Is 4 Liters of Engine Oil Enough for the Tiggo 3?

2 Answers
StJuliette
07/28/25 6:07pm
Adding 4 liters of engine oil to Chery's Tiggo 3 is completely sufficient. In most cases, you only need to ensure the oil level is between the upper and lower marks on the engine oil dipstick. Below are specific methods for selecting engine oil for your car: 1. Performance Selection: If you prioritize long-lasting oil performance, you can choose Mobil oil; if you focus on the oil's cleaning ability for the engine, Shell lubricants are a good option; for stronger oil film toughness, Castrol is recommended. 2. Driving Conditions: If you frequently drive in congested areas, own an older vehicle, or operate heavy-duty vehicles for long-distance transport, you can appropriately increase the viscosity of the lubricant. 3. Engine Type: For naturally aspirated engines, you can use mineral oil or semi-synthetic oil. Compared to naturally aspirated engines, turbocharged engines have a more compact structure and operate under harsher conditions, requiring higher-grade lubricants with better fluidity, preferably full synthetic oil.
Was this review help?
9
1
Share
Quintero
08/11/25 11:56pm
When I used to drive a Tiggo 3, I also wondered about the right amount of engine oil to add. Adding 4 liters of oil is usually fine. The Tiggo 3 manual states the standard capacity is around 3.5 liters, so 4 liters is generally sufficient after an oil change, especially when the engine is empty. However, if the old oil wasn’t fully drained, the oil level might be slightly higher. After adding, start the engine for a few minutes and then check the dipstick—as long as it’s between the min and max marks, it’s safe. Too little oil is risky; insufficient lubrication can accelerate engine wear, cause overheating, or even lead to cylinder scoring. Checking the oil level during regular maintenance is crucial. Don’t just focus on the quantity—oil quality matters too. For the Tiggo 3, 5W-30 or 10W-40 is suitable, depending on your local climate and driving habits. In short, getting the right amount ensures smoother driving and fewer repair headaches.
Was this review help?
11
5
Share
Expand All
More Forum Discussions

Can New Energy Oil Replace Gasoline?

New energy oil can be used in cars, but it is not recommended. New energy oil is actually a type of kitchen fuel oil, primarily used for cooking in restaurants. Introduction to New Energy Oil: New energy oil is essentially methanol fuel currently used in restaurants, also known as eco-friendly oil, alcohol-based fuel, etc. There are many names for it, but the product is the same. It is mainly composed of methanol, with a small amount of additives and water blended in, forming a new type of fuel that is energy-saving, environmentally friendly, safe, and convenient compared to liquefied petroleum gas (LPG). The cost ranges from 1.3 to 1.8 per kilogram, which is half the price of LPG. Currently, it is mainly used in catering hotels, school and factory canteens, industrial boilers, drying processes, bathhouses, as well as for household and automotive purposes. Automotive Use: Most automotive applications of this fuel are speculative. The raw material is methanol, and its principle is similar to ethanol gasoline. It is best used when mixed with gasoline, as using it alone results in weaker power and may trigger the malfunction indicator lamp (MIL). The most mature applications are in kitchens and boilers, which are more reliable. For kitchen use, the burner core needs to be replaced; for industrial boilers, a special burner is required. For automotive use, it can be mixed with gasoline without requiring any modifications.
5
5
Share

Is Benelli Considered a Domestic or Joint-Venture Vehicle?

Benelli motorcycles are not domestic vehicles; Benelli is an Italian motorcycle brand. Below are specific details regarding the related content: 1. History of Benelli: Benelli was founded in 1911 in Pesaro, Italy. Initially, Benelli was just a repair shop, but it could also produce all the spare parts needed for repairs. In 1920, the company manufactured a complete single-cylinder, two-stroke 75cc engine for motorcycles. In 1921, Benelli produced its first motorcycle equipped with a self-developed 98cc engine. 2. Acquisition by a Chinese Company: In October 2005, China's Qianjiang Motorcycle successfully acquired Benelli. This marked the first time a Chinese motorcycle company acquired a renowned European motorcycle enterprise, and it was also the first instance in China's machinery industry to achieve a cross-border acquisition of a European company. This acquisition filled the gap in China's production of large-displacement high-end motorcycles and racing bikes.
13
0
Share

Will water in the motorcycle exhaust pipe enter the engine?

