Is It Necessary to Clean Engine Carbon Deposits?

What to Do If Paint is Sprayed on the Car?

Methods to remove paint sprayed on the car: 1. Use banana oil for cleaning: Banana oil can be used to dilute paint and has a good cleaning effect on paint spots. Note its flammable, explosive, toxic, and volatile characteristics when using. 2. Use gasoline for cleaning, which does not have strong corrosive effects and can be applied by wiping with a damp towel. 3. Use fine sandpaper or a blade to remove, but operate carefully. 4. For slight marks, they can be repaired by waxing and polishing. Below are the functions of the car body: The main functions of the car body are to protect the driver and form a good aerodynamic environment. A good car body not only enhances performance but also reflects the owner's personality. The car body structure is mainly divided into two forms: body-on-frame and unibody.

19

4

Share

Is 10 liters per 100 kilometers high fuel consumption?

Different vehicles have different fuel consumption, so it should be analyzed flexibly based on actual conditions. Below is the relevant analysis: Family sedan: For an ordinary family sedan, 10 liters per 100 kilometers is relatively high. Cars with engine displacement above 2.0: For a car with an engine displacement above 2.0, 10 liters per 100 kilometers is not much and is considered normal. Large-displacement mid-size or full-size SUVs: For a large-displacement mid-size or full-size SUV, the fuel consumption is very low. General situation: Generally, SUVs have higher fuel consumption than sedans due to their greater weight and larger frontal area.

16

4

Share

What is the installation method for car sealing strips?

Car sealing strip installation method is to find the starting point of the sealing strip, then press and paste the strip bit by bit. Below is relevant information about sealing strips: 1. Function: Sealing strips can improve airtightness, preventing wind and rain from entering the cabin. Once the door sealing strips age and become damaged, it can lead to cabin leaks, increased driving noise, and leaks can easily cause body rust. 2. Maintenance: The waterproofing of various parts of the car body is ensured by sealing strips, which are made of rubber material. They have a certain strength and hardness and will not deform under certain conditions, but long-term exposure to air will inevitably cause aging. Combined with wear from frequent use, sealing strips can become very fragile, and once damaged, water can easily seep in. You can clean the sealing strips multiple times or gently wipe them with a damp cotton strip.

16

0

Share

What is the ideal idle speed for a car?

Normally it ranges between 700-800 RPM. Below is relevant information about car idle speed: 1. The function of car idle speed: Idle speed is an operational state of a car, referring to the engine running in neutral gear. The engine speed during idle is called idle speed. Idle speed can be adjusted by modifying parameters like throttle opening. Idling means the engine is "producing power without doing work". When the engine is running and the accelerator pedal is fully released, the engine enters idle state. 2. Causes of unstable idle speed: Direct causes refer to mechanical components being dirty, worn, or improperly installed, leading to variations in cylinder power output which creates imbalance among cylinders, resulting in unstable idle speed; Indirect causes refer to abnormalities in the engine's electronic control system causing poor combustion mixture, making it difficult to balance cylinder power output and resulting in unstable idle speed.

17

2

Share

Is it a problem if a sedan scrapes its undercarriage?

Whether the car's undercarriage is affected depends on various circumstances. Below are relevant details about the undercarriage: Different scenarios of undercarriage scraping: Minor scraping generally causes no issues; however, scraping the exhaust pipe or catalytic converter underneath the undercarriage can lead to exhaust system malfunctions. If the vehicle's suspension is scraped and deformed, it may cause wheel alignment problems, resulting in the car pulling to one side or producing unusual noises. Daily maintenance of the undercarriage: Ensure wheel hub bearings are well-lubricated and properly adjusted; adjust the front wheel toe-in appropriately; monitor changes in the front and rear axles and the frame; check the clutch's working condition; adjust brake clearance correctly; and inspect leaf springs for any damage.

16

3

Share

Is It Normal for the Car's Air Conditioning to Get Louder After Changing the Filter?

It is normal for the car's air conditioning to become louder after changing the filter. The function of the car's air conditioning filter: It ensures the filter fits tightly against the housing, preventing unfiltered air from entering the cabin. It separates solid impurities such as dust, pollen, and abrasive particles from the air. It adsorbs moisture, soot, ozone, odors, carbon oxides, SO2, CO2, etc., from the air and has strong and long-lasting moisture adsorption capabilities. Maintenance of the car's air conditioning filter: If the filter is dirty, clean it by blowing compressed air from the opposite side. Hold the air gun about 5 cm away from the filter and blow at 500 kPa pressure for approximately 2 minutes. The air conditioning filter easily accumulates dust, so blowing away loose dust with compressed air is sufficient.

14

1

Share

Is It Necessary to Clean Engine Carbon Deposits?

What to Do If Paint is Sprayed on the Car?

Is 10 liters per 100 kilometers high fuel consumption?

What is the installation method for car sealing strips?

What is the ideal idle speed for a car?

Is it a problem if a sedan scrapes its undercarriage?

Is It Normal for the Car's Air Conditioning to Get Louder After Changing the Filter?

What is under the feet in a car?

Which seat is best for pregnant women in a car?

Can a car be equipped with front parking sensors?

What is the speed rating code on tires?