Is Lexus the same as Lingzhi?

1 Answers
Amy
07/24/25 9:57pm
Lexus is indeed Lingzhi. Here is a detailed introduction to the Lexus brand: 1. Lingzhi and Lexus belong to the same brand, which is a globally renowned luxury automobile brand under the Toyota Group. 2. Lingzhi was the original name for LEXUS in China, while Lexus is the English pronunciation of LEXUS and the official name used by Toyota. The name 'Lingzhi' was given by the car dealers who represented the brand at the time. In 2001, Toyota officially introduced the Lexus brand into the Chinese market, hence renaming Lexus from 'Lingzhi' to 'Lexus'. 3. Lexus primarily develops high-end models for Toyota, including models such as LX, LFA, LFCC, NX, LC, and LS.
Was this review help?
1
3
Share
More Forum Discussions

Can a Modified Air Suspension Run at 120 km/h?

Modified air suspension can run at 120 km/h. Here are the extended details: Working Principle of Air Suspension: It adjusts the vehicle's height by controlling air pressure, consisting of elastic rubber airbag shock absorbers, an air pressure control system, a trunk-mounted air tank, and an electronic control system. HellaFlush Style: In HellaFlush-modified cars, apart from meticulous attention to wheel J-values, ET values, and camber parameters, another crucial aspect is lowering the vehicle's height. Many opt for coilover suspensions as they not only reduce ride height but also provide ample support for the vehicle. Remote Control: Installing an air suspension typically includes linking a remote control inside the car, allowing preset positions for quick height adjustments. This enables the car to 'slam' when parked and return to normal driving height when in motion.
5
0
Share

Where is the fuse box of the Audi A6L?

The Audi A6L has five fuse boxes. One is located inside the cover above the driver's footwell, on top of the relay; another is located on the right side panel of the trunk; there is one on each side panel of the dashboard; and another one is located below the washer fluid reservoir. Steps to replace a fuse: 1. Turn off the vehicle and all power sources, and remove the mechanical key if applicable; 2. Open the fuse box cover, the inside of the cover clearly shows a reference diagram of the components; 3. Use a light to check if the corresponding fuse is damaged, and replace it if it is blown; 4. Only use a fuse with the same current rating and size for replacement; 5. After replacement, check if the corresponding component is functioning properly. The Audi A6L is a luxury car produced by Audi, with a body size of 5034mm in length, 1874mm in width, 1480mm in height, and a wheelbase of 3012mm.
12
3
Share

Can a Modified Vehicle Be Transferred?

Yes, it can be transferred as long as the vehicle modifications comply with formal procedures. Here is some additional information: Modification Regulations: Article 6: If a registered motor vehicle falls under any of the following circumstances, the owner of the motor vehicle shall apply to the traffic management department of the public security authority where the motor vehicle is registered for modification registration: (1) Changing the body color of the motor vehicle; (2) Replacing the engine; (3) Replacing the body or frame. Vehicle Transfer Steps: The seller's original ID card and a copy, the buyer's original ID card and a copy, the original vehicle purchase invoice or the previous transfer invoice and a copy, the original vehicle registration certificate and a copy, the original vehicle license and a copy are required. The motor vehicle must be present, and the used motor vehicle sales contract must be filled out.
3
4
Share

What Causes the Shock Absorber to Make Noise When Passing Over Potholes at 70 km/h?

70 km/h over potholes shock absorber noise is mainly caused by not slowing down when passing over large potholes or rough road surfaces. Below are some relevant introductions about driving on uneven roads: 1. Driver's posture: When driving on uneven roads, the driver should maintain the correct driving posture, with the upper body close to the seat back and both hands holding the steering wheel, trying not to let the upper body sway or jump. If the body loses stability due to the vehicle's jumping, it will affect uniform acceleration and thus lose control of the vehicle. 2. Method of passing through roads: When passing through short and slightly uneven roads, you can coast in neutral gear. On continuous small uneven road surfaces, maintain an appropriate speed and drive at a constant speed, and try to choose relatively flat ground to pass through slowly.
5
4
Share

What are the reasons for a single-cylinder gasoline engine failing to start?

1. Electrical or electronic failure: This type of failure occurs very suddenly without any warning. Electrical failures include: blown fuse, open circuit in the high-voltage coil, open circuit in the low-voltage circuit, detached central ignition wire, leaking distributor rotor, or damaged spark plug. Electronic failure mainly refers to the malfunction of the central computer control board. 2. Fuel system failure: Symptoms include engine weakness or the accelerator pedal feeling like stepping on cotton. Possible causes include: fuel pump failure, blocked fuel line, clogged fuel filter, carburetor failure, or damaged injector. Sometimes, the fuel tank may be empty without the owner realizing it. If this is the cause, adding a few liters of gasoline can solve the problem. 3. Mechanical failure: Common mechanical failures include: broken timing belt (or chain), cylinder leakage with no pressure, etc. 4. Battery failure: Visually inspect the battery casing. If it appears swollen or deformed, it definitely needs replacement. Besides the battery, other reasons for the starter not working could be a damaged ignition switch, faulty ignition relay, or a defective starter itself. Additionally, check the grounding circuit and fuses.
5
4
Share

What certificates are required to drive a 4.2 refrigerated truck?

Obtain an operating permit and a professional qualification certificate. More details are as follows: Required certificates: The certificates required to drive a refrigerated truck mainly depend on whether it is a blue license plate or a yellow license plate. For a 4.2 refrigerated truck with a total mass of less than 4,500 kilograms, an operating permit and a professional qualification certificate are not required. For trucks over 4.2 meters, these certificates are necessary. According to the "Regulations of the People's Republic of China on Road Transport": To apply for freight transport operations, after completing the relevant registration procedures with the industrial and commercial administrative authorities, applications shall be submitted in accordance with the following provisions, along with the relevant materials that meet the conditions specified in Articles 21 and 23 of these Regulations: For freight transport operations other than hazardous goods transport, apply to the county-level road transport management authority; for hazardous goods transport operations, apply to the municipal road transport management authority of the relevant district.
6
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.