Water in the exhaust pipe cannot enter the engine. When the engine is off, the valves are closed, and only the exhaust pipe will be filled with water. After starting and driving a few kilometers, the water in the exhaust pipe will be expelled, and any remaining water will evaporate due to the high temperature. Here is more information about motorcycle engines: 1. Concept: A motorcycle engine converts the thermal energy generated by igniting the fuel-air mixture in the cylinder into mechanical energy, which is then transmitted to the rear wheel through the crankshaft and transmission mechanism to provide driving power. 2. Advantages: Motorcycle engines have the advantages of low inertia force, minimal vibration, and low noise.
11
2
Share

Can traffic violations be handled without the vehicle license?

Traffic violations cannot be handled without the vehicle license. According to the "Procedural Regulations for Handling Road Traffic Violations," the violator or vehicle owner must bring the following documents: original "Resident ID Card," original "Motor Vehicle Driving License" (i.e., driver's license), and original "Vehicle License." Here are ways to avoid violations: 1. Familiarize yourself with traffic regulations. 2. Master driving skills to expand your field of vision, avoid distractions, and clearly spot traffic police and speed cameras. 3. Try not to speed; you can also use safety driving systems like GPS for speed alerts. 4. Frequently check maps and familiarize yourself with routes to reduce detours. 5. Develop the habit of checking violation records online to avoid failing the annual vehicle inspection.
20
2
Share

What is the Passing Standard for Subject 2?

Subject 2 has a full score of 100 points, with evaluation criteria set for failure, deductions of 20 points, 10 points, and 5 points. The test is considered passed if the following conditions are met: ① For applicants of large buses, tractors, city buses, medium buses, and large trucks, a score of 90 or above is required; ② For other vehicle types, a score of 80 or above is required. The test items for small vehicles C1 and C2 include reversing into a garage, parallel parking, stopping and starting on a slope (canceled for C2), turning at a right angle, and driving through curves (commonly known as S-turns), which are the five mandatory test items (some regions have a sixth item: highway toll card collection). The test items for large vehicles A1, A2, A3, B1, and B2 include pile test, stopping and starting on a slope, parallel parking, driving over a single-plank bridge, driving through curves, turning at a right angle, passing through a narrow gate, driving over continuous obstacles, driving on bumpy roads, making a U-turn on a narrow road, as well as simulated highway driving, continuous sharp turns on mountainous roads, tunnels, rain (fog) conditions, slippery roads, and emergency handling. Candidates who fail the Subject 2 test on the first attempt are allowed one retest. If the candidate does not take the retest or fails the retest, the current test session is terminated, and the applicant must reschedule the test after ten days. Within the validity period of the driving skill test permit, the number of test appointments for Subject 2 and Subject 3 (road driving skills) must not exceed five. If the candidate fails the fifth test appointment, the passing scores of other subjects already taken will be invalidated.
19
2
Share

What is the horsepower of the ZS1100 diesel engine?

The ZS1100 diesel engine generally has a horsepower of 15 and above. Below is relevant information:1. The normal range of oil pressure for diesel engines: The oil pressure of a diesel engine is normally between 3 to 5 pressures, with idle speed at around 1 pressure. It should be noted that the oil pressure of diesel and gasoline engines varies depending on the specific model, so the above data is only an estimate.2. Reasons for abnormal oil pressure in diesel engines: Due to component wear, improper assembly, or other faults, diesel engines may experience low or no oil pressure. Diesel engines usually have a pressure regulating valve to adjust the oil pressure.
8
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.