Is a tire pressure of 200 kPa normal?

1 Answers
LeWillow
07/29/25 9:33pm
A tire pressure of 200 kPa is not normal; 200 kPa is slightly low. Generally, tire pressure should be between 220 kPa and 240 kPa. Tire pressure refers to the air pressure inside the tire. There is a standard tire pressure label on the rear end of the driver's side door, which indicates the pressure when the tire is cold, i.e., when the vehicle has been parked for at least three hours or driven no more than 1.6 km. The measured tire pressure under these conditions is accurate. Hazards of low tire pressure: The friction coefficient with the road surface increases, leading to higher fuel consumption; it causes the steering wheel to feel heavy and increases the risk of veering, which are factors detrimental to driving safety; it increases the movement of various parts of the tire, leading to excessive rolling and abnormal heating of the tire; it reduces the functionality of the cords and rubber, causing delamination or cord breakage, excessive friction between the tire and the rim, resulting in damage to the bead area and abnormal wear. The friction between the tire and the ground increases exponentially, causing the tire temperature to rise sharply, the tire to soften, and its strength to drop drastically. If the vehicle is driven at high speeds, this may lead to a tire blowout; it increases the deformation of the tire body, making the tire sidewalls prone to cracking, while also causing flexing movements that lead to excessive heat, accelerating rubber aging, fatigue in the cord layers, and cord breakage. It also increases the tire's contact area with the ground, accelerating wear on the tire shoulders.
Was this review help?
14
3
Share
More Forum Discussions

Is it necessary to clean the Mercedes-Benz intake tract?

Cleaning the Mercedes-Benz intake tract is necessary. Cleaning cycle: Regular car washing, once a week is sufficient, and it doesn't need to be too frequent. Do not wash the car within one week after applying a car wrap. Dirt can be wiped clean with a soft, fine towel and water. Corrosive contaminants (such as oil stains, dyes, bird droppings, etc.) should be cleaned as much as possible within 24 hours. Leaving them unattended may result in stubborn marks that are difficult to remove. Return to the wrapping shop every six months or a year for a wrap maintenance, which is essentially a thorough cleaning of the wrap surface to remove accumulated stubborn stains. Precautions: Avoid directly flushing the edges with a water gun to reduce the chance of peeling. Do not use acid or alkaline corrosive cleaners to clean the car wrap.
13
2
Share

What adhesive should be used for a detached car roof lining?

Roof lining detachment is generally caused by aging of the fabric sponge. Special automotive adhesive or bonding products can be used for reattachment. Below are solutions for addressing detached car roof linings: 1. Adhesive bonding: Car owners can purchase a bottle of specialized automotive adhesive or bonding products online (ensure the adhesive is heat-resistant). Apply the adhesive along the detached area and press firmly to reattach. 2. Clip fastening: If the detachment occurs in the middle section where adhesive repair is difficult, car owners may opt for clip fastening. While this may not look visually perfect, it remains an acceptable solution. 3. Complete roof lining replacement: First remove the roof lining, clean off the aged sponge surface, prepare a new roof lining fabric with specialized roof adhesive, apply adhesive to both surfaces, wait 3-5 minutes before bonding, then reinstall the lining. DIY replacement can be challenging, so it's recommended to have a repair shop handle this procedure.
4
1
Share

How often should the transmission fluid be changed for the Dongfeng Nissan Tiida?

Tiida should have its transmission fluid changed every 40,000 kilometers. Below is a partial introduction to the related content:1. The Tiida measures 4393mm in length, 1766mm in width, and 1539mm in height, with a wheelbase of 2700mm. It features front-wheel drive, a front suspension type of MacPherson strut (with high-rigidity stabilizer bar), and a rear suspension type of torsion beam (with high-rigidity stabilizer bar).2. Transmission fluid is essential for keeping the transmission system clean. It helps maintain the transmission in normal working condition and extends the lifespan of the vehicle's transmission components.3. Transmission fluid can be categorized into manual transmission fluid and automatic transmission fluid (ATF) based on structural differences. ATF serves both as a transmission fluid and a hydraulic fluid, suitable for different parts within the vehicle.
11
3
Share

Where is the Cabin Air Filter Located in a Cadillac XTS?

Cadillac XTS's cabin air filter is located inside the glove compartment on the passenger side. The method to replace the cabin air filter is: 1. First, remove the glove compartment on the passenger side. 2. Then, you can see the cover of the cabin air filter. 3. Open the cover to take out the cabin air filter. 4. Reinstall it by following the reverse steps. Additional information: 1. The cabin air filter is a very important component in a car and needs to be replaced regularly. 2. If the cabin air filter is not replaced for a long time, it will affect the performance of the air conditioning system and the health of the passengers inside the car.
5
5
Share

How to reset the maintenance light on Chery Flagcloud 1?

The method to reset the maintenance light on Chery Flagcloud 1 is: 1. Turn on the ignition switch, press and hold the reset button with one hand while turning off the ignition switch with the other hand; 2. Keep holding the reset button until the clock and mileage on the dashboard disappear, then release the button; 3. Press and hold the reset button again, then turn on the ignition switch; 4. Continue holding the reset button until the maintenance reminder stops flashing, then release the button. Taking the 2012 Chery Flagcloud 1 as an example, it belongs to the microcar category with body dimensions of: length 4150mm, width 1640mm, height 1535mm, wheelbase 2340mm, fuel tank capacity 45l, and curb weight 990kg.
11
2
Share

What is the RPM of a Honda CR-V at 120 km/h?

Lower on downhill roads, higher on uphill roads. Around 2000 RPM on flat roads. Introduction to Gear Ratio: Automotive transmission ratio, also known as gear ratio, refers to the ratio of rotational speeds between two transmission mechanisms before and after the gearbox in a vehicle's drivetrain. There are two types of gear ratios in a vehicle's drivetrain: the final drive ratio and the gearbox ratio. For the same vehicle model, the final drive ratio is a fixed value, and gear ratio data for various types of vehicles can be found in automotive performance manuals. Comparison of Gear Ratios: Different gears in the transmission have different gear ratios, and the final drive gear ratios in differentials also vary between different vehicles. A higher gear ratio results in slower speed but greater torque, while a lower gear ratio results in higher speed but reduced torque.
17
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.