Is E or P More Fuel-Efficient?

1 Answers
DelJace
07/29/25 11:30pm
Using the E gear is more fuel-efficient. There are three methods to reduce vehicle fuel consumption: 1. Minimize vehicle weight: Keep the interior simple and avoid carrying unnecessary items, as every additional kilogram increases fuel consumption by 1%; 2. Avoid excessive modifications: Adding spoilers, protective covers, or wings can disrupt the car's original aerodynamic design, increasing wind resistance and consuming extra fuel. Modifying lighting systems increases electrical load and leads to unnecessary fuel consumption; 3. Develop good driving habits: Avoid sudden acceleration, driving at high speeds in low gears, prolonged idling, frequent lane changes or braking. Aim for smooth starts, steady-speed driving, and reduced braking.
Was this review help?
6
5
Share
More Forum Discussions

How to Identify China 4 and China 5 Vehicles?

Here is an introduction on how to identify China 4 and China 5 vehicles: 1. Check the "Automobile Fuel Consumption Label" on the new car: This label is usually affixed to the side window of the new car. The "Automobile Fuel Consumption Label" displays three types of fuel consumption indicators under urban, suburban, and combined driving conditions for light-duty vehicles. Additionally, imported new cars must also have this label, which is an essential document for consumers to identify fuel consumption levels or energy-saving effects. 2. Check the new car's nameplate, find the "Vehicle Model"—a combination of numbers and letters—and take a photo with your phone. This allows you to distinguish between China 5 and China 4 standards in just 10 seconds. 3. Locate the new car's engine model: Similarly, just take a photo. 4. Visit a national website: the Motor Vehicle Environmental Protection Website, enter the vehicle model and engine model, and perform a query. 5. If you are buying a used car or already own a car and want to confirm whether it meets China 4 or China 5 standards, you can directly take a photo of the vehicle model and query it on the National Motor Vehicle Environmental Protection Model Query Website.
2
3
Share

What does 'one panel' mean in car paint?

Because touch-up paint cannot have joints, this is the principle of paint touch-up. A 'panel' does not refer to one side of the front, back, left, or right, but rather to a segment. If it's on the same part, it counts as one panel. For example, on the left side of the car body, if the paint is damaged on one door, the entire door is repainted. If it's on two doors, then both entire doors are repainted. It's impractical to repaint an entire side, and there should be no touch-up paint joints where two panels meet. A car has 13 panels for painting, with the following details: 1. The front and rear bumpers (2 panels). 2. The left and right front fenders (2 panels). 3. The two left-side doors (2 panels). 4. The two right-side doors (2 panels). 5. The left and right rear fenders (2 panels). 6. The front hood (1 panel). 7. The rear trunk lid (1 panel). 8. The roof of the vehicle (1 panel).
17
3
Share

What to Do When the Car Fuel Pump is Too Noisy?

There are several reasons that may cause excessive noise from the fuel pump: 1. The viscosity of the hydraulic oil is too high. High viscosity reduces the pump's self-priming capability and volumetric efficiency. Pay attention to selecting hydraulic oil with appropriate viscosity in the future. 2. Improper installation of the fuel pump and motor, meaning the concentricity between the pump shaft and the motor shaft is inconsistent, causing the pump shaft to bear radial force and generate noise. At this time, you can check and adjust the concentricity of the fuel pump and motor installation to solve this problem. 3. The oil level in the tank is too low, or the suction pipe is blocked, increasing the pump's suction resistance, causing the pump to suck air or there is air leakage in the inlet pipe section. At this time, clean the filter, unclog the intake pipe, and check and tighten the connection screws of the inlet pipe section. 4. There is air inside the fuel pump. This fault usually occurs when a new pump is installed. When starting a new pump, you should first add oil to the pump to lubricate the pump's bearings, plungers, and cylinder block. You can open the fuel pump's oil filler port while the pump is running to allow the air inside the pump to escape from the filler port.
19
3
Share

How to Replace Coolant in Volkswagen Tiguan?

Volkswagen Tiguan Coolant Replacement Method: Before completely replacing the coolant, conduct a thorough inspection to check for any signs of leakage or cracks in the pipelines. Pay special attention to the five-way hose, which gets its name from the five connections it has to different parts of the car. The coolant flows through this hose and is distributed to various parts of the vehicle to perform its function. If there are signs of coolant leakage in this area, replace the hose or re-secure the connections as needed. Drain the old coolant, then flush the fluid channels with clean water. Add water to the coolant reservoir and continue filling until water flows continuously through the engine cooling system. Start the engine and let it idle for 3 to 5 minutes to circulate the water. Initially, the water draining from the reservoir may appear slightly pinkish. Continue flushing with clean water until the drained water runs clear. Remember to disconnect the heater hose to drain all water from the heater core. After draining for about an hour, add the new coolant through the radiator hose to allow it to flow quickly into the radiator. Then, fill the coolant reservoir with another batch of coolant until it is nearly full. Start the engine and let it run for about 10 minutes. As the cooling system expels some air, the coolant level will drop. Top it up again until it reaches the "MAXT" mark on the reservoir.
16
2
Share

What are the differences between the A4 and A6?

A4 and A6 are products from different platforms of Volkswagen. Below are the specific introductions of A4 and A6: A4 is a product from Volkswagen's B-series platform: The 01 model A4 used the B6 platform, sharing the same platform with the Audi S4, Volkswagen Passat, and Skoda Superb. However, the A4 and S4 belong to the PL46 sub-series (longitudinal engine), while the Passat and Superb are PQ46 (transverse engine). The 05 model A4 used the B7 platform, sharing platform technology with the Audi S4, Audi RS4, and SEAT Exeo. The new A4 in 2008 (called A4L in China) uses the B8 platform, sharing platform technology with the Audi A5, Q5, and A8. A6 is a product from Volkswagen's C-series platform: The so-called A6L in China is actually the 04 model Audi A6, based on the C6 platform, sharing platform technology with the Audi S6 and RS6. In automotive classification, the A4 belongs to the premium compact car (entry-level luxury car) category, while the A6 is classified as an executive car (luxury mid-size car).
1
2
Share

Does a sunroof need tinting?

Sunroofs do not require tinting. Here are the details regarding sunroofs: Disadvantages of tinting a sunroof: After tinting a sunroof, the increased glass thickness may, if not applied properly, lead to difficulties in smooth operation and affect the sunroof's sealing performance. Tinting primarily blocks UV rays and provides heat insulation, and it can also prevent injuries from glass shattering. However, sunroofs generally do not require tinting, as most sunroof glass already offers good heat insulation. If the sunroof is rarely used, the built-in sunshade is usually sufficient to block sunlight. Functions of a car sunroof: In hot summer weather, when the temperature inside the car is high, the best way to cool down is by opening windows for ventilation to allow air circulation. If the car has a sunroof, air exchange inside the vehicle will be faster. In winter, when condensation often forms inside the car, opening side windows can be too cold, but opening the sunroof can effectively address this issue. While driving on highways, the high speed can generate significant noise, rapidly increasing the decibel level inside the car. Opening the sunroof can quickly reduce noise levels, avoiding discomfort caused by car noise.
2
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.