Is an Idle Speed of 1000 RPM Normal for a Car?

2 Answers
PatrickMarie
07/28/25 2:31pm
An idle speed of 1000 RPM is not normal for a car. An idle speed of 1000 RPM is too high; the typical idle speed usually ranges between 700 and 900 RPM. Idle state refers to a working condition of the engine when it is running without load. When the engine is running, if the accelerator pedal is completely released, the engine enters the idle state. When adjusting the idle speed, the RPM should not fluctuate abruptly, as this can cause premature wear to the engine. It is best to have the idle speed adjusted by an automotive repair service. Idle speed refers to the engine running without any load, only overcoming the internal friction resistance of its components, without delivering any external power. The minimum RPM required to maintain stable engine operation is called the idle speed, which is one of the five basic operating conditions of an engine. For an engine with good performance, the idle speed is generally between 550-800 RPM. Solutions for high idle speed in cars: When the engine idle speed is too high, first start the engine, then manually control the throttle arm to close the throttle. If the idle speed returns to normal, it indicates that the throttle return spring is too weak and should be replaced. If manually closing the throttle is ineffective, check whether the throttle shaft is loose or if the throttle is closing properly. If the throttle does not close tightly or the throttle shaft is loose, it should be repaired. If the throttle is functioning normally, check for minor air leaks below the throttle. If leaks are found, they should be eliminated. If no leaks are found, further adjust the idle speed until it reaches the appropriate level.
Was this review help?
6
0
Share
MacMaya
08/11/25 10:32pm
In my opinion, an idle speed of 1000 RPM is quite common in many cars, especially when starting up or in cold weather. My car usually idles at around 700-800 RPM, but when the air conditioning is on or during winter, the RPM jumps to around 1000, which is no big deal. The engine needs a slightly higher RPM to maintain stable operation and avoid stalling. However, if the idle speed consistently stays at 1000 RPM without any shaking or unusual noises, it’s generally not a cause for concern. If there’s severe shaking or increased noise, it might be due to a dirty throttle body with carbon buildup or a faulty sensor, in which case it’s advisable to visit a repair shop. Regularly cleaning the air filter or performing maintenance can help prevent such issues. Overall, 1000 RPM isn’t abnormal, especially for electronically controlled modern cars, so you can drive with peace of mind.
Was this review help?
10
4
Share
Expand All
More Forum Discussions

How to Open the Fuel Tank Cap of BYD F0?

There are English words 'OPEN' and 'CLOSE' next to the lock on the BYD F0 fuel tank cap. Turn the key to 'OPEN', then twist the cap by hand to open it, regardless of the key. To lock it, screw the cap back on and turn the key from 'OPEN' to 'CLOSE' to secure it.
4
4
Share

How to Jump Start the Negative Terminal of a Peugeot 408 Battery?

Before connecting, ensure the engines, audio systems, and air conditioning of both vehicles are turned off. First, attach the red clamp of the jumper cable to the red positive terminal of the battery. Attach the red clamp of the jumper cable to the red positive terminal of the 'rescued vehicle.' Then, attach the other end of the red clamp to the positive terminal of the 'rescue vehicle.' After successfully starting the engine, remember to remove the jumper cables in the correct order to avoid the risk of a short circuit.
4
1
Share

How to Reset the Throttle Body on a BYD?

First, remove the car key, open the hood, and locate the throttle body on the engine. Use a flat-head screwdriver to remove the air filter and intake pipe, then unplug the electrical socket on the throttle body. After unscrewing the bolts, the throttle body can be taken out.
12
0
Share

How to Remove the Gear Knob of BYD F3?

Hold the gear knob (if your hands are slippery, you can use a towel for better grip), then twist it forcefully to the left to remove the ashtray. Lift upwards at the position of the ashtray to take off the gear lever cover panel.
16
1
Share

How to Connect Bluetooth on Santana to Play Music from Phone?

First, turn on the car's Bluetooth. At this time, the car's Bluetooth display will show a pairing request password, usually 0000. Then, enable Bluetooth on your phone. The phone will detect the car's Bluetooth information. Click on it and enter the pairing password.
20
0
Share

How to Playback Recordings on Highlander Dash Cam?

The dash cam is equipped with a display screen, and generally, you can directly view the playback on the dash cam by clicking on the recorded video file to play it. Nowadays, most dash cams have corresponding mobile apps that support viewing video playback on your phone, making the operation more convenient.
18
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.