Is it normal to feel a strong jerk when shifting from P to R in an automatic transmission?

1 Answers
MarcusRose
07/24/25 2:33pm
It is not normal to feel a strong jerk when shifting from P to R in an automatic transmission. Here is some knowledge about gear shift jerking: 1. Introduction: Gear shift jerking refers to the feeling of the car moving forward in a jerky or stuttering manner when shifting gears, usually occurring during starting, accelerating, or decelerating. 2. Cause: When shifting gears and releasing the clutch, if the engine speed does not match the current vehicle speed—meaning there is a speed difference between the engine speed and the clutch disc speed (in most cases, the engine speed is lower than the clutch disc speed)—then jerking will occur.
Was this review help?
20
3
Share
More Forum Discussions

What Causes an Automatic Transmission Car to Suddenly Stop Moving?

An automatic transmission car may suddenly stop moving due to the following reasons: 1. The clutch is not fully engaged. 2. The handbrake is not released. 3. The gear is stuck and not fully engaged. 4. The clutch friction plate is worn. Note: To shift gears in an automatic transmission car, simply push the lever to the corresponding gear position. However, a new car requires a break-in period, and more force may be needed when shifting. A manual-automatic transmission does not have as many gear positions as a pure automatic transmission. Apart from the essential P (Park), R (Reverse), and N (Neutral) gears, the forward gear is simply D (Drive), and the functions of other gears can be achieved through manual mode.
19
3
Share

What is the difference between automatic AT and manual-automatic AT?

The difference between automatic AT and manual-automatic AT lies in aspects such as shifting methods and applied technologies. Here are the specific details: 1. Different modes: Manual-automatic transmission offers two selectable modes - manual shifting mode and automatic mode. Drivers can choose either manual mode or automatic mode, whereas automatic transmission lacks a manual mode. 2. Different practical technologies: Manual-automatic transmission is a gear-shifting device that combines manual and automatic transmission functions, allowing drivers to independently select shift timing in manual mode. In contrast, conventional automatic transmission only permits the computer to determine shift timing, without driver intervention in selecting shift moments.
8
1
Share

What is the hand signal for allowing a vehicle to turn left?

The hand signal for allowing a vehicle to turn left is when the traffic police officer points horizontally to the left side of the driver with their left hand. Below are precautions for making a left turn in a car: 1. Wide turning radius: Try to make the left turn as wide as possible. To avoid hazards such as obstruction or collision, aim to turn into a farther point. 2. Check mirrors frequently: Always check the rearview mirrors before turning to ensure there are no vehicles or pedestrians on the side or behind you. 3. Watch for blind spots: Beginners often focus only on what’s ahead or to the left, neglecting blind spots, which may lead to hitting the curb or causing a scrape. Be sure to check for obstacles below the rearview mirror, and if necessary, open the door to take a look before turning. 4. Control the steering wheel: Proper steering wheel control is crucial when turning. For a sharp turn, turn the steering wheel as much as possible and gradually straighten it after completing the turn. For a wide turn, steer slowly.
12
5
Share

What Are the Solutions for Overweight Dump Trucks?

There is no solution for overweight dump trucks because it is caused by the vehicle itself being overweight. Here is some relevant information about dump trucks: 1. Hazards of overloading dump trucks: Since the rear compartment of a dump truck can be automatically unloaded under hydraulic control, overloading the vehicle may cause hydraulic failure and lead to accidental tipping, with unimaginable consequences. 2. Hazards of the dump truck itself being overweight: If a new dump truck is overweight, it will affect the registration process because there is an inspection step before registration. If the vehicle is overweight, it will fail the inspection and cannot be registered.
6
1
Share

What does a car feel like when the timing is off?

Incorrect timing can cause delayed ignition, weak acceleration, engine shaking, insufficient power, etc. It is recommended to go to a 4S shop to adjust the timing belt and restore vehicle performance. The following are specific manifestations of incorrect timing faults: 1. Small timing deviation: In cases of small timing deviation, the car will feel weak, making it difficult to accelerate when going uphill. 2. Larger timing error: In cases of larger timing errors, the fault manifestations include no idle speed or severe engine shaking at idle, a popping sound from the exhaust pipe when accelerating, and occasional engine stalling accompanied by the popping sound. 3. Excessive timing error: If the deviation is too large, the engine may not start at all. In some car models, you may hear a knocking sound inside the engine when cranking, which is the sound of pistons hitting the valves.
13
2
Share

Can a Car Without a Spare Tire Be Driven on the Road?

Can a Car Without a Spare Tire Be Driven on the Road? A car without a spare tire can be driven on the road. Here is more relevant information: 1. Spare tire location: Depending on the vehicle model, the spare tire is generally placed under the trunk floor, hung under the rear of the car, or fixed outside the trunk door. For SUV models, the spare tire is mostly hung under the rear or fixed outside the trunk door. 2. Spare tire mounting method: Many spare tires are secured with screws, meaning there is a large-headed fixing bolt in the center hole that can be removed (counterclockwise) to take out the spare tire. Another method uses zip ties for fixation, where loosening the zip ties will release the spare tire. Reinstallation follows the same method as removal.
16
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.