Is it necessary to reach the designated parking spot for the pull-over parking in Subject 3?
3 Answers
It is mandatory to reach the designated parking spot for the pull-over parking in Subject 3. Below are the key points to note for the pull-over parking in Subject 3: 1. Speed: Keep the speed slow, properly control the clutch to avoid stalling, and a slower speed makes it easier to adjust the distance between the vehicle body and the roadside line. Reduce speed and shift to second gear. 2. Parking: Depress the clutch and brake to stop, engage the handbrake, shift to neutral, turn off the turn signal—all these actions should be done smoothly in one go. 3. Rearview mirror: Always check the rearview mirror. Even if you add a head-turn observation, do not neglect the rearview mirror, as failing to check it may lead to point deductions. 4. Head-turn observation: Do not forget to perform a head-turn observation. Not turning your head to observe the traffic situation on the left rear before opening the door to exit the vehicle will also result in a failing score.
The pull-over in Subject 3 indeed requires stopping at a designated point, which is a pre-set area determined by the examiner based on the test route—usually marked by roadside lines or signs—and directly affects whether you pass. I personally experienced this during my driving test: I was in a hurry to stop and got points deducted for being half a meter short of the mark, prompting the examiner to have me retry that section. Remember, the test rules mandate stopping precisely at the marked spot, mainly to assess your ability to control speed and distance, such as keeping the car within 30 cm of the curb. The procedure includes signaling early, checking mirrors, and stopping slowly and steadily. Pulling the handbrake prematurely before reaching the point may be seen as improper operation and poses safety risks—after all, stopping randomly in real driving could cause a rear-end collision. Practice simulations often, using roadside objects like trees or poles as references, to naturally align with the mark.
For the parallel parking in Subject 3, stopping precisely at the designated spot is one of the core test requirements. When I was learning to drive at the driving school, the instructor repeatedly emphasized this point, explaining that examiners design specific parking zones based on the route layout, and only by stopping accurately there can you demonstrate solid driving skills. I once neglected this, thinking 'close enough' was fine, but the misaligned car body led to failure. Failing to meet the standard during the test affects your score or even results in an immediate fail, as it simulates real-life driving scenarios, such as safely pulling over in traffic. The key is to perform the actions smoothly: first slow down, signal, check mirrors, then gradually adjust the wheel position—never rush through it. Through repeated practice later on, I learned to use the curb or traffic signs as reference points, making it easier to master the distance.
