Is driving at 120 km/h on a highway with a speed limit of 100 km/h considered speeding?

1 Answers
Marques
07/29/25 6:34am
If the highway speed limit is 100 km/h and the driving speed reaches 120 km/h, it constitutes a 20% speeding violation, punishable by a 200 yuan fine and 3 penalty points. Below is an introduction to highway speed limits: 1. Maximum speed: The maximum speed shall not exceed 120 km/h, and the minimum speed shall not be lower than 60 km/h. On highways, the maximum speed for small passenger vehicles shall not exceed 120 km/h, other motor vehicles shall not exceed 100 km/h, and motorcycles shall not exceed 80 km/h. 2. Minimum speed: When there are 2 lanes in the same direction, the minimum speed for the left lane is 100 km/h; when there are 3 or more lanes in the same direction, the minimum speed for the leftmost lane is 110 km/h, and the minimum speed for the middle lane is 90 km/h.
Was this review help?
13
2
Share
More Forum Discussions

How Long Does It Take to Charge a Car Battery Before It Can Start the Engine?

You can start the engine after charging for a short while, and driving the car will also slowly charge the battery. If you don't plan to drive it temporarily, it's recommended to charge it for five to six hours to fully charge it. Below are some car battery maintenance methods: 1. Use a damp cloth to clean the exterior of the battery, wiping off dust, oil stains, white powder, and other contaminants on the panel and terminals (the positive and negative poles) that may cause leakage. 2. Open the battery water cap and check if the water level is within the normal range. Most batteries have upper and lower limit markers on the side. If the water level is below the lower marker, you must add distilled water or tap water. 3. Check if the battery is charging properly. After starting the engine, measure the voltage across the battery terminals—it must exceed 13V to be considered normal. If you find the charging voltage is too low, you should have a professional inspect the charging system.
2
3
Share

What Causes the Engine Warning Light to Illuminate in a Magotan?

The engine warning light in a Magotan may illuminate due to the following 7 main reasons: Sensor malfunction: This includes sensors such as coolant temperature, crankshaft position, air flow, intake temperature, and oxygen sensors. When these sensors are damaged, have poor connections, or experience signal interruptions, the vehicle's ECU cannot accurately obtain engine data, triggering the engine warning light. Fuel or oil quality issues: If fuel or engine oil is not added according to the manufacturer's requirements, it may cause engine wear, leading to the warning light illuminating. Poor combustion of the air-fuel mixture: Poor combustion can result in engine carbon buildup or knocking. When detected by the oxygen sensor and reported to the ECU, the warning light will illuminate as a warning. Issues such as faulty spark plugs, ignition coils, fuel pumps, or clogged fuel lines can cause poor combustion. Turbocharger problems: Issues with the intake boost piping or turbocharger can also trigger the engine warning light. The most common problem is turbocharger damage, accompanied by symptoms like oil leaks, excessive oil consumption, reduced power, metallic noises, or blue/black smoke from the exhaust. Intake problems: If the vehicle's intake system malfunctions, it may lead to clogged engine pipes, and in severe cases, the engine warning light will illuminate. A dirty or uncleaned air filter can cause intake issues. Exhaust problems: Exhaust system failures can also trigger the engine warning light. Common causes include faulty rear oxygen sensors, catalytic converters, exhaust camshafts, or bearings. The catalytic converter is the most frequent culprit. Using leaded gasoline, lead- or silicon-based lubricant additives, physical damage to the catalytic converter, or fuel system malfunctions can all lead to catalytic converter issues. Anti-theft system malfunction: If the vehicle's electronic anti-theft system fails or the anti-theft controller does not match the engine ECU, the anti-theft system may prevent the engine from operating normally, and the engine warning light will illuminate. If the engine warning light illuminates, follow these steps: First, check whether the engine is running normally. If there are issues like shaking or black smoke, avoid restarting the engine. Note: Do not restart the engine if the red warning light is on. If the engine can start, turn it off and wait for 5-10 minutes. Without pressing the brake, press the start button once or turn the key halfway to the "ON" position (without pressing the clutch). The vehicle will enter self-inspection mode after powering on. Wait for 5-10 seconds to see if the warning light turns off. If the warning light remains on, visit a service center as soon as possible. Technicians can use a portable diagnostic tool to read fault codes, identify the issue, and perform targeted repairs.
11
3
Share

Is an Appointment Required for the Hangzhou Subject 4 Exam?

An appointment is required for the Hangzhou Subject 4 exam. As of July 2020, candidates cannot directly take the Subject 4 exam at the test center; they must make an appointment in advance either through a driving school or online. The appointment can be scheduled after passing the Subject 3 exam. The Subject 4 theoretical exam, also known as the driver's theory test, is part of the motor vehicle driver's license assessment. Since this exam is conducted after Subject 3, it is commonly referred to as the Subject 4 exam. The content of the Subject 4 exam includes: 1. Based on the type of driver's license being tested, 50 questions are randomly selected from the corresponding Subject 4 question bank in a proportional manner. For car licenses, questions are selected from a pool of 1,240, while for large vehicle licenses, questions are selected from a pool of 1,235, with each question worth 2 points. 2. The exam duration is 45 minutes, and the test is terminated if 12 points (6 questions) are answered incorrectly during the exam. 3. The exam questions are divided into true/false questions (questions 1-22), single-choice questions (questions 23-45), and multiple-choice questions (questions 46-50). 4. The exam includes picture-based questions, scenario recognition questions, and text-based questions.
10
4
Share

What is the fuel consumption of the Civic?

The official combined fuel consumption of the tenth-generation Civic is 5.4-6L/100km. Here is an introduction to the tenth-generation Civic: 1. Powertrain: The new Civic is the domestic version of Honda's tenth-generation Civic, featuring a more youthful and sporty design. It is equipped with a 1.5T and 1.0T engine, with the 1.5T model being launched first, paired with either a 6-speed manual or CVT transmission. A total of four models are available. 2. Exterior: The new Civic largely retains the design of the overseas model, featuring full LED headlights. The side profile of the car is more daring than the front, with the C-pillar's smooth transition resembling that of a Coupe model. It adopts 'bracket-style' LED taillights, with the light clusters shaped like darts.
2
4
Share

What Causes Tire Bulges?

Tire bulges can occur due to the following reasons: 1. Tire bulges are caused by excessive internal pressure. 2. If the sidewall of the tire is impacted during driving, the sidewall fabric may rupture, allowing outside air to enter the tire and causing a bulge. The following situations indicate that a tire cannot be repaired: 1. Damage to the sidewall cannot be repaired. 2. A puncture in the tread with a diameter exceeding 6 millimeters cannot be repaired. 3. Damage such as bead damage or deformation, tread deformation, rubber corrosion by chemicals, or damage from driving under-inflated cannot be repaired. 4. The tire has a bulge.
15
2
Share

What happens when a car's ball joint is broken?

Symptoms of a broken car ball joint include: 1. The chassis will make a clunking noise when driving on bumpy roads. 2. Uneven tire wear, unstable driving, and the car may sway from side to side. 3. Braking deviation. 4. Steering wheel vibration, which in severe cases may lead to steering failure. Introduction to steering ball joints: 1. The steering ball joint is a crucial component in a car's steering mechanism, directly affecting the stability of vehicle handling, driving safety, and tire lifespan. Therefore, it must be replaced promptly if damaged. 2. The function of the steering ball joint is to use a spherical connection to transmit power between different axes, providing multi-angle rotation, allowing the steering mechanism to turn smoothly, reducing vibration, and achieving smooth steering.
11
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.