Is it better to turn on or off the ECO mode?

1 Answers
ZacharyFitz
07/29/25 4:38pm
Whether to turn on the air conditioning ECO mode depends on the occupants' requirements for the indoor temperature. The air conditioning ECO mode is an energy-saving mode, which is used in the cooling state to reduce the power of the compressor by lowering the frequency of the air conditioning start and stop without affecting the cooling effect. The compressor does not operate at the maximum cooling power. The ECO mode will automatically turn off under the following conditions: 1. When the vehicle speed exceeds 120 kilometers per hour, the ECO mode will automatically turn off. 2. When idling in park or in N/P gear as well as in manual mode, the ECO mode may also become ineffective. 3. When a large torque output is required, such as when climbing a slope or operating under heavy load, the engine computer will ensure sufficient vehicle power to drive the vehicle, and the ECO mode will not work either.
Was this review help?
2
2
Share
More Forum Discussions

How often should the transmission fluid be changed for an Audi A6?

Audi A6 transmission fluid should be changed every 65,000 kilometers or 84 months. Transmission fluid is an oil product that keeps the gear system clean, ensuring the normal operation of the transmission and extending the life of the transmission components. The Audi A6 is a mid-to-large-sized 5-door, 5-seat station wagon with body dimensions of 4951mm in length, 1886mm in width, and 1483mm in height, a wheelbase of 2925mm, and a fuel tank capacity of 73 liters. The Audi A6 is equipped with a 2.0T turbocharged engine and a 7-speed dual-clutch transmission, delivering a maximum power of 140 kilowatts and a maximum torque of 320 Newton-meters. It features front-wheel drive and uses five-link independent suspension for both front and rear suspension.
11
0
Share

What are the differences between the Mercedes-Benz GLC300 Dynamic and Luxury models?

The differences between the Mercedes-Benz GLC300 Dynamic and Luxury models are as follows: 1. Exterior: The Dynamic model features a two-bar grille design with chrome trim surrounding the lower bumper air intake, while the Luxury model has a single-bar starry sky grille design with a faux mesh pattern on the lower bumper. 2. Wheels: The 260 Dynamic model comes with 235/60R18 five-spoke alloy wheels, whereas the 260 Luxury model is equipped with 235/55R19 ten-spoke alloy wheels. 3. Technology: Front and rear parking sensors are standard on all GLC models (including entry-level versions). However, the 360-degree panoramic camera is only available on the 300 Luxury and 300 AMG-Line versions, while lower-spec models like the 300 Dynamic only come with a rearview camera.
1
3
Share

How to Replace the Battery in the New Mercedes-Benz GLS63 Key?

To replace the battery in the Mercedes-Benz GLS63 key, follow these steps: 1. Turn the key to its tail end, where there is a push button. Push it upwards, and the metal key inside will pop out. Remove the key. 2. There is a gap at the tail end of the key. Use a tool to pry it open with slight force, and the outer shell of the key will open. 3. After opening the shell, the key is positioned deep inside and cannot be removed by hand. Use a thin object to slide along the side gap and pry upwards to remove the old battery, then replace it with a new one. 4. After replacing the battery, ensure to check it, making sure the positive side is facing upwards. 5. Once the battery is securely in place, insert the shell back to cover it, and then reinsert the mechanical key.
7
3
Share

Will speed limits of 20 km/h be monitored for speeding?

Speed limits of 30 km/h are generally not monitored, but there may be exceptions. According to relevant regulations, mobile speed monitoring devices are generally not allowed to be set up on road sections with speed limits below 50 km/h (excluding 50 km/h). If special circumstances require their installation, approval from the Municipal Public Security Bureau's Traffic Police Division is necessary. Below is relevant information about speeding: 1. Introduction: Speeding refers to the act of driving a vehicle at a speed exceeding the legal limit. For example, the maximum speed limit on China's highways is 120 km/h. 2. Penalties for speeding: If the speed exceeds the limit by less than 10%, a warning will be issued. On roads with speed limits below 50 km/h, if the speed exceeds the limit by 10% to 20%, a fine will be imposed.
13
0
Share

What to Do When a Car Tire Gets a Nail Puncture?

Handling a nail puncture in a car tire depends on the specific situation: 1. If the nail is stuck in the tire tread, simply remove it; 2. If the nail has penetrated the tire but not gone all the way through and there is no air leakage, use pliers to pull it out; 3. If the nail has penetrated the tire tread completely, continuing to drive will worsen the damage, and you should replace it with a spare tire immediately; 4. If the nail has punctured the sidewall of the tire, slow down and drive to the nearest location to purchase and replace a new tire. The functions of a tire are: 1. To directly contact the road surface and work with the car's suspension to absorb shocks during driving; 2. To ensure good ride comfort and smooth driving; 3. To provide good traction between the wheels and the road surface.
18
5
Share

How to Solve Dual-Clutch Shudder During Start-Up?

Dual-clutch shudder during start-up can be resolved by: 1. Cleaning the fuel system and checking if the idle control valve has carbon deposits that need cleaning; 2. Inspecting the spark plugs for excessive carbon buildup and replacing them if necessary; 3. Checking the fuel pressure and replacing components if needed; 4. Replacing engine mounts or other worn-out parts. The causes of dual-clutch shudder during start-up include: 1. Insufficient engine power; 2. Loose connections between the transmission and chassis; 3. Uneven engagement of the clutch pressure plate and friction disc; 4. Dirty throttle body; 5. Unstable fuel system; 6. Damaged high-tension leads or faulty spark plugs. The clutch, located between the engine and transmission, acts as a switch for power transfer between them, capable of both transmitting and cutting off power as a transmission component.
6
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.