Is it a problem if a car tire runs over a glass bottle?

2 Answers
VonMadison
07/30/25 12:17am
Generally, running over a glass bottle with a car tire will not damage the tire because the tread structure of the tire is very sturdy and contains steel wires, making it difficult to be damaged. Below is some relevant information about car tires: 1. Tire shelf life: The main component of a tire is rubber, which has a shelf life, so tires also have a shelf life. Fresh rubber has the best performance, so newly manufactured tires also perform the best. ADAC's investigation of unused tires produced in different years shows that the longer a tire sits unused, the worse its performance becomes. 2. Replacement cycle: Tires are rubber products, and even if they are not used, they will age. It is recommended to replace tires every four years, and even if the mileage driven within the year is low, they should still be replaced.
Was this review help?
3
3
Share
LaBrody
08/16/25 4:33am
Honestly, last time I drove over a broken glass bottle, the tire instantly made a sharp screeching sound, which scared me so much that I immediately pulled over. When I got out to check, there were several obvious scratches on the tread, and glass shards were embedded in the rubber. Fortunately, I was driving slowly at the time, otherwise the risk of a blowout would have been high. The sharp fragments of glass bottles can easily cut through the tire surface, leading to slow leaks or sudden flats. If this happens at high speed, the danger increases significantly, potentially causing loss of control. Since then, I’ve been extra careful to avoid debris when passing through areas with lots of trash, and I always glance at my tires when getting out of the car. If you run over something, I recommend checking immediately: if there are no cracks, you can continue driving but should monitor the tire pressure; if there’s damage, it’s best to have a professional shop assess whether a repair is needed. Safety first—don’t take any chances!
Was this review help?
8
4
Share
Expand All
More Forum Discussions

What is the ground clearance of the Focus?

The unladen ground clearance of the Focus is 130mm, while the laden ground clearance is 120mm, and it reduces to 90mm with a skid plate installed. Below is some relevant knowledge about ground clearance: 1. Smaller ground clearance: The smaller the ground clearance, the poorer the vehicle's ability to overcome obstacles. Regarding minimum ground clearance, previous standards had a mandatory requirement of approximately 150~160mm, but this requirement has been removed in current standards. 2. Larger ground clearance: The larger the minimum ground clearance, the better the vehicle's ability to pass over obstacles or uneven terrain, but it also results in a higher center of gravity, which reduces stability.
8
1
Share

What are the symptoms of a damaged carbon canister solenoid valve in a Focus?

Here are the specific symptoms of a damaged carbon canister solenoid valve in a Focus: 1. Difficult engine starting (solenoid valve stuck open): Since the solenoid valve remains constantly open, the intake manifold will be filled with fuel vapors. During engine startup, an overly rich air-fuel mixture will cause starting difficulties or even stalling. 2. Fuel vapor leakage (solenoid valve stuck closed): When the solenoid valve remains constantly closed, the fuel vapors stored in the carbon canister cannot be purged. This leads to increased fuel tank pressure, eventually causing fuel vapors to escape through the tank cap's pressure relief valve.
19
2
Share

What does AMB mean in cars?

AMB in cars refers to switching between outdoor temperature and air conditioning temperature, where AMB represents the external ambient temperature signal. Cars are equipped with external temperature sensors, and when using automatic air conditioning, these sensors automatically detect the outdoor temperature and adjust the interior temperature accordingly, ensuring a consistently comfortable environment inside the vehicle. During the operation of automatic air conditioning, the system automatically regulates the airflow, humidity, and temperature inside the car. Once the occupants set a desired temperature, the automatic air conditioning system adjusts the air vents and fan speed based on signals from various sensors, maintaining an optimal air environment within the vehicle.
7
1
Share

What's the matter with the Focus not starting?

There may be a problem with the engine. The following describes common starting faults in cars: 1. Idling operation problems: It may be unstable idling, engine shaking, idling speed exceeding the upper limit, idling speed lower than the lower limit, or rough idling. These phenomena are related to faults or poor operation of components such as the injector, oxygen sensor, air flow sensor, and exhaust gas recirculation valve. 2. Abnormal exhaust pipe smoke: There may be black smoke, white smoke, or blue smoke. Black smoke indicates an overly rich mixture, related to defects in the fuel supply, air distribution, mechanical, or electronic control system; white smoke indicates excessive water in the fuel; blue smoke indicates oil burning.
18
2
Share

What documents are needed for car insurance?

Provide personal ID card, vehicle license, and vehicle insurance policy. The following are detailed introductions to the relevant content: 1. Introduction for those who have already purchased insurance: For car insurance renewal of vehicles that have already purchased car insurance, individuals need to provide an ID card, vehicle license, and the previous car insurance policy, while enterprises need to provide an organization code certificate, vehicle license, and the previous car insurance policy. 2. Introduction for first-time insurance purchase: New car insurance requires a vehicle qualification certificate, purchase invoice, and the ID cards of the owner and the insured. Original or photocopies of the above documents are acceptable, but both front and back sides are required.
9
0
Share

How Does a Parking Sensor Judge Distance?

Parking sensors determine distance through sound waves. A parking sensor system consists of ultrasonic sensors, a controller, and a display. It operates on the principle of ultrasonic distance measurement. Under the control of the controller, the sensors emit ultrasonic signals. When these signals encounter an obstacle, they generate echo signals. The sensors receive these echo signals, which are then processed by the controller to determine the obstacle's position. The distance is displayed on the screen, and a warning signal is issued. The primary function of parking sensors is to automatically activate during reversing, allowing the driver to know if there are obstacles behind the vehicle without turning their head. This alerts the driver to brake promptly or reduce reversing speed, helping to prevent accidents.
16
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.