Is it okay for a car to be left outside in the rain all the time?

1 Answers
Emilio
07/29/25 1:31pm
It is not advisable to leave a car outside in the rain all the time, as prolonged exposure to rain can have certain negative effects on the vehicle. The specific impacts are as follows: 1. Paint damage: If parked in an area with poor environmental conditions, acid rain can easily occur, which can also damage the paint. 2. Circuit short circuits: Rain exposure may cause certain components of the car to corrode, leading to circuit short circuits and potential hazards. Methods to protect your vehicle during rainy days are as follows: 1. Timely cleaning: After driving in heavy rain, the car should be washed promptly to prevent sludge accumulation in the gaps underneath the vehicle. 2. Paint protection: The acidic components in rainwater can severely corrode the car's paint. Over time, this can cause damage to the paint. Therefore, during seasons with frequent rain, it is best to give your car a paint restoration treatment. 3. Undercarriage care: The undercarriage is the part closest to the ground and is particularly affected by road conditions. This area is most prone to rust and corrosion, and the wheel wells may even loosen or develop holes. Therefore, it is essential to perform undercarriage cleaning and rust-proofing treatments, which can last for about three months. 4. Ignition start: On rainy days, car owners often encounter difficulties starting the engine. Sometimes, even if the engine starts, it may run weakly. The most likely cause of this issue is moisture-induced leakage in the ignition system.
Was this review help?
4
1
Share
More Forum Discussions

Can the vehicle pass the annual inspection with different tire specifications?

Tires with different specifications cannot pass the annual inspection. According to the "Motor Vehicle Safety Technical Inspection Items and Methods," the requirements for tires during the annual inspection are as follows: both sides of the same axle must be equipped with tires of the same model, specification, and tread pattern, and the tire bolts and axle bolts must be complete and tightened. Materials required for the vehicle annual inspection: 1. Original copy of the motor vehicle license plate application form. 2. Proof of compulsory traffic accident liability insurance for motor vehicles. 3. Copy of the tax payment or tax exemption certificate for vehicle and vessel tax. 4. Original copy of the motor vehicle safety technical inspection certificate. 5. Original copy of the motor vehicle driving license. 6. If it is an entrusted issuance of the motor vehicle inspection qualification mark, the original copy of the notice of entrusted issuance of the inspection qualification mark must also be provided. 7. For proxy registration, the agent's identity certificate and the original copy of the legally effective written power of attorney issued by the motor vehicle owner must be provided.
14
0
Share

Is the Volkswagen Sagitar a mid-size car?

The Sagitar does not belong to the mid-size car category. From the model's positioning, it can be seen that the Volkswagen Sagitar is actually a compact sedan, also known as an A-segment car. However, when placed alongside traditional compact sedans, the Sagitar's body length is noticeably longer, so it is generally referred to as an "A+" segment car—larger than an A-segment car but not meeting the standards of a B-segment car. A-segment cars: A-segment cars are called compact sedans, with a wheelbase ranging approximately from 2.3 to 2.45 meters and engine displacements around 1.3 to 1.6 liters. Main models include the Volkswagen Jetta, Golf, Sagitar, Ford Focus, Honda Civic, etc. B-segment cars: B-segment cars are referred to as mid-size sedans, with a wheelbase ranging from about 2.45 to 2.6 meters and engine displacements from 1.6 to 2.4 liters. Main models include the Volkswagen Santana, Passat, Magotan, Audi A4, BMW 3 Series, Honda Accord, Toyota Camry, etc.
19
5
Share

How to Replace the Key Battery for Mercedes-Benz GLA?

On the side of the Mercedes-Benz GLA remote, there is a PUSH button. Press this push metal head, and the mechanical key will come out. After it comes out, a small groove and a slit will be exposed on the top. Pry it open with force, and the key will split into two halves as you apply pressure. The side with the circuit board is where the battery is located. Flip it over, remove the old battery, and place a CR1632 battery in the metal frame. Then, put the circuit board back in place and close the two halves together. 1. Method for opening the car remote key to replace the battery: There is a circle on the back of the remote key with a groove in the middle. Use a coin to press into the groove and twist open the cover to see the button battery. The groove is on the edge between the front and back of the remote key. Use an appropriate tool according to the size of the groove to twist it open. Buy a new battery with the same number as the original one for replacement. 2. Working principle: First, the key emits a weak radio wave, which is received by the car antenna. The electronic control unit identifies the signal code, and then the actuator of the system performs the action of locking/unlocking.
18
5
Share

Can I directly obtain an automatic transmission driver's license?

You can directly obtain an automatic transmission driver's license, which is the C2 driver's license. The C2 driver's license only permits driving automatic transmission passenger cars and does not allow driving manual transmission vehicles. Automatic transmission vehicles do not have a clutch, making them easier to control and significantly different from manual transmission vehicles. Holders of a C2 license cannot drive manual transmission vehicles, while holders of a C1 license can drive automatic transmission vehicles. Therefore, the C1 license is downward compatible with the C2 license, and the C2 can be considered a subset of the C1. C2 is the automatic transmission driver's license, and C1 is the manual transmission driver's license. Comparatively, the C2 test is simpler and easier to pass because many people struggle with mastering the clutch, often leading to failure in the test. However, the cost of the C2 test is higher. Obtaining an automatic transmission driver's license, like a manual transmission one, requires passing four subjects: the subject on road traffic safety laws, regulations, and related knowledge; the subject on field driving skills; the subject on road driving skills and safe civilized driving knowledge. The content of Subject 2 includes: parallel parking, reversing into a garage, right-angle turns, and curve driving. Starting from May 2021, the slope parking and starting project was removed from Subject 2 for small automatic transmission vehicle tests.
13
5
Share

Do Volkswagen cars need to add a relay when installing a reverse camera?

Volkswagen cars require a relay when installing a reverse camera, while other car models may not need one. The reason for adding a relay: German cars experience voltage and current instability when starting, with significant output voltage interference. The relay is added to protect the equipment. Function of the relay: The relay uses low power to control high current. Installing a relay allows the signal from the rear camera to be switched to the display when shifting into reverse gear, while also powering the camera. Therefore, a relay with multiple contact points is needed. During installation, only one wire from the reverse gear switch is required to control the relay to achieve this switching.
3
1
Share

What to Do When a Sedan Has Insufficient Tire Pressure?

Here are the methods to deal with insufficient tire pressure in a sedan: 1. If the tire pressure warning persists after inflation, it may be because the tire pressure has not been recalibrated. Simply recalibrate the tire pressure on the central control panel. 2. If the tire pressure warning appears some time after inflation but there is no puncture in the tire, it could be due to air leakage caused by a deformed wheel rim. It is recommended to check the wheel rim and replace it if necessary. Below are some precautions for checking tire pressure: 1. Observe the tire condition before setting off. Radial tires—commonly known as low-pressure tires—are fine as long as the aspect ratio is not too low. High-pressure tires—which are bias-ply tires with inner tubes—should not have protruding shoulder areas when viewed from the front, colloquially referred to as 'not bulging.' When viewed from the side, the contact area with the ground should be similar to normal. 2. While driving, pay attention to the sound of the tires rubbing against the ground, the cushioning effect when driving over uneven roads, and whether the acceleration feels different from usual when pressing the accelerator. 3. Under normal circumstances, check and replenish the tire pressure at a professional tire repair shop every week.
15
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.