Is It Useful to Press the Brake During Cruise Control?

Should the Handbrake Be Applied When Parking an Automatic Transmission Car for a Long Time?

Automatic transmission cars should have the handbrake applied when parked for a long time. If parked on a flat surface where the vehicle's center of gravity is balanced, applying the handbrake is optional after shifting to P (Park) mode. However, if parked on an incline, failing to apply the handbrake while in P mode will concentrate all the gravitational force on the transmission. Over time, this can adversely affect the transmission. In severe cases, the transmission's engagement might become too tight, making it difficult to disengage from P mode. Therefore, it is essential to apply the handbrake when parking on a slope. Below is an introduction to the gears of an automatic transmission car: 1. L (Low) Gear: This is the low-speed gear that limits speed. Engaging this gear while climbing a hill maintains a state of high RPM and low gear. 2. S (Sport) Mode: This is the sport mode where the transmission can shift freely, but the shifting timing is delayed, keeping the engine at high RPM for an extended period, allowing the car to move at low gear and high RPM for longer durations. 3. D (Drive) Gear: This is the forward gear used when the car is moving forward. 4. N (Neutral) Gear: This is the neutral gear used during brief stops. 5. P (Park) Gear: This is the parking gear used when the car is parked. Placing the gear in P mode stops the car's braking system, preventing it from rolling. 6. R (Reverse) Gear: This is the reverse gear used when backing up. However, R gear should only be engaged when the car is completely stationary. Engaging R gear while the car is moving slowly can cause severe damage to the transmission.

4

Share

What causes the left parking light and daytime running light to fail?

Left parking light and daytime running light failure may be caused by damage to the headlight drive module, which can be addressed by visiting an auto repair shop. The roadside parking light is a parking warning function set by the car. When the car is parked on the roadside, the left parking light keeps flashing. This function is mainly used to remind passing vehicles at night to avoid collisions. Below are the correct ways to use car lights: 1. Poorly lit roads: On roads with no street lighting or poor lighting, high beams can be used. However, when meeting other vehicles or pedestrians, switch to low beams to prevent glare. 2. When needing to read road signs: When unfamiliar with the road and needing to read road signs or other markers, high beams can be used, but should be quickly switched back to low beams. 3. When overtaking another vehicle: The left turn signal should be activated in advance, and high beams and low beams should be alternated or the horn should be sounded to alert the vehicle ahead to yield. 4. When passing through corners, curves, or intersections without traffic signals: Alternate between high and low beams as a reminder. 5. When driving into a tunnel: Turn on high beams, and when meeting another vehicle, switch to low beams in advance. 6. In urban areas with street lighting at night: Low beams must be used. 7. In areas without street lighting at night or during dusk when it is dark or at dawn: Low beams must be turned on when driving. 8. When visibility is obstructed: If encountering heavy fog, snow, or heavy rain that obstructs visibility, low beams must be turned on even during the day.

3

4

Share

Which gear should be used when going downhill?

Downhill, use 3rd gear. Do not coast in neutral, just keep it in 3rd gear. For steep descents, especially when driving a heavy vehicle down a winding mountain road, it is best to use a lower gear. Utilize the engine idle speed to control the vehicle speed along with the brakes, ensuring safety, fuel efficiency, and prolonging brake life. Avoid using exhaust braking as it is harmful to the engine. 1. Downhill driving techniques: Reduce speed before descending to enter the downhill section at a slow pace. Shift into an appropriate gear before descending, usually second or third gear. It is strictly forbidden to shift gears after entering the downhill section. 2. Precautions: Coasting in neutral is strictly prohibited on downhill sections. Always engage an appropriate gear to utilize the engine's braking effect to reduce the vehicle's coasting speed.

11

3

Share

Shift Gear First or Turn Signal First?

First turn on the turn signal, then shift gears, and finally steer. 1. Reason: Turning on the turn signal is to inform others that you are about to start, so please pay attention. At this time, others notice you, giving you time to shift gears, and you can steer shortly after starting. Steering while the car is moving is easier than when it is stationary (rolling requires less effort than pure friction when stationary), which means you use less force and also protect the steering system. 2. Notes: There is no strict order, but generally, it is advisable to turn on the signal before shifting gears. One reason is to avoid forgetting to signal, and the other is that signals should be turned on three seconds in advance, so the three seconds after signaling can be used to shift gears.

8

0

Share

Should the air conditioner blow hot or cold air to defog the car in summer?

If the car fogs up in summer, you should use cold air to defog. Whether it's summer or winter, opening the windows can quickly remove fog from the car. When defogging, it is recommended to turn the air conditioner's fan speed to the maximum, as this provides better defogging effects and faster defogging speed. 1. Defogging methods: The front windshield is defogged using the air conditioner, while the rear windshield is defogged using electric heating wires. When the rear windshield defogger is turned on, the electric heating wires will start working, but they will stop after a while to protect the wires. 2. Precautions: In winter, it is recommended to set the air conditioner temperature to the highest and the fan speed to the maximum for defogging. In summer, it is recommended to set the air conditioner temperature to the lowest and the fan speed to the maximum. To prevent the windshield from fogging up, you can buy anti-fog sprays to apply on the windshield. These sprays can effectively prevent fogging on the glass and rearview mirrors.

9

4

Share

What are the hazards of tire repair fluid to tubeless tires?

Tire repair fluid can temporarily seal air leaks in tires within a short period, but this is merely an emergency repair method. In reality, tire repair fluid poses the following hazards to tubeless tires: 1. Tire repair fluid is composed of chemical ingredients with acidic or alkaline properties, which can react chemically with the rubber inside the tire and the wheel hub, thereby corroding both the rubber and the hub. The quality of tire repair fluids on the market varies, making it easy to purchase inferior products, which increases safety risks for the tires. 2. Being a liquid, tire repair fluid tends to coat the inner tire wall during driving, making it difficult to clean off. It also hinders sanding and bonding, which is detrimental to tire repair and may lead to air leakage. 3. Tire repair fluid is only effective for minor damages and does not work for tire injuries larger than 6mm.

7

4

Share

Is It Useful to Press the Brake During Cruise Control?

Should the Handbrake Be Applied When Parking an Automatic Transmission Car for a Long Time?

What causes the left parking light and daytime running light to fail?

Which gear should be used when going downhill?

Shift Gear First or Turn Signal First?

Should the air conditioner blow hot or cold air to defog the car in summer?

What are the hazards of tire repair fluid to tubeless tires?

What is a Damping Sheet?

What color of fog lights has strong penetration?

Will Uninspected Vehicles Be Detected on Highways?

What is the difference between frameless doors and framed doors?