake can significantly reduce the reliance on service brakes (foot brakes), thereby minimizing wear on brake pads (or discs) and greatly lowering the risk of driving safety hazards caused by overheating from continuous braking.

17

0

Share

What kind of engine oil should be used for the Avancier 370?

The Avancier 370 is recommended to use fully synthetic engine oil. Detailed information about the Avancier 370 is as follows: 1. The Avancier is a mid-size SUV launched by GAC Honda. Compared to models equipped with naturally aspirated engines, turbocharged engines require higher-performance engine oil to protect the engine. 2. In terms of power, this car has two models: the 240 model and the 370 model. The 240 model is equipped with a 1.5T turbocharged engine, while the 370 model is equipped with a 2.0T turbocharged engine. Since this car uses a turbocharged engine, it is recommended to use fully synthetic engine oil to protect the engine and extend the maintenance cycle. 3. There are three types of engine oil used in cars: mineral oil, semi-synthetic oil, and fully synthetic oil. Compared to mineral oil and semi-synthetic oil, fully synthetic oil performs better and has a longer usage cycle. In cold start conditions, using fully synthetic oil makes the engine run more smoothly, saves fuel, and improves the engine's fuel economy.

3

5

Share

Is the bx5 a joint venture or domestic brand?

How to Drain the Water from the Radiator?

How to Repair a Flood-Damaged Car?

Can You Drive on the Highway with a Spare Tire?

What is the function of the Jetta intake sensor?

How to Use Exhaust Brake and Where is the Switch?

What kind of engine oil should be used for the Avancier 370?

How to Turn Off the Continuously Flashing Hazard Lights?

What is the refund process for Shouqi Limousine & Chauffeur?

How to Install Dual Throttle Cables?

How to Install a Water Plug?