Is a 13-year-old car still exempt from inspection in 2019?

1 Answers
SanChase
07/24/25 12:24pm
A 13-year-old car in 2019 needs to undergo an inspection at the testing station, as new cars are exempt from inspection for the first six years. Here is the relevant information: 1. During the annual inspection, the car must go through the testing station, where professional staff and equipment are responsible for checking the vehicle. The inspection includes testing exhaust emissions, the lighting system, the braking system, the chassis, and the exterior. 2. If the exterior has been modified, the car will not pass the inspection. Therefore, avoid making unauthorized modifications to your vehicle during regular use. 3. Before the annual inspection, check the car's lighting system in advance. If any lights are damaged, repair them beforehand to avoid complications. 4. If the car has not been serviced for a long time, consider getting it serviced before the inspection. During regular use, avoid using low-quality gasoline, as it can lead to increased carbon deposits in the engine, which is harmful to the engine.
Was this review help?
6
5
Share
More Forum Discussions

How to Disassemble the Cruze Key?

The method to disassemble the Cruze key is: 1. Press the button on the side of the remote key and pull out the mechanical key from the housing; 2. Insert a flat-blade screwdriver into the middle of the contact port, turn the screwdriver, and pry open the back cover of the key. Be careful not to touch the circuit board or battery terminals during disassembly. The Cruze is a compact 4-door 5-seater sedan under SAIC-GM Chevrolet, with a length, width, and height of 4666mm, 1807mm, and 1460mm respectively, a wheelbase of 2700mm, equipped with a 6-speed manual transmission, a top speed of 185 km/h, and an engine with a maximum power of 84kw and a maximum torque of 146nm.
19
4
Share

Does the Sylphy have a headlight washer function?

The Sylphy is equipped with a headlight washer function. The headlight cleaning device features a water outlet located below the headlights, allowing for the removal of dust and dirt from the headlights at any time. The Sylphy utilizes a MacPherson strut independent suspension in the front and a torsion beam non-independent suspension in the rear. It is powered by a 1.6L naturally aspirated engine, delivering a maximum horsepower of 122 PS, a maximum torque of 155 Nm, and a maximum power output of 90 kW. The engine is paired with a 5-speed manual transmission. The Sylphy measures 4631 mm in length, 1760 mm in width, and 1503 mm in height, with a wheelbase of 2700 mm. It has a fuel tank capacity of 50 liters and a top speed of 186 km/h.
16
2
Share

What are the causes of cylinder head gasket wear?

There are several causes of cylinder head gasket wear: 1. Elongation or loosening of cylinder head bolts and nuts; 2. Deformation of the mating surfaces between the cylinder head and engine block. If these two surfaces are deformed, the cylinder head gasket cannot be evenly compressed, leading to gas leakage and subsequent gasket burning; 3. Dirty mating surfaces during installation, incorrect tightening sequence of cylinder head bolts and nuts, insufficient or uneven torque. Methods to prevent cylinder head gasket wear include: 1. Strictly inspect the flatness of both mating surfaces (cylinder head and engine block) before installation; 2. Check whether the quality of the cylinder head gasket meets standards; 3. During installation, tighten bolts and nuts evenly according to requirements and achieve the specified torque.
15
4
Share

How to clear the 'Check Vehicle Condition Immediately' prompt on the new Sagitar?

The method to clear the 'Check Vehicle Condition Immediately' prompt on the new Sagitar is: turn on the hazard lights, then press the button on the right side of the odometer, and finally press the OK button on the multifunction steering wheel. The new Sagitar is a compact sedan equipped with a 1.2L turbocharged engine and a 1.4L turbocharged engine, with a maximum power of 85kW and a maximum torque of 175Nm, paired with a 5-speed manual transmission. The dimensions of the new Sagitar are 4753mm in length, 1800mm in width, and 1462mm in height, with a wheelbase of 2731mm. It features a MacPherson independent front suspension and a multi-link independent rear suspension.
4
3
Share

What type of battery does the BYD e2 use?

The BYD e2 uses a ternary lithium battery. The dimensions of the BYD e2 are 4240mm in length, 1760mm in width, and 1530mm in height, with a wheelbase of 2610mm. It features a MacPherson independent front suspension and a torsion beam non-independent rear suspension. The vehicle is equipped with a permanent magnet motor, delivering a maximum horsepower of 96ps, a maximum power of 70kw, and a maximum torque of 180nm. It is paired with a single-speed fixed gear ratio transmission. The BYD e2 is a compact 5-door, 5-seat hatchback with front-wheel drive. It comes with 205/60R16 tires and features such as tire pressure monitoring, driver seat belt reminder, traction control, brake assist, and rear radar.
3
5
Share

How many three-cylinder cars does Geely have?

Geely has 7 three-cylinder car models, namely Binyue, Emgrand GS, Emgrand GL, Xingyue, Jiayue, Binrui, and Vision X1. Taking the Geely Binyue as an example: it uses a MacPherson independent suspension at the front and a torsion beam non-independent suspension at the rear. It is equipped with a 1.4L inline 4-cylinder turbocharged engine, delivering a maximum horsepower of 141ps, maximum power of 104kw, and maximum torque of 235nm, paired with a 6-speed manual transmission. The Geely Binyue has dimensions of 4330mm in length, 1800mm in width, and 1609mm in height, with a wheelbase of 2600mm, a fuel tank capacity of 45L, tire specifications of 215/60R17, and a front-wheel drive system.
2
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.