Is 7 liters per 100 kilometers high?

1 Answers
DeHope
07/29/25 8:09pm
7 liters per 100 kilometers is not high. Here are the specific factors affecting fuel consumption: 1. Vehicle condition: In addition to regular cleaning, it's important to maintain the vehicle's condition with timely repairs and periodic maintenance. 2. Driving habits: Poor driving habits can waste fuel, such as carrying unnecessary weight, driving with windows open at high speeds, and sudden acceleration or deceleration, all of which increase fuel consumption. 3. Road conditions: Driving in urban areas can increase fuel consumption by 20% compared to test tracks, mainly due to frequent starts, stops at traffic lights, and gear shifting for acceleration and deceleration.
Was this review help?
16
5
Share
More Forum Discussions

What Happens When a Truck's Beidou Positioning System Malfunctions?

Truck Beidou positioning abnormalities generally have two outcomes: The first is going offline. If offline, it is recommended to contact the service provider to check whether the annual fee has been paid normally. The second situation is when the time is correct but the positioning location is wrong. In this case, it is usually because the Beidou recorder cannot position normally. It is recommended to purchase a GPS Beidou satellite antenna for replacement. Below is related content introduction: 1. If the Beidou time on the truck is incorrect, it may be due to a software issue. You can report this to the relevant department and request their assistance in resolving the problem. 2. The commonly used positioning and navigation for trucks relies on SIM card signals for network positioning. If there is no mobile signal, the GPS signal may become weak or unavailable.
8
5
Share

Is the first maintenance within three months or can it be exceeded?

Different brands and models of cars have different first maintenance periods. Some models require the first maintenance to be done within three months, while others require it within six months. Here is an introduction to the first maintenance of a car: 1. The first maintenance of a car is the initial mandatory maintenance after the car leaves the factory. 2. In China, except for imported models, the first maintenance for domestic and joint-venture models is generally free. 3. Different brands and models may have different requirements, but most of them require the first maintenance to be done within 3,000 to 5,000 kilometers or three to six months. When choosing the time and mileage for the first maintenance, try not to exceed the specified time or mileage. Otherwise, you may have to pay for the first maintenance yourself due to exceeding the time or mileage.
17
3
Share

What is the solution when there is no windshield washer fluid in the car?

The solution when there is no windshield washer fluid in the car is to add windshield washer fluid. The method for adding windshield washer fluid is as follows: 1. Turn on the wiper switch to spray the windshield washer fluid from below the front windshield. 2. Continue until the spray nozzles no longer spray fluid, then open the windshield washer fluid filler cap and add a small amount of windshield washer fluid. 3. Turn on the wiper switch again to clear out any remaining windshield washer fluid. 4. When the spray nozzles no longer spray fluid the second time, add windshield washer fluid, then securely close the filler cap. The functions of windshield washer fluid are as follows: 1. Clean debris from the windshield. 2. Lower the freezing point of the liquid. 3. Ensure the windshield remains clear and transparent, providing a clear field of vision.
19
5
Share

How Often Should Shock Absorber Top Mounts Be Replaced?

Shock absorber top mounts do not have a fixed replacement interval. Replacement is necessary if the following failure symptoms occur: 1. Abnormal noises: When severely worn or damaged, the vehicle's shock absorbers will produce unusual sounds during operation. 2. Steering deviation: Damaged top mounts may cause slight steering misalignment, difficulty in returning to center position, and reduced return force. 3. Increased noise: Without the cushioning effect of intact top mounts, the shock absorbers will directly transmit all absorbed vibrations and impacts to the vehicle cabin through the frame. 4. Steering noise when stationary: Even when the shock absorbers are not in motion, excessive wear or damage to the top mounts can cause very noticeable abnormal sounds when turning the steering wheel while stationary.
19
1
Share

The Difference Between 5S Stores and 4S Stores?

Automobile 4S stores and 5S stores mainly differ in their business models. The detailed introduction is as follows: A 4S store is a sales outlet that integrates automobile sales, maintenance, parts, and information services. The 4S store is a car franchise model centered on the "four-in-one" concept, including vehicle sales (Sale), spare parts (Sparepart), after-sales service (Service), and information feedback (Survey). 5S includes: vehicle sales (sales), spare parts sales and promotion (spareparts), system information feedback (System-of-information-feed-back), maintenance and repair (service), and used car transactions (second-hand). A 5S store is a business model that combines the above five main elements.
9
2
Share

What Causes the Clicking Sound in a Motorcycle Chain?

Reasons and solutions for the clicking sound in a motorcycle chain: 1. Poor fit between the chain and sprocket: When the chain and sprocket do not fit well, abnormal noise may occur while riding. This issue cannot be adjusted by oneself and requires replacing the entire chain and sprocket set. Professional assistance is needed in such cases. 2. Insufficient lubrication of the motorcycle chain: If inspection reveals insufficient lubrication, it is necessary to add lubricating oil. 3. A stuck section in the chain: When a part of the chain is stuck, abnormal noise will inevitably occur while riding. The rider should promptly inspect and clean it to avoid the chain coming off during the ride. Maintenance tips for motorcycle chains are as follows: 1. Regularly clean the motorcycle chain during routine rides. After cleaning, apply specialized lubricating oil to the chain. 2. Ensure the purchased motorcycle chain has quality assurance, preferably choosing original factory parts.
7
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.