Is the Area Near the Cargo Box a Blind Spot?

1 Answers
LaKai
07/29/25 5:49pm
The rear of a large truck is a blind spot for vehicles, but the blind spots of large trucks are not limited to the rear section. Below are some relevant introductions about the blind spots of large trucks: 1. Semi-blind zone: The driver's seat of a large truck is relatively high, making it difficult to see the area below the front of the truck, which constitutes a semi-blind zone. When the traffic light turns green, pedestrians have very little time to react. If the truck suddenly starts moving, the consequences can be very serious. 2. Right-side blind zone: In fact, the most dangerous blind spot is on the right side of a large truck. For example, when a car and a truck are moving side by side with a distance of about 1.5 meters between them, the car is within the truck's blind spot. If the truck changes lanes to the right at this moment, it can be extremely dangerous.
Was this review help?
8
5
Share
More Forum Discussions

What to Do When a Diesel Vehicle Emits Black Smoke?

Solutions for diesel vehicles emitting black smoke include replacing the air filter, replacing the solenoid valve, replacing the fuel filter, cleaning the fuel system, and replacing damaged components. Specific details are as follows: Replace the air filter: When excessive dust and particles in the air cause the filter element to accumulate too much dirt and debris, it can lead to insufficient air supply, resulting in black smoke emission. In this case, the air filter needs to be replaced. Replace the solenoid valve (including the turbocharger's solenoid valve): Poor diesel quality can cause clogging or wear of the fuel injector, leading to inaccurate fuel supply. In such cases, the solenoid valve needs to be replaced. Replace the fuel filter: If the fuel filter does not meet standards, is used beyond its recommended lifespan, or is damaged due to quality issues, particles and moisture can enter the engine along with the diesel, damaging the fuel system—especially the common rail system. This prevents the establishment of high pressure and results in insufficient fuel atomization, causing black smoke emission. In such cases, the fuel filter needs to be replaced. Clean the fuel system: Carbon deposits can obstruct the fuel system, leading to poor fuel supply and subsequent black smoke emission. Replace damaged components: Prolonged driving can cause component wear, affecting fuel and air supply. In such cases, the damaged components need to be replaced.
12
5
Share

Does the Audi S4 have engine sound?

The Audi S4 does have engine sound, and it is quite captivating. The Audi S4 is the direct successor to the S2 model, a four-wheel-drive coupe-style sports car with exceptional power and explosive performance. Currently, the Audi S4 sold in China is imported, available in two versions: the 2018 and 2019 models.  The Audi S4 does have engine sound, and it is quite captivating.   The Audi S4 is the direct successor to the S2 model, a four-wheel-drive coupe-style sports car with exceptional power and explosive performance.   Currently, the Audi S4 sold in China is imported, available in two versions: the 2018 and 2019 models. Below is a detailed description of the 2019 Audi S4.   The 2019 Audi S4 was launched in July 2019, with prices ranging from 449,800 to 450,800 RMB, complying with the China National V emission standard.   1. Exterior:   The 2019 Audi S4 measures 4749mm in length, 1842mm in width, and 1400mm in height, with a wheelbase of 2831mm.   The front face features Audi's family-style design, with a hexagonal front grille, eagle-eye-style headlights, and extensive chrome trim in the grille area. The overall lines are bold and aggressive, with high recognizability.   2. Features:   Standard features include body stability control, anti-lock braking, side airbags, tire pressure monitoring, cruise control, lane keeping, blind-spot monitoring, hill start assist, auto hold, and rearview camera.   3. Performance:   The 2019 Audi S4 is equipped with a 3.0T engine, delivering a maximum output of 260 kW and a peak torque of 500 N·m. It is paired with an 8-speed automatic transmission, achieving a 0-100 km/h acceleration time of 4.8 seconds.
11
5
Share

Will the car battery die if not used for a month?

