Is it necessary to go to the 4S store where the car was purchased for the first maintenance?

What are the reasons for improper intake camshaft positioning?

The improper positioning of the intake camshaft may be caused by a stuck camshaft solenoid valve, which requires timely replacement; or misalignment between the camshaft and crankshaft. If this misalignment exceeds one gear tooth, the corresponding fault code will appear. The vehicle has high-voltage spark: But the starting time is prolonged, though the vehicle can eventually operate. During the starting process: Crankshaft reversal may occur, and backfire may appear in the intake manifold. Unstable engine idle: Severe shaking, similar to a cylinder misfire condition. Insufficient vehicle acceleration: The car cannot gain speed properly when RPM exceeds 2,500.

1

4

Share

What Causes a Motorcycle to Lose Power?

Motorcycle losing power can be attributed to the following reasons: Engine Malfunction: Abnormal wear of the cylinder and piston rings, manual damage, clutch slippage, incorrect valve timing, excessively small valve clearance, etc., can all cause a motorcycle to lose power. In such cases, it is necessary to promptly visit a repair shop for professional inspection and maintenance to prevent potential safety hazards during use. Low-Quality Gasoline: If the quality of the gasoline is poor, it cannot fully perform during combustion, leading to a loss of power in the motorcycle. In this situation, it is advisable to switch to higher-quality fuel, which not only burns more efficiently but also extends the engine's lifespan to some extent. Engine Overheating: If the engine operates under prolonged overload, its efficiency will decrease. In such cases, it is recommended to stop the motorcycle and allow it to cool down naturally.

20

5

Share

How Far Can a Motorcycle's Reserve Fuel Last?

Motorcycle reserve fuel tanks generally have a capacity of around 2 liters, but not all of this fuel can be fully utilized as some remains unextractable. For typical 125cc or 150cc cross motorcycles, the reserve fuel can usually last approximately 50–70 kilometers. However, if the reserve fuel outlet pipe in the fuel tank switch is positioned higher, the distance may be shorter. Motorcycle Fuel Tank Switch: There are variations among different brands and models, so it's not accurate to simply state whether the reserve position is up or down, as these directions may be reversed depending on the motorcycle. Switch Indicators: Motorcycle fuel tank switches are marked with indicators. The switch handle has an arrow, and the switch itself features letters or graphical symbols. "ON" or a full cup symbol represents the main fuel tank, while "OFF" or a half-cup symbol indicates the reserve tank. The direction the arrow on the switch handle points to signifies which function is currently in use.

10

0

Share

Is there a mandatory retirement period for motorcycles?

The Hummer H2 SUT has a mandatory retirement period. As a large or medium-sized commercial passenger vehicle, the Hummer H2 SUT has a retirement period of 15 years. Retirement regulations for private cars: For family-use 5-seat sedans and 7-seat SUVs, as well as small and micro non-commercial vehicles, there is no usage period limit. When the normal mileage reaches 600,000 kilometers, the state will guide the retirement. In addition to the above vehicles, small and micro non-commercial passenger vehicles, large non-commercial cars, and wheeled special machinery vehicles also have no usage period limit. Common retirement regulations for commercial vehicles: Small and micro taxi passenger vehicles have a retirement period of 8 years, medium-sized taxi passenger vehicles have a retirement period of 10 years, and large taxi passenger vehicles have a retirement period of 12 years. Public transport passenger vehicles have a retirement period of 13 years, other small and micro commercial passenger vehicles have a retirement period of 10 years, and large and medium-sized commercial passenger vehicles have a retirement period of 15 years. Micro commercial trucks have a retirement period of 8 years, while light and large commercial trucks have a retirement period of 10 years.

20

5

Share

Can a motorcycle still undergo annual inspection if it hasn't been inspected for several years?

