Is it a violation to go straight in a turning lane at an intersection?

1 Answers
OLondon
07/25/25 11:40am
Going straight in a turning lane is considered a traffic violation, as it constitutes driving not in accordance with the designated lane. Below is an introduction to the relevant content: Regulations: Even if the traffic light is green, you cannot go straight; upon entering, you must drive according to the lane guidance signs. Violation: If violated, it is considered a directional violation. Regulations: According to Article 37 of the Road Traffic Safety Law, where special lanes are designated on roads, only specified vehicles are allowed to travel within these lanes, and other vehicles must not enter. If a motor vehicle driver violates the road traffic safety laws or regulations regarding road usage, they may be subject to a warning or a fine.
Was this review help?
1
3
Share
More Forum Discussions

What are the reasons why the Volkswagen CC has power but won't start?

Here are the possible reasons why a Volkswagen CC has power but won't start: 1. Engine washing: Washing the engine may cause water ingress and moisture in the distributor, ignition module, spark plugs, or high-voltage wires. 2. Spark plug issues: Damaged spark plugs. 3. Insufficient voltage: Low battery voltage. 4. Switch disconnection: Inertia switch is turned off. 5. Check intake manifold and timing chain: If the car starts normally when warm but has this issue when cold or after sitting for a while, inspect the fuel system. For pre-2010 models, it's recommended to check the intake manifold and timing chain. 6. Prevention and solutions: Avoid direct engine washing. Regularly inspect, adjust, or replace spark plugs. Have damaged components checked and replaced at authorized service stations. Charge the battery. Reset the inertia switch to restore the circuit.
11
2
Share

How to Replace the Rear Wiper on the Qashqai?

The method to replace the rear wiper on the Qashqai is as follows: 1. Press the small clip of the rear wiper inward; 2. Push the bracket outward and remove it; 3. Open the clip of the frameless wiper and insert the bracket; 4. Align the position, pull tight, and secure the clip. The Qashqai is a 5-door, 5-seater compact SUV with body dimensions of: length 4401mm, width 1837mm, height 1593mm, and a wheelbase of 2646mm. It is equipped with a 2.0L naturally aspirated engine and a CVT continuously variable transmission, delivering a maximum power of 111 kW and a maximum torque of 194 Nm. The drivetrain is front-wheel drive, with a front suspension using a MacPherson strut independent suspension and a rear suspension using a multi-link independent suspension.
11
1
Share

What causes severe gear shifting jerks in the Changan CS55?

It may be due to damaged friction plates. Below is relevant information about the Changan CS55: 1. Exterior: Obsidian star grille; diving wave body design; three-dimensional obsidian-style rear; LED "cool" lights. The Changan CS55 offers "Dynamic Red" and "Starry Blue" as its main body colors, along with high-tech features that meet the demands of young consumers. 2. Interior: The Changan CS55 follows a "refined" approach in its interior design, featuring a three-spoke steering wheel and a symmetrical center console. The air vents, center control area, and red trim on both sides of the dashboard highlight its "individualistic" character. The seats come in a red and black color scheme, catering to the sporty preferences of younger drivers.
15
1
Share

What engine is used in the Changan Kaicheng F70?

There are three options: a 1.9-liter turbocharged diesel engine, a 2.5-liter turbocharged diesel engine, and a 2.4-liter turbocharged gasoline engine. Below is relevant information about the Changan Kaicheng F70: 1. Model Overview: The Changan Kaicheng F70 offers 19 series with over 100 configurations, including diesel/gasoline engines, 2WD/4WD, single/double cab, short/long wheelbase, manual/automatic transmission, right-hand drive, N1/M1 classifications, leaf spring/five-link suspension, and electric pickup variants. It features a multimedia system supporting 12 languages for markets in Asia, America, and Africa. 2. Endurance Capability: With 900mm wading depth, an 80L oversized fuel tank, and 1000km ultra-long range, it comes equipped with 18-inch wheels, 265 wide tires, and a 3.5t towing traction stability system.
1
1
Share

What is the fuel consumption of the Haval H9 diesel version?

Haval H9 diesel version has a fuel consumption of around 8 liters per 100 kilometers, which is not considered high. Factors affecting fuel consumption: Long idling time: Some may think that idling doesn't consume much fuel because the engine speed is low during idling. In terms of gasoline consumption per unit time, idling indeed doesn't consume much fuel. However, during idling, the vehicle is stationary, and the burned gasoline doesn't serve any practical purpose. It's simply wasted. Therefore, if the vehicle is parked for an extended period, it's better to turn off the engine rather than keeping it idling. Frequent lane changes: Practice has shown that driving straight at a constant speed is the most fuel-efficient, especially when maintaining an economic speed of 80-90 kilometers per hour.
14
1
Share

What is the correct method for shifting gears in a manual transmission?

The correct method for shifting gears in a manual transmission car is: 1. When starting, press the clutch all the way down, shift into first gear, release the handbrake, slowly release the clutch, and lightly press the accelerator while releasing the clutch; 2. Shift gears quickly and avoid looking down during the process; 3. Do not skip gears when shifting—always shift up or down one gear at a time. Skipping gears can cause discontinuous power delivery; 4. Do not coast in neutral when going downhill, as it reduces the engine braking effect; 5. Drive slower in rain or snow. The principle of a manual transmission is to manually move the gear lever to change the gear engagement inside the transmission, altering the gear ratio to achieve speed changes. Precautions for starting a manual transmission car: 1. Do not release the clutch too quickly—lift it gradually; 2. Press the accelerator only after the engine and driveshaft are connected; 3. Lightly press the accelerator during the semi-clutch phase before fully releasing the clutch.
16
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.