Is It Necessary to Install Headrests in Cars?

2 Answers
AdelineRose
07/29/25 4:04pm
It is necessary to install headrests in cars. Here is a detailed introduction to car headrests: Functions of Car Headrests: Car headrests play a protective role for the head in the event of a traffic accident. When a car is moving at high speed and a collision occurs, the resulting inertia concentrates most of the force on the neck. If the neck is not protected, the person's life is also at risk. Therefore, it is essential to use car headrests properly while driving. How to Use Car Headrests: When using car headrests, first adjust the angle between your body and the seat. Straighten your back and ensure the angle between your neck and body is gentle. The distance between the back of your head and the headrest should be as small as possible to minimize the damage caused by inertia during a traffic accident, reducing harm to the lowest extent. When installing the headrest, it should at least be parallel to the top of your ears, and the headrest must be securely fixed to provide better protection.
Was this review help?
10
1
Share
McLyla
08/15/25 4:19am
I firmly believe that car headrests are absolutely essential. Last time I was rear-ended on the highway, the headrest cushioned the violent backward jerk of my head—without it, my cervical spine would have been seriously injured. Now, the first thing I do when buying a car is adjusting the headrest height to ensure the center of the back of my head rests firmly against it. This is especially important for families with elderly or children in the back seats—they tend to doze off during rides, and their heads swaying around can easily cause neck strain. Avoid those fancy soft pillows; opt for ones with anti-whiplash design and internal steel frames for proper stability. These are as crucial as seatbelts—spending a few dozen bucks for peace of mind is totally worth it.
Was this review help?
5
5
Share
Expand All
More Forum Discussions

Is There a Charge for Checking Fault Codes at a 4S Shop?

Whether checking fault codes at a 4S shop incurs a charge generally depends on the following two aspects: 1. If the vehicle is within the warranty period, fault detection at the 4S shop is usually free of charge. 2. If the warranty period has expired, fault detection at the 4S shop usually requires a fee. Below are the common practices of 4S shops when a vehicle experiences a fault: (1) Technicians typically use a diagnostic computer to read the fault codes first. The electronic systems in modern vehicles are highly advanced. If a fault occurs in any part of the car, the computer will generate a fault code. Technicians can read these codes with a diagnostic computer, which helps them quickly identify the cause and location of the fault. (2) If the fault code cannot be read with the computer, the technicians at the 4S shop will assess the possible faulty parts based on the symptoms described by the owner. They will then conduct a test drive and finally troubleshoot the issue.
12
0
Share

Do modern cars still need to be warmed up before driving in winter?

Modern cars still need to be warmed up before driving in winter. Since winter temperatures are much lower than other seasons, the engine warms up relatively slower. After starting the vehicle, friction occurs between the engine and various moving parts. If these components suddenly operate at high speeds, prolonged exposure to such conditions may cause damage. Therefore, warming up the car is essential. Here's the correct way to warm up your car in winter: After starting the vehicle, drive at low speeds. This prevents unlubricated components from undergoing intense operation that could lead to damage. During this time, simply maintain the engine speed at around 2000 RPM, and wait until the engine coolant reaches normal operating temperature before driving normally.
1
4
Share

What should be paid attention to when repairing the differential?

When repairing the differential, the following points should be noted: 1. First remove the oil filler hole screw and drain the lubricating oil inside the differential; 2. Use a hex wrench to first remove the small pressure cover, take off the bearing snap ring on the pulley seat, use a puller to remove the belt pulley, and then remove the pulley seat; then use the hex wrench to remove the left end cover of the differential, use a pry bar to take out the first-stage planetary carrier, then remove the first and second-stage differential housing, remove the right end cover, and take out the third-stage and second-stage planetary carriers; 3. Disassemble the first, second, and third-stage planetary carriers separately, clean and inspect all gears, bearings, and the inner sleeves of the planetary carriers. The surfaces should be free of wear, and the bearing clearance should be kept within the fixed range. If there is any wear, they must be replaced; 4. Clean and inspect. After disassembly, the differential housing and planetary gears must be thoroughly cleaned to ensure normal meshing between the gears; 5. During the disassembly and repair of the differential, hammering or striking is not allowed. The integrity of the parts must be ensured. If necessary, a copper hammer or copper rod can be used; 6. The platform for repairing the differential must be covered with a rubber mat to prevent hard contact between parts.
7
1
Share

Which is Faster: Automatic or Manual Transmission?

Whether a manual transmission accelerates faster than an automatic transmission depends on the specific type of transmission: 1. CVT transmission: Manual transmission accelerates faster than automatic. 2. Dual-clutch transmission: Automatic transmission accelerates faster than manual. Below are the differences between manual and automatic transmissions: 1. Different levels of operational difficulty: Manual transmissions are suitable for skilled drivers; automatic transmissions are suitable for beginners. 2. Different structures: Manual transmissions have a clutch; automatic transmissions do not. 3. Characteristics of manual transmissions: Quick response, stable performance, good fuel economy, and strong power. 4. Characteristics of automatic transmissions: Extends the lifespan of components, improves vehicle performance, and reduces air pollution.
9
0
Share

Should Vehicle Maintenance Be Based on Mileage or Time?

Whether to perform maintenance based on time or mileage generally follows the principle of whichever comes first. There is no fixed answer, as car owners need to analyze their vehicle's specific conditions to determine the optimal approach. Here is a brief introduction to vehicle maintenance: (1) Routine Maintenance: Typically performed every 5,000KM (or 7,500KM for some models), it mainly involves changing the engine oil and oil filter, inspecting the fuel filter (many modern vehicles no longer have one), and checking the air filter—replacing them if excessively dirty. Additionally, each maintenance session must include an inspection of the brake discs and pads for potential replacement, checking the brake fluid level, and assessing tire conditions to ensure safety. (2) Periodic Maintenance: Usually conducted every 3 years or every 40,000KM. Beyond routine maintenance, it includes cleaning the fuel injectors, throttle body, and the vehicle's intake system. Furthermore, it requires replacing transmission fluid, front and rear axle oil, coolant, and brake fluid. Tire wear should also be inspected, with replacements made if necessary. (3) Major Maintenance: Typically occurs after the vehicle has traveled 100,000KM, involving a comprehensive inspection and replacement of parts as needed. Special attention should be paid to the wiring (electrical circuits) and transmission mechanisms during this phase.
8
3
Share

What Are the Reasons for No Hot Air in a Car?

Car no hot air reasons are as follows: 1. Thermostat failure, causing the cooling system to prematurely enter a large circulation cycle resulting in no hot air. 2. Dirty or clogged air filter, affecting the effectiveness of the hot air. 3. Broken heater control button, unable to transmit the corresponding hot air supply signal, leading to no warm air. 4. Clogged heater core, preventing coolant from passing through the small radiator resulting in no hot air. Below is the principle of car hot air: When the car air conditioning is heating, the high-temperature coolant from the engine flows through the heater core. At this time, the air blown by the blower also passes through the heater core, allowing the car air conditioning vents to blow out warm air.
19
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.