It can still undergo annual inspection. Check on the local traffic management bureau website: Since not every motor vehicle inspection station can perform motorcycle inspections, it's best to call ahead for consultation or check on the local traffic management bureau website before going. Emissions and lighting inspection: The emissions and lighting inspections are relatively strict during the testing process. Those who have modified their exhaust or lighting systems should take note. If the inspection is not passed, there will be three opportunities for re-inspection. Bring cash: The environmental protection hall at the inspection station only accepts cash, so remember to bring cash. Complete within three months: Motorcycles must be inspected every two years for the first four years, and then annually thereafter. The annual inspection must be completed within three months before the expiration date of the inspection period (as indicated on the vehicle registration certificate).

3

0

Share

What Causes the ABS Light to Illuminate in a Great Wall Pickup Truck?

ABS light illumination can occur in various states, with different causes and solutions for each state, as detailed below: State 1: ABS warning light remains constantly illuminated (most common). Cause 1: The ABS wheel speed sensor's sensing area is covered by dirt, mud, or other contaminants, affecting the sensor's ability to detect the corresponding speed signal. This prevents the ABS control unit from determining the vehicle speed and calculating the wheel slip rate, thus failing to issue appropriate commands to adjust braking. Solution: Clean the contaminants from the wheel speed sensor and adjust the gap between the sensor and the tone ring to restore normal function. Cause 2: Loose connections between system wiring or poor contact in the ABS relay can cause signal issues, leading to system failure. Solution: Inspect wiring connections and reconnect any loose parts. State 2: ABS warning light intermittently illuminates but turns off during acceleration. Cause: When multiple vehicle electrical components are in use, the battery voltage may drop below 10.5V. As engine speed increases, voltage rises, causing the ABS light to turn off. This can also occur if the ABS system power supply voltage is too low due to poor terminal contact or grounding issues. Solution: Check the battery's specific gravity; inspect the charging system; examine the power supply (e.g., voltage relay or poor power contact). State 3: ABS warning light remains illuminated after engine start and only turns off when the engine is turned off (IGFF). Cause: Poor grounding contact in the ABS hydraulic valve body; loose wiring connections in the ABS hydraulic valve body; ABS control unit malfunction. Solution: Loosen and retighten the hydraulic valve body's grounding screw, cleaning the contact surface if necessary; check for enlarged terminal gaps; replace the ABS or ABS/ASR control unit. State 4: ABS warning light illuminates during high-speed driving. Cause: During high-speed driving, the ABS control unit detects a significant discrepancy between rear and front wheel speed signals; incorrect tire or wheel rim specifications. Solution: Refer to the vehicle's specified tire and wheel rim sizes, as indicated on the fuel tank cap label. State 5: ABS warning light intermittently illuminates. Cause: Improper adjustment of the brake light switch; poor internal contact in the brake light. Solution: With the engine running, press the brake pedal and manually push the brake switch linkage downward to its limit, then release the pedal to complete self-positioning; replace the brake light switch if necessary. When the ABS warning light is illuminated, it is advisable to avoid continued driving. An illuminated ABS light indicates a malfunction in the vehicle's anti-lock braking system. During emergency braking, if the wheels lock up, the vehicle may skid uncontrollably, preventing the driver from slowing down or adjusting the vehicle's trajectory, posing significant safety risks.

2

3

Share

Is it necessary to go to the 4S store where the car was purchased for the first maintenance?

What are the reasons for improper intake camshaft positioning?

What Causes a Motorcycle to Lose Power?

How Far Can a Motorcycle's Reserve Fuel Last?

Is there a mandatory retirement period for motorcycles?

Can a motorcycle still undergo annual inspection if it hasn't been inspected for several years?

What Causes the ABS Light to Illuminate in a Great Wall Pickup Truck?

Can a New Car Be Driven on Mountain Roads During the Break-in Period?

What Engine Displacement Qualifies as a Heavy Motorcycle?

What battery model does the Teana key use?

What is the function of the oil pressure relief valve?