Is Geely's Engine Made by Volvo?

2 Answers
KylieRose
08/31/25 6:44am
Geely's engine is sourced from Volvo. The Geely Xingrui is equipped with Volvo's Drive-E series 2.0TD direct-injection turbocharged engine, which delivers a maximum horsepower of 190 HP, a maximum power of 140 KW at 4700 rpm, and a peak torque of 300 N.m. Geely's engines are produced independently by Geely. The powertrain options include two engine displacements: a 1.0T and a 1.4T turbocharged engine. The 1.0T engine is a three-cylinder unit with the model number JLF-3G10TD, while the 1.4T is a four-cylinder engine with the model number JLB-4G14T. For daily maintenance of Geely engines, the following methods can be used: Use lubricating oil of appropriate quality grade. For gasoline engines, select SD-SF grade gasoline engine oil based on the additional equipment of the intake and exhaust systems and usage conditions. For diesel engines, choose CB-CD grade diesel engine oil according to mechanical load, with the selection standard not lower than the manufacturer's requirements. Regularly change the engine oil and filter. The quality of any grade of lubricating oil will deteriorate over time. After a certain mileage, performance degradation can cause various engine issues. To avoid malfunctions, change the oil regularly according to usage conditions and maintain an appropriate oil level. When oil passes through the fine pores of the filter, solid particles and viscous substances accumulate in the filter. If the filter becomes clogged and oil cannot pass through, the filter may burst or the safety valve may open, allowing oil to bypass through the relief valve and carry contaminants back to the lubrication points, accelerating engine wear and increasing internal pollution. Periodically clean the crankcase. During engine operation, high-pressure unburned gases, acids, moisture, sulfur, and nitrogen oxides from the combustion chamber enter the crankcase through the gap between the piston rings and cylinder walls. These mix with metal particles from component wear to form sludge. Small amounts remain suspended in the oil, while larger amounts precipitate, clogging filters and oil passages, making engine lubrication difficult and causing wear. Regularly use a radiator cleaner to flush the radiator. Removing rust and scale deposits not only ensures proper engine operation but also extends the overall lifespan of the radiator and engine.
Was this review help?
19
3
Share
DeCamila
09/13/25 3:05am
Geely Automobile acquired Volvo Cars in 2010, and since then the two companies have begun sharing technologies, including engines. However, Geely itself has its own engine series. For example, some of their entry-level models like the Emgrand use Geely's self-developed 1.5T or 1.4T engines. In higher-end models, such as the Lynk & Co brand or the Xingyue SUV, Geely utilizes engines based on Volvo's Drive-E technology, like the 2.0T turbocharged engine, which has significantly improved both performance and fuel efficiency. This doesn't mean all Geely vehicles use Volvo engines; the brands remain independent, and Geely has its own R&D center in Ningbo. The technology sharing has enhanced the overall quality and reliability of Geely vehicles, allowing consumers to choose different configurations based on their budgets when purchasing a car. After the acquisition, Geely also introduced the CMA shared platform for compact cars, further integrating Volvo's engineering advantages.
Was this review help?
14
5
Share
Expand All
More Forum Discussions

What is the disassembly and assembly sequence of engine cylinder head bolts?

Engine cylinder head bolt disassembly and assembly sequence: The disassembly sequence of cylinder head bolts is to remove them in a cross-symmetrical order from both sides to the center of the cylinder head in two to three steps; The installation sequence of cylinder head bolts is to tighten them in a cross pattern from the center to both sides in three to four steps according to the specified torque. The function of the cylinder head is to seal the cylinder, form the combustion chamber together with the piston, and withstand the effects of high-temperature and high-pressure gas. The cylinder head bears the mechanical load caused by gas force and the tightening of cylinder bolts, as well as high thermal load due to contact with high-temperature gas. To ensure good sealing of the cylinder, the cylinder head must neither be damaged nor deformed, so it should have sufficient strength and stiffness.
12
0
Share

What to Do About Timing Chain Noise?

