Is 55b24l more durable than 46b24l?

1 Answers
VanConnor
07/30/25 6:29am
46B24L is 45 ampere-hour, and 55B24L is also 45 ampere-hour. The difference between 46B and 55B lies in the cold cranking current, which is higher for 55B. Therefore, it is better to choose 55B in colder northern regions, while in the south, either option is acceptable. The number 46 represents the performance parameter of the battery; the larger the number, the more electricity the battery can store. B denotes the width and height code of the battery. The combination of width and height is represented by one of eight letters (A to H), with letters closer to H indicating larger width and height values. 24 indicates that the length of the battery is approximately 24 cm. L indicates the position of the positive terminal; when viewed from the side away from the battery terminals, R denotes the positive terminal on the right end, and L denotes the positive terminal on the left end.
Was this review help?
20
1
Share
More Forum Discussions

How to Maintain Your Car in Winter?

Winter car maintenance methods are introduced as follows: 1. Wiper Blades and Windshield: Due to weather conditions, wiper blades often freeze to the windshield in winter. Do not force them off; instead, turn on the car's air conditioning, set it to blow air towards the windshield to raise its temperature. This also helps check if the heating system is functioning properly. Regularly clean the heating system to ensure good air quality inside the car. 2. Body and Chassis: The car's exterior inevitably gets damaged while driving, or even when parked. In winter, with rain and snow, the car's exterior is prone to corrosion. Roads are often salted to quickly melt snow, and the tires can splash saltwater onto the chassis, causing rust. Therefore, before winter arrives, thoroughly inspect the car's body, promptly repair any scratches, and apply wax in early winter to protect the paint. A waxed body is less likely to get damp, and ice formation on the car's surface will be significantly reduced. Also, perform rust-proof maintenance on the vehicle's chassis to extend its lifespan.
2
1
Share

Where is the child lock on the Audi A4?

Audi A4 child lock is located above the rear door lock mechanisms. Additional information: 1. Use the mechanical key from the remote key to insert into the lock hole, then rotate the key in the direction of the arrow above the lock hole to activate the child lock. Rotate the key in the opposite direction of the arrow to deactivate the child lock function. When the child lock is activated, even if the central door lock is in the open state, the door cannot be opened from inside the vehicle and can only be opened from the outside door handle; 2. There is also a child safety feature at the central window control button on the driver's side door panel. Pressing this button will illuminate the indicator light in the button, deactivating the rear door window switch and preventing rear passengers from controlling the window operation via the rear door switches. When children are seated in the rear, the window lock switch should be pressed promptly.
14
0
Share

What Are the Reasons for the ETC Barrier Not Lifting When Entering the Highway?

Reasons for the ETC barrier not lifting when entering the highway include detachment or removal of the ETC device; ETC device malfunction; lane malfunction; pass card malfunction; or being blacklisted. In such cases, it is necessary to promptly contact on-site staff for assistance. How ETC Works: Through dedicated short-range communication between the onboard electronic tag installed on the vehicle's windshield and the microwave antenna in the ETC lane at the toll station, computer networking technology is used to perform backend settlement processing with the bank. This allows vehicles to pass through highway or bridge toll stations without stopping while still paying the toll. ETC Usage Notes: The ETC transaction sensing range is 8 meters. When encountering a vehicle in front that has stopped, to prevent the front vehicle's ETC device from malfunctioning or not having an ETC device at all, maintain a distance of more than 10 meters to avoid automatic sensing and payment for the front vehicle. The ETC lane recognition speed is 20 km/h. If the vehicle speed is too fast, the vehicle device information cannot be read, which will also result in payment failure. Unauthorized removal or movement of the OBU device, detachment or loosening of the ETC electronic tag, etc., will cause the electronic tag to fail. It can be sent to the bank where the ETC card was issued or the highway service office for testing. Non-deliberate loosening or detachment only requires reactivation. When using a debit card linked to ETC, insufficient balance will also cause payment failure. Follow the guidance of on-site staff to use the manual MTC lane and pass by cash or card. Excessive thickness of the car windshield can cause poor sensing. This is especially important for vehicles that have had their windshields replaced after an accident or for those who have modified their front windshields.
4
5
Share

Do You Need to Replace Coolant in Hot Weather?

Hot weather does not necessitate coolant replacement, as coolant change is not related to weather conditions. For vehicles that operate for extended periods, such as taxis, high-quality coolant should generally be replaced annually. Vehicles with shorter operating hours can have their coolant replaced every two years or every 30,000 kilometers. How to Replace Coolant: Before completely replacing the coolant, conduct a thorough inspection to check for any signs of leaks or cracks in the pipelines, with a particular focus on the five-way hose. Coolant flows through the five-way hose and is then distributed to different parts of the car to function. If there are any signs of coolant leakage in this area, replace the hose or resecure the connection as needed. Drain the old coolant and then flush the fluid channels with clean water. Add clean water to the coolant reservoir and continue to fill it until water flows continuously through the engine cooling system. Then, start the engine and let it idle for 3 to 5 minutes to circulate the water. Initially, the water draining from the reservoir will have a faint pink tint. Continue adding clean water until the drained water runs clear. Note: Remember to remove the heater hose and drain all water from the heater core. Approximately one hour after draining, add new coolant through the radiator hose. Then, pour another container of coolant into the coolant reservoir until it is nearly full. Start the engine and let it run for about 10 minutes. As the cooling system expels some air, the coolant level will drop slightly. Top up the coolant until it reaches the "MAXT" mark on the reservoir.
19
4
Share

Why Are Used BMW X6 Cars So Cheap?

The price of a used BMW X6 is influenced by the vehicle's condition. The age of the vehicle and the extent of wear and tear will both lower the price. Things to consider when buying a used car: 1. Check the paperwork: If the used car's paperwork is incomplete, it may prevent the car from being legally transferred. When reviewing the paperwork, check how long the compulsory traffic insurance and commercial insurance are still valid. 2. Inspect the vehicle's condition: When inspecting the vehicle's condition, it's acceptable as long as the car hasn't been involved in any major accidents. The car body consists of the frame and the body panels. The panels include the front and rear bumpers, front fenders, doors, hood, and trunk lid. The roof and rear fenders are part of the frame. If an accident only damaged the body panels, the car is not considered a salvage vehicle. However, if the accident damaged the frame, the car is classified as a salvage vehicle.
6
1
Share

Will Sidewall Cracks Cause a Tire Blowout?

When there are cracks on the tire sidewall and the cracks are relatively deep, a blowout may occur, especially during long-distance or high-speed driving. This is because the increased temperature of the tire raises the internal tire pressure, making a blowout highly likely. If the sidewall cracks are minor, driving in urban areas should generally be safe, but it is recommended to replace the tire if possible. Below is relevant information: 1. Causes of cracks: Cracks in the tire grooves are caused by natural aging of the tire. Since tires are made of rubber and operate in harsh conditions, the high-pressure air inside, combined with temperature fluctuations and sunlight exposure, leads to the degradation of the tire rubber from the inside out. Factors such as oxygen, heat, and rolling over thousands of kilometers contribute to this natural aging process over time. 2. Timeframe for crack formation: Generally, tires begin to show signs of aging after about 3 years of use, with small cracks appearing on the sidewalls, tread, or drainage grooves. Over time, or if the tire is corroded, these cracks will gradually deepen. The drainage grooves and sidewalls are particularly vulnerable, and after 5 years, the tire is usually severely aged, posing a high risk of blowouts and significant safety hazards.
10
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.