Is Antifreeze Universal?

1 Answers
FinleyLee
07/30/25 4:25am
Antifreeze is not universal; you must use the same brand of antifreeze. Different brands of antifreeze have varying production formulas, and mixing them may lead to chemical reactions between multiple additives, rendering them ineffective. The basic indicators of antifreeze are its freezing point and boiling point. In the market, antifreeze comes in several specifications with freezing points such as -15°C, -25°C, -30°C, and -40°C. Generally, it is advisable to choose an antifreeze with a freezing point at least 10°C lower than the lowest temperature in your region. Antifreeze replacement cycle: For vehicles that operate for long periods, such as taxis, high-quality antifreeze should generally be replaced once a year. For vehicles with shorter operating times, replacement can be done every two years or every 30,000 kilometers. To prevent excessive foam formation, which reduces the heat exchange efficiency between the antifreeze and engine components, ensure the product is within its validity period when adding it. Long-lasting antifreeze can have a validity period of up to three years. If suspended particles, sediment, or signs of deterioration or discoloration are found in the antifreeze, it should be replaced promptly, and the system should be cleaned.
Was this review help?
12
1
Share
More Forum Discussions

How to Replace a Motor Vehicle Driver's License?

After losing your driver's license, there is no need to report it as lost. You only need to promptly apply for a replacement at the vehicle management office. When applying for a replacement, you need to fill out a written statement of loss for the motor vehicle driver's license to prove that the license has indeed been lost.
2
1
Share

How to Replace the Honda City Gasoline Filter?

Remove the rear seat of the Honda City vehicle. Use a flat-head screwdriver to pry open the cover of the Honda City fuel pump. Take off the fuel pump cover. Unplug the Honda City fuel pump connector. Disconnect the Honda City fuel inlet pipe. Remove the entire Honda City fuel pump. Pry up the Honda City fuel pipe. Take out the Honda City gasoline filter. Install the new gasoline filter back in its original position to complete the operation.
14
0
Share

Is It Normal for a Newly Replaced Battery to Get Hot While Charging?

It is normal for a newly replaced battery to get hot while charging. Reasons why the battery heats up during charging: During charging, the battery's charging current is generally high, causing the electrolyte inside to heat up and boil, which results in some temperature rise—this is normal. Additionally, the battery itself has internal resistance, and the passage of current naturally generates heat. If the battery becomes excessively hot (to the point of being too hot to touch), it may be due to improper charging practices or a potential issue with the battery itself. This can lead to water loss in the battery, shortening its lifespan. Precautions during charging: A car battery getting hot during charging will not explode, but it can damage the battery. This may be caused by severe sulfation or overcharging, in which case charging should be stopped immediately, and the sulfation should be addressed promptly. Typically, charging takes about 8-10 hours. If using a low current, it may take around 12 hours to fully charge. However, it is important to note that you should not wait until the battery is completely drained before charging. It is recommended to charge when the remaining battery level is around 70%, as this usually takes only 6-8 hours to fully charge. Avoid overcharging.
16
3
Share

How to Deal with Engine Oil Stains on the Car?

If the oil stain is discovered early, it can be wiped off directly with a cloth. If the oil stain has been there for a long time, you must use automotive-specific cleaning sandpaper to remove the stain, and then restore the car's surface gloss by waxing.
18
3
Share

How to License a Motorcycle?

Go to the vehicle inspection station to have the motorcycle inspected and pre-record the information. After queuing up to get a number in the service hall, submit the required documents at the acceptance window. Proceed to the payment window to pay the relevant fees. Go to the license and certificate window to collect the license and certificate; then proceed to the license plate installation point to have the plate installed.
5
0
Share

How to open the trunk from inside the Peugeot 408?

Below the left side of the steering wheel, there is a button for adjusting the headlight height, and the button next to it is for opening the trunk. The remote key can also be used to open the trunk.
15
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.