Is Acura Imported?

Is It Correct to Use the Left Foot for Braking and the Right Foot for Accelerating?

Yes, but it's not entirely accurate. To be precise, for manual transmission vehicles: the left pedal is the clutch, the middle is the brake, and the right is the accelerator; for automatic transmission vehicles: the left pedal is the brake, and the right is the accelerator. Below are some tips for novice drivers: 1. Use the right foot to press the brake: New drivers, who may lack proficiency, are advised to press the brake with the right foot when starting the car. Of course, the accelerator is also controlled by the right foot, which helps prevent mistaking the accelerator for the brake in emergency situations. 2. Warm up the car in winter: New drivers should remember to warm up the car in winter. It's simple—let the car idle for half a minute, then drive at low speed. For manual transmission, you can drive without pressing the accelerator for 3-5 minutes before normal driving. 3. Stay calm in difficult situations: New drivers should remain calm when encountering challenging maneuvers like reversing, parking, or turning at intersections. Don't feel overwhelmed by the difficulty of driving, as beginners often lack road sense. After driving around 10,000 kilometers, road sense will develop, and driving will become much more familiar.

11

0

Share

What Causes the Failure of Anti-Theft Authentication and Inability to Start the Engine?

Solutions for engine authentication failure and inability to start the engine are as follows: 1. Press and hold the one-touch start button, then press the unlock button: Open the door, sit in the driver's seat, take out the car remote key, and place it close to the one-touch start button for more than 30 seconds. Continue holding the key near the one-touch start button and press the unlock button on the remote key. 2. Try pressing the trunk button: Press it several times or press the lock and trunk buttons a few more times. If multiple attempts still fail to resolve the engine system authentication failure alarm, it is advisable to take the vehicle to a repair shop for inspection. Reasons for engine authentication failure include the following situations: 1. The internal chip of the key is not matched/locked. 2. Faulty anti-theft read coil. 3. Communication failure between the anti-theft coil and the anti-theft control unit. 4. Internal fault in the anti-theft control unit/communication failure with the engine control unit/lack of matching between them. 5. Electromagnetic wave interference, etc.

19

0

Share

What Causes the Abnormal Noise When the Car Air Conditioner is On?

Abnormal noise from a car's air conditioner is generally caused by issues either inside or outside the air conditioning system. Internal noise is usually due to air or moisture in the refrigerant, which creates noise during evaporation and expansion, making the driver feel as if the sound is coming from inside the dashboard. External noise is typically from the air conditioning compressor, and the sound can be felt near the compressor. Below are other possible causes of abnormal noise in a car's air conditioner: 1. Impurities in the refrigerant: The noise is often caused by air and moisture mixed into the refrigerant. 2. Damage to the internal structure of the compressor: If the noise persists after refrigerant recharge and is located near the compressor, there is a high probability of internal mechanical damage to the compressor. If the noise recurs after some time and is located inside the dashboard, it is more likely due to reduced efficiency of the dryer. The noise after the air conditioner starts is mainly the working noise of the compressor and is not considered a fault.

6

3

Share

What are the symptoms of a bad brake pump?

Here are the symptoms of a faulty brake vacuum pump: 1. No braking effect: Poor braking performance or no braking effect at all; 2. Oil leakage: Visible oil leakage at the external connections of the vacuum pump; 3. Brake pedal not returning: The brake pedal returns slowly or does not return at all; 4. Abnormal noise: A noticeable abnormal noise can be heard when the brake pedal is pressed; 5. Braking direction deviation: The vehicle pulls to one side or vibrates when braking. Additional information: The brake vacuum pump, also known as the brake booster pump, controls the vacuum entering the booster pump during braking. It moves the diaphragm and uses the pushrod on the diaphragm through a linkage device to assist the driver in pressing and pushing the brake pedal, thereby amplifying the force applied by the driver.

6

0

Share

Should You Use Recirculation Mode When Turning on AC in Summer?

When using the car's air conditioning in summer, activating the recirculation mode can achieve better cooling effects. The cooling process involves lowering the temperature of hot air through the compressor before circulating it into the car. If recirculation mode is on, the already relatively cool air inside the car is further cooled down. In contrast, the fresh air mode requires cooling the hot air from outside each time, which has limited cooling efficiency per cycle. Therefore, it's evident that recirculation mode provides superior cooling performance. The differences between car recirculation and fresh air modes are as follows: 1. Different air circulation methods: Recirculation mode circulates the air inside the car in a closed loop, while fresh air mode draws outside air into the car. 2. Different air circulation states: In recirculation mode, the interior air is reheated or recooled before being sent back into the cabin. Fresh air mode heats or cools outside air before introducing it into the car. 3. Different working principles: Recirculation mode promotes air circulation within the car. Fresh air mode uses a fan to bring outside air into the vehicle while expelling interior air through another fan, achieving ventilation without opening windows.

14

1

Share

What does 235/55r19 on tires mean?

235/55-r19 represents the following: 235: The tire width is 235 millimeters; 55: Known as the tire's aspect ratio, meaning the ratio of the sidewall height to the tire width is 55%; R: Radial tire (steel-belted radial); 19: The rim diameter is 19 inches. Additional information: 1. Tire number meanings: Tire specifications are commonly represented by a set of numbers, where the first number indicates the tire section width, and the latter indicates the rim diameter in inches. For example, 165/70R14 means a tire with a width of 165 millimeters, an aspect ratio of 70, and a rim diameter of 14 inches for a radial tire. 2. Letter symbol extensions: Some tires may include other letters or symbols with special meanings: "X" denotes high-pressure tires; "C" denotes reinforced tires; "B" denotes bias-ply tires; "-" denotes low-pressure tires. M and S are abbreviations for Mud and Snow in English, indicating that the tire is suitable for use on snowy and muddy roads.

9

2

Share

Is Acura Imported?

Is It Correct to Use the Left Foot for Braking and the Right Foot for Accelerating?

What Causes the Failure of Anti-Theft Authentication and Inability to Start the Engine?

What Causes the Abnormal Noise When the Car Air Conditioner is On?

What are the symptoms of a bad brake pump?

Should You Use Recirculation Mode When Turning on AC in Summer?

What does 235/55r19 on tires mean?

How Often Should the Cabin Air Filter Be Replaced?

What do vl and v represent in terms of national emission standards?

What brand is doublestar tire?

What to Do When the Traction Control Off Light Comes On?