Solutions for timing chain noise include: 1. Replace the tensioner; 2. Replace the chain; 3. Replace the chain guide; 4. Check if the lubrication system is faulty; 5. If the noise is caused by low oil pressure, the noise will be louder at idle and reduce when accelerating. The method for replacing the timing chain is: 1. Remove the valve cover, detach the crankshaft pulley, and take off the timing chain cover; 2. Rotate the crankshaft to the top dead center of the first cylinder, then tighten the crankshaft fixing screw to secure it; 3. Rotate the intake and exhaust camshafts—there are grooves at the rear of the camshafts—align the grooves of both camshafts evenly, and insert the specialized tool; 4. Remove the old chain and install the new one.
3
4
Share

How are license plate screws installed?

First, drill a hole in the protective cap with a drill, then use a screwdriver to install the screw. Alternatively, use an angle grinder to remove the protective cap, and then install the screw with a screwdriver. Here are specific details about license plates: 1. Meaning: A license plate, commonly known as a vehicle plate, refers to the number plates attached to the front and rear of a vehicle. They are typically made of aluminum, sheet metal, plastic, or paper, and display the vehicle's registration number, registration region, and other relevant information. License plates serve to identify and register vehicles, allowing authorities to determine the vehicle's region of registration and access the owner's details and registration information. 2. Temporary license plates: Temporary license plates are issued by vehicle management authorities when a vehicle is undergoing registration procedures and has not yet been officially registered. These temporary plates have a limited validity period and are restricted to specific regions.
1
4
Share

How Many Models Does Mercedes-Benz Have?

Mercedes-Benz offers a wide range of models, including sedans, SUVs, sports cars, MPVs, and light commercial vehicles. Below is an introduction to Mercedes-Benz models: Mercedes-Benz Models and Classes: The A-Class is a compact hatchback, the C-Class is a compact sedan, the E-Class is a mid-size sedan, the S-Class is a luxury sedan, the M-Class is an SUV, the G-Class is an off-road vehicle, the V-Class is a multi-purpose van, the SLK is a compact sports car, the CLK is a mid-size sports car, the SL is a luxury sports car, the CL is a luxury coupe, and the SLR is a supercar. Introduction to Mercedes-Benz: Mercedes-Benz is a German automotive brand, with the "three-pointed star" as its logo, symbolizing the mechanization and integration of land, water, and air.
9
3
Share

What brand of transmission does the Boyue use?

The Boyue uses a self-developed transmission. The transmission is a mechanism used to change the speed and torque from the engine, capable of fixed or stepped changes in the transmission ratio between the output and input shafts. The Boyue is a compact 5-door, 5-seat SUV with body dimensions of 4519mm in length, 1831mm in width, 1694mm in height, and a wheelbase of 2670mm. It is equipped with a 1.8T turbocharged engine and a 6-speed manual transmission, delivering a maximum power of 120 kilowatts and a maximum torque of 250 Newton-meters. The drive system is front-wheel drive, with a front suspension using MacPherson independent suspension and a rear suspension employing a multi-link independent suspension.
13
0
Share

Where is the emergency trunk release switch for the Elysee?

The Elysee does not have an emergency trunk release switch. The method to open the trunk from inside the car for the Elysee is: the switch is located above the CD slot on the center console panel. Press the button, and the trunk will open automatically. Taking the Elysee 2018 1.6L Manual Fashion model as an example, the car's length, width, and height are 4427mm, 1748mm, and 1476mm respectively, with a wheelbase of 2652mm. The car is equipped with a 1.6L naturally aspirated engine, with a maximum power of 86kw and a maximum torque of 150nm, paired with a 5-speed manual transmission. The front suspension type is MacPherson independent suspension, and the rear suspension type is torsion beam non-independent suspension. The body structure is a monocoque, the drive type is front-engine front-wheel drive, and the power steering type is electric power steering.
8
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.