Leaving a car unused for a month will not cause the battery to die, but it is best to disconnect the positive and negative terminals to avoid natural power drain. Poor vehicle condition: For cars in poor condition, the battery may lose power in about a week. However, there is no need to worry too much. Simply driving normally for one to two hours can restore the battery to its normal charge level. If the situation is severe enough that the engine cannot be started, a jump start may be required to activate it. For vehicles parked for extended periods, it is advisable to start and drive them at least once a week if possible. Recommendations: If you are usually busy with work, consider driving the vehicle on weekends for a few dozen kilometers. This can help recharge the battery, evenly distribute tire pressure, and most importantly, allow the engine oil to better adhere to the internal parts of the engine, which is crucial for vehicle maintenance. Keeping the engine running smoothly is also an effective method of self-maintenance for the vehicle.
11
1
Share

How to Repair a Compressor?

For issues with the compressor motor part, poor sealing of the compressor suction and exhaust valves, or thermal protector failure, replacement is the recommended solution. For compressor seizure or cylinder jamming faults, repair can be attempted first. The specific methods are as follows: Knocking Method: After turning on the compressor, use a wooden hammer to tap the lower half of the compressor to vibrate the stuck internal components and get them moving. Capacitor Start Method: Connect a capacitor with a larger capacitance than the original one to the circuit for starting. High Voltage Start Method: Use a voltage regulator to increase the power supply voltage before starting. Pressure Relief Method: Release all the refrigerant from the system before starting.
11
1
Share

Where is the Mercedes-Benz wiper switch located?

The wiper switch of Mercedes-Benz cars is located on the left side of the steering wheel, combined with the light control on a single lever. Mercedes-Benz wipers' automatic intermittent working gear can adjust the swing frequency, making the wiper's swing frequency change according to the vehicle speed. When the wiper lever is set to the automatic intermittent swing gear, the wiper will change its swing frequency based on the adjusted frequency and vehicle speed. Wipers are also known as windshield wipers, water wipers, or windscreen wipers. They are devices used to remove raindrops and dust attached to the vehicle's windshield, improving the driver's visibility and enhancing driving safety. Precautions for using wipers: Pay attention to whether the swing amplitude of the upper and lower wipers is consistent. If not synchronized, correct it in time; If the wiper makes a heavy "quacking" sound during operation, there may be an issue with the wiper's adjustment, with excessive downward pressure; After the wiper wipes several times, if some moisture remains on the windshield, it indicates that the rubber strip is aged and needs replacement; Never operate the wiper dry, as it not only damages the wiper itself but can also cause significant harm to the glass if there are foreign objects like sand; Regularly lubricate the wiper. Frequently add lubricant at the wiper arm joints to reduce mechanical friction; Remove debris promptly. After parking for a long time, there may be many dead branches and leaves on the car glass. Do not use the wiper to scrape debris directly. Be careful not to forcibly peel or pour hot water, as this can cause problems such as wiper blade tearing or windshield cracking. It is recommended to start the vehicle, turn on the heater, and blow warm air toward the front windshield to melt the frozen wiper with the air conditioning's hot air. Additionally, when choosing windshield washer fluid in winter, pay special attention to selecting antifreeze washer fluid. Judge based on the local winter temperature. If you are in a northern region, you can choose a special antifreeze type washer fluid to ensure it does not freeze even at -40 degrees Celsius.
19
1
Share

Why is the reversing camera not displaying on the Mercedes-Benz R320?

System failure reasons: Solutions: The reversing camera will only display when the vehicle's gear is shifted into reverse. If the reversing camera still does not display after shifting into reverse, then there are other reasons. There are many possible causes for system failure issues, and specific conditions should be diagnosed by professionals at a repair shop or 4S store. Vehicle battery is dead: When the vehicle battery is dead, the reversing camera will definitely not display. In this case, simply charging the battery will solve the problem. If the camera is damaged, causing the reversing camera to be unresponsive, this is a hardware issue. In such a situation, a new camera needs to be replaced.
3
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.