Is Heavy Rain Harmful to Cars?

1 Answers
RafaelLee
07/30/25 1:48am
Heavy rain can cause significant damage to cars. Here is an introduction to the potential harm heavy rain can inflict on vehicles: 1. Damage to the car body: When rainwater mixes with dirt and grime, it forms contaminants that adhere to crevices. If not cleaned properly, this can lead to rust on the car body. 2. Damage to the paint: Rainwater in urban areas generally has high acidity levels. The acidic components in the rain can severely corrode the car's paint, causing damage that is difficult to repair. 3. Damage to the interior: As a vehicle ages, the sealing strips at the joints of the car body gradually deteriorate. 4. Damage to the ignition system: During rainy weather, when cold air outside the car meets the hot air inside the engine compartment, condensation forms on the ignition system. If this moisture does not evaporate in time, it can affect the operation of the ignition system, leading to symptoms such as difficulty in starting the car.
Was this review help?
8
2
Share
More Forum Discussions

Can You Make a U-Turn at a Highway Entrance?

You cannot make a U-turn at the entrance to a highway because U-turns are prohibited on highways. However, if you have not yet entered the highway and there is a designated U-turn point, you may make a U-turn without incurring penalties or fines. Prohibited behaviors on highways: Reversing, driving in the opposite direction, making a U-turn across the central divider, or stopping within a lane; overtaking on ramps, acceleration lanes, or deceleration lanes; straddling or driving on lane markings or shoulders; driving or parking in the emergency lane unless in an emergency; test driving or learning to drive a motor vehicle. Other highway regulations: When entering a highway from a ramp, vehicles must turn on the left turn signal and merge into the lane without obstructing the normal flow of traffic already on the highway. When exiting a highway, vehicles must turn on the right turn signal, enter the deceleration lane, reduce speed, and then exit.
9
0
Share

Is it possible to shift gears without depressing the clutch?

It is possible to shift gears without depressing the clutch, but safety precautions must be observed. Below is detailed information about automotive clutches: 1. Overview: Vehicle safety is primarily categorized into active safety and passive safety. Active safety refers to the ability to control the vehicle as freely as possible. Whether braking or accelerating in a straight line or steering left and right, operations should be as smooth as possible to avoid deviating from the intended path and without compromising the driver's visibility or comfort. 2. Additional Information: Automotive safety technology covers an increasingly broad and detailed range, evolving towards integration, intelligence, systematization, and comprehensive involvement. Strictly controlling speed during nighttime driving is a fundamental measure to ensure safety.
6
5
Share

How Long Does It Take to License a Car?

There is no specific regulation on the time frame for licensing a new car. If handled by a 4S shop, it usually takes about half a month. During this period, a temporary license plate is required to drive on the road. Below is more detailed information: Notes on Temporary License Plates: When displaying temporary license plates, it is important to note that two temporary plates should be affixed simultaneously. One should be placed in the upper right corner of the front windshield inside the car, ensuring it does not obstruct the driver's view and is not covered by the compulsory traffic insurance label. The other should be affixed in the upper left corner of the rear windshield inside the car. Temporary license plates have the same effect as formal license plates, meaning any traffic violations will still be recorded. Therefore, it is essential to adhere to traffic rules when using temporary plates to avoid violations or other accidents. Documents Required for Licensing: Vehicle certification, purchase invoice, and compulsory traffic insurance policy. Note: Make three copies each of your ID card, vehicle certification, purchase invoice, and compulsory traffic insurance policy for backup.
13
5
Share

What is the speed range for manual transmission gears?

Manual transmission gear speed correspondence table is as follows: 1st gear: Used for normal starting or climbing very steep slopes. When using this gear, the speed is generally around 10 kilometers per hour; 2nd gear: A transitional gear for acceleration after starting, or used for low-speed driving or climbing steep slopes, with speeds generally around 20 kilometers per hour; 3rd gear: Used at speeds between 20-40km/h, commonly used for city driving; 4th gear: Used at speeds between 40-60km/h; 5th gear: Can be used at speeds of 60Km/h. When shifting gears, the clutch and throttle must be coordinated well. Press the clutch all the way down, then immediately release the throttle pedal, and quickly shift to the corresponding gear. After shifting, release your hand immediately and avoid keeping it on the gear lever (commonly known as the gear stick) for too long, as this can easily damage the gear lever.
6
2
Share

Should You Press the Accelerator While Releasing the Clutch?

When starting a manual transmission car, it is necessary to release the clutch while pressing the accelerator, which is called clutch-accelerator coordination. Here is an introduction to the related content for starting: 1. Correct Coordination: Proper clutch-accelerator coordination should be adjusted according to the vehicle speed. During the starting phase, place the gear in neutral, start the engine, press the clutch pedal, shift the gear lever into first gear, slowly release the clutch, and coordinate with the accelerator pedal to ensure a smooth start. 2. Precautions: The clutch pedal must be fully depressed when pressing it. During the process of slowly releasing the clutch pedal, feel the vehicle's vibration and movement tendency. When the vehicle shows slight vibration and a tendency to move, gently apply the accelerator, continue to slowly release the clutch pedal until it is completely released, ensuring a smooth start. Clutch-accelerator coordination is equally important when shifting gears while the vehicle is in motion. As the vehicle speed increases, the process of clutch-accelerator coordination gradually shortens, meaning the speed of releasing the clutch pedal should be accelerated.
9
0
Share

What does the car air conditioner displaying 'lo' mean?

When a car air conditioner displays 'lo', it indicates the maximum cooling mode. Below is an introduction to related content about car air conditioners: 1. Car air conditioner modes: 'lo' stands for maximum cooling. When the vehicle's air conditioner panel displays 'lo', it means the air conditioner is currently in the lowest temperature cooling state, and the system is working at full capacity to cool. 'Hi' is the abbreviation of the English word 'high', meaning 'high'. When the air conditioner panel displays 'hi', it indicates the air conditioner is working at full capacity to heat, typically at 30 degrees Celsius. In this mode, the air conditioner transfers heat from the engine coolant into the cabin. 2. Precautions: Of course, if the vehicle is in a cold state, heating may be affected. Once the water temperature rises, heating will return to normal. Do not rest in the car with the air conditioner running while parked. When the car engine is running, incomplete combustion of gasoline in the cylinders can produce high concentrations of carbon monoxide, leading to poisoning.
2
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.