Is it normal for the VV7 engine to make abnormal noises?

2 Answers
MartinAnn
07/25/25 3:42pm
It is normal for the VV7 engine to make abnormal noises. Since the engine is a direct injection engine, the fuel is injected directly into the cylinder during operation. Additionally, the direct injection engine is equipped with a high-pressure pump, which can produce abnormal noises during operation. This is considered a normal phenomenon. Causes of abnormal engine noises in cars: 1. Aging engine mounts: Engine mounts are rubber blocks placed between the engine and the frame. Their purpose is to reduce vibrations and provide cushioning during engine operation while securing the engine in place. Once these mounts age or become loose, the engine may shake, leading to abnormal noises. 2. Engine misfire: This mainly refers to one or more cylinders not functioning properly. The exhaust gas flow will show noticeable interruptions, and the exhaust pipe may shake significantly. This phenomenon is often related to issues with the ignition coil. 3. Poor lubrication: Due to insufficient lubrication, excessive wear may occur between the piston and cylinder wall, causing the clearance between them to exceed normal tolerances. This results in noticeable knocking sounds during idle or low-speed operation. 4. Overly rich fuel mixture: When the engine's air-fuel mixture is too rich, it may be difficult to start. After starting, acceleration may be sluggish, and the engine may run unevenly. The exhaust pipe may emit black smoke, accompanied by popping or knocking noises. Methods for diagnosing abnormal engine noises: 1. Manual inspection: This mainly involves using a stethoscope, performing a cylinder cut-off test, and adjusting the throttle opening to listen and observe changes in abnormal noises. During the inspection, it is also important to monitor the color and volume of exhaust smoke and the readings of various gauges. 2. Instrument diagnosis: Since different types of engine noises and vibrations have distinct sound levels, pressures, and amplitudes, any wear in engine friction pairs, increased clearance, or loosening of components can produce abnormal noises and vibrations. These can be reflected through specialized diagnostic instruments.
Was this review help?
16
5
Share
StJoshua
08/11/25 9:33pm
I've been driving the VV7 for several years, and encountering abnormal engine noises is no small matter. A normal engine should run with a steady hum. If you hear clicking or squeaking sounds, it's likely there's a problem. It could be a loose timing chain, worn bearings, or sometimes an aging belt. I once experienced a similar situation where the noise kept getting louder. When I took it to the dealership for inspection, they found that the piston rings were worn and needed replacement. I suggest you don't take it lightly and go to a professional repair shop for diagnosis immediately. Otherwise, it could lead to more severe damage or even safety hazards. During regular maintenance, check engine components more often and change the oil periodically to effectively prevent such issues. Safe driving is the top priority.
Was this review help?
12
3
Share
Expand All
More Forum Discussions

Why does a novice driver's car always veer off course?

The reasons why a novice driver's car always veers off course are: 1. Nervousness while driving, leading to excessive steering wheel movements; 2. Gripping the steering wheel too tightly; 3. Not fully mastering the technique of driving in a straight line. The solutions to prevent the car from veering off course are: 1. Avoid holding the steering wheel too stiffly or with excessive force; 2. Hold the steering wheel with both hands level and keep eyes looking straight ahead. Precautions for novice drivers include: 1. Maintain a good driving mindset; 2. Strictly adhere to traffic regulations; 3. Properly control the steering wheel while driving; 4. Perform car maintenance before setting off; 5. Be cautious when driving at night; 6. Drive slowly when reversing; 7. Estimate the following distance based on the current speed while driving.
18
1
Share

Why does fuel consumption increase after changing the mid and rear exhaust sections?

Because the backpressure level of the exhaust pipe affects the exhaust velocity. Whether the speed is fast or slow, it will influence the combustion efficiency at different RPM ranges. Excessively fast exhaust flow may cause unburned gases to be expelled, while overly slow exhaust flow increases cylinder temperature and reduces oxygen content, leading to decreased combustion efficiency. The ultimate result in both cases is increased fuel consumption and reduced power output. Here are additional details: 1. During modification: When modifying the exhaust system, it's necessary to select components based on the engine displacement and vehicle model, striving for optimal compatibility with the engine. 2. Automotive exhaust system: The automotive exhaust system refers to the assembly that collects and discharges waste gases, typically consisting of exhaust manifold, exhaust pipe, catalytic converter, exhaust temperature sensor, muffler, and tailpipe.
20
2
Share

Can a car tire with peeled skin be repaired?

Tire peeling cannot be repaired. However, if the tire is not leaking air, minor rubber loss or cracking on the tire sidewall can be patched. Generally, repairs are not recommended as they may lead to tire blowouts. Therefore, it is advisable to replace the tire as soon as possible. Here are the specific details about tire peeling: Damage condition: Whether a tire with peeled skin can continue to be used depends on the extent of the damage. If only the outer layer is slightly scraped and the surface is damaged without significantly affecting the tire's structural strength, it can still be used. However, if the peeling occurs on the tire sidewall and covers a large area or is deep, the tire should not be used further. The damaged area may develop bulges, which can easily cause a blowout, necessitating immediate replacement. Degree of wear: The decision should also consider the tire's wear condition. If the tire is relatively new, minor surface scratches or peeling may allow continued use. For tires that have been in use for a long time and show signs of aging or hardening, caution is advised if they experience scrapes or impacts, and replacement is often the best option.
19
4
Share

What does the oil change maintenance reminder in Volkswagen vehicles mean?

The oil change maintenance reminder in vehicles does not affect normal driving. The reminder can be cleared after the owner replaces the vehicle's oil, similar to the maintenance light, which serves to remind the owner of the need for regular maintenance. More relevant information is as follows: 1. Vehicle maintenance: Refers to the preventive work of regularly inspecting the vehicle, cleaning and lubricating, or replacing certain parts, or maintaining the vehicle's engine system, cooling system, fuel system, etc. Regular maintenance can keep the vehicle in good condition, extend its service life, etc. Cleaning involves removing external dirt, cleaning the body, and keeping fuel, oil, and various components clean. 2. Inspection: Mainly involves checking the tightness of connections between various parts and the technical condition of lighting and signal systems. Vehicle maintenance serves as a reminder for drivers to perform maintenance on time, ensuring the smooth operation of all components.
18
1
Share

What Are the Hazards of Car Exposure to Sunlight?

The hazards of car exposure to sunlight are as follows: 1. Accelerated paint aging: Prolonged exposure can cause oxidation of the car's paint surface, speeding up the aging process. 2. Accelerated rubber seal aging: This can lead to water leakage during rain and abnormal conditions in the car's internal components. Below is an introduction to related content: Correct approach: High temperatures and UV rays under strong sunlight can damage the car's paint, accelerating aging and fading. Therefore, when parking, it's best to choose a shaded area or use a car cover. Waxing your car also provides some protection to the paint layer, helping to mitigate the damage caused by intense sunlight.
9
5
Share

How long does it take for a tire to bulge after scraping the curb?

If a tire hits a pothole at high speed, it will bulge immediately; if the speed is slower or the impact is minor, the cord fabric may not break, and the tire won't bulge right away. Besides hitting potholes or impacts, the following situations can also cause tire bulging: 1. Driving with long-term underinflated tires: Underinflation squeezes the tire's cord fabric, making it prone to fatigue and cord breakage during driving. 2. Parking on uneven surfaces for extended periods: Parking with the tire on the curb can gradually damage the cord fabric, leading to bulging. 3. Wheel rim deformation: A deformed wheel rim can forcefully squeeze the tire, damaging the cord fabric and causing bulging after some time of driving.
15
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.