Is it difficult to upgrade from C1 to B2?

1 Answers
Brad
07/30/25 12:26am
C1 upgrading to B2 does have certain difficulties. To upgrade from C1 to B2, you need to meet the requirement of no 12-point penalty record in the previous scoring cycle and the current scoring cycle, while direct application for B2 does not have this restriction. After successfully upgrading from C1 to B2, driving small passenger cars during the probation period is not subject to probation restrictions, whereas directly applied B2 licenses have probation restrictions for all vehicles. Below is additional information about upgrading from a C1 license to a B2 license: 1. Relevant regulations: According to regulations, the upgrading process can only be handled at the vehicle management office in the driver's registered residence, and cannot be processed in other locations. 2. Conditions to meet: (1) Age requirement: between 21 and 50 years old. (2) Must hold a C1 driver's license for more than one year, with no record of 12-point penalty in the last two scoring cycles, then you can apply for the upgrade at the vehicle management office where the license was issued.
Was this review help?
11
4
Share
More Forum Discussions

How to Release the Gear Lock on a Passat?

Press the brake pedal in the vehicle's cockpit, then press the one-touch start button of the vehicle. Power on the vehicle and press the RES button on the left side of the multifunction steering wheel. Press and hold the OK button on the right side of the multifunction steering wheel until you hear a beep, then release your hand. Turn the gear switch to the D position to unlock the anti-theft lock and start the engine.
20
0
Share

How to Remove the Passat Sunroof Sunshade?

Prepare the tools needed for removing the car sunshade. Use a flat-head screwdriver to gently pry up the edge of the sunshade that is hooked in place. After prying open the right side, rotate the sunshade clockwise by about ninety degrees with your hand, then use the flat-head screwdriver to gently pry off this small cover. Use a T-20 spline wrench to remove this screw, then gently pull down to separate the sunshade from the car's roof lining.
13
2
Share

How to Set Up the Power Window Control with Passat Key?

Gently press the button down to the first position and release it when reaching the desired position. Briefly press the switch to the second position to automatically open the window. Pull the button up to the first position and release it when reaching the desired position. Slightly pull the button up to the second position to automatically close the window. You can also use the lock and unlock buttons on the key for one-touch control of the power windows.
2
3
Share

What are the symptoms of a bad catalytic converter?

Symptoms of a bad catalytic converter: decreased engine power performance, increased fuel consumption, increased exhaust channel resistance, deteriorated emissions, engine mixture concentration disorder, difficulty in ignition or incomplete combustion, engine overheating, lack of engine power, and unpleasant exhaust odor. The catalytic converter is an important external purification device installed in the automobile exhaust system, which converts harmful gases such as CO, HC, and NOx emitted by automobile exhaust into harmless carbon dioxide, water, and nitrogen through oxidation and reduction. When high-temperature automobile exhaust passes through the purification device, the purifying agent in the catalytic converter enhances the activity of the three gases CO, HC, and NOx, promoting certain oxidation-reduction chemical reactions.
2
3
Share

What to Do When the Passat Multimedia Screen Goes Black?

Use the reset button on the all-in-one device (small hole RESET in the upper right corner), hold it for a few seconds, and the all-in-one device will automatically reset, restoring the screen to normal. First, check if the wiring connector of the car multimedia system is loose, and then check if it is a system issue. Restore the factory settings and restart. If the Haval H6 multimedia screen frequently goes black, it is likely a problem with the car multimedia system. It is recommended to contact after-sales service directly. If it is within the warranty period, free maintenance can be provided.
3
2
Share

How to Remove the ABS Sensor on a Passat Lingyu?

The ABS sensor is located at the inner side of the vehicle's knuckle hub and requires the removal of the wheel hub for clear visibility. The chrome-plated part of the sensor is inserted into the knuckle, with its wiring harness merging with the brake pad wiring harness, passing through the interior of the knuckle arm, and then entering the cabin through the rear of the wheel liner. During installation, avoid inserting it too deeply to prevent scraping the CV joint's tone ring, nor too shallowly, as this could cause the ABS to engage with light brake application.
8
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.