Is 180 Horsepower Sufficient for Pulling Ten Tons of Cargo?

What Causes the Reversing Radar to Beep Abnormally?

There are several reasons why a car's reversing radar keeps beeping: obstruction around the radar probe, malfunction of the reversing radar control box, or damage to the probe. Obstruction around the radar probe: If a car is exposed to the elements for a long time, it is prone to accumulating dust and dirt. In northern winters, water can freeze into ice, which may also cause the reversing radar to keep beeping. Carefully inspect and remove any obstructions. Malfunction of the reversing radar control box: Electromagnetic interference or circuit issues may cause the reversing radar to keep beeping. It is recommended to take the car to a 4S shop for repair. Damage to the probe: This usually occurs after a severe collision at the rear of the car, where the probe was damaged but not detected or replaced. How the car reversing radar works: When reversing, the reversing radar uses ultrasonic waves emitted by probes mounted on the rear bumper. These waves reflect off obstacles, and the system calculates the actual distance between the car and the obstacle, then alerts the driver to make parking or reversing easier and safer. During this process, the radar probe is the component most prone to malfunction and requires attention.

2

0

Share

What is the USB-like object that comes with the Volvo S90 key?

Volvo S90 and the key comes with a USB-like object is a waterproof key. The Volvo S90 remote key is a key that utilizes the wireless remote control function of the central locking system, allowing you to remotely unlock and lock the doors without inserting the key into the keyhole. This system mainly consists of a transmitter and a receiver. It includes a transmission switch, transmission antenna, integrated circuit, etc. It contains an identification code storage circuit and an amplitude modulation circuit, with a snap-on lithium battery installed on the other side of the circuit. The transmission frequency is selected according to the radio standards of the user's country, and each button of the transmission switch sends a signal once. It achieves the basic functions of opening and closing doors like a traditional mechanical key. Lightly pressing the button on the remote can open/close the car doors, but the car still requires a mechanical key to operate. Both keys must be used together, which can be somewhat cumbersome. Combining the functions of the key and the remote into one, the active button is used to open/close the doors/start the car. The mechanical key is embedded in the remote key for emergency situations. Based on the active button, a passive working mode is added, allowing the opening/closing actions to be performed without pressing any buttons, further improving efficiency and significantly enhancing safety performance.

18

1

Share

How to Solve the Problem of Windshield Washer Not Spraying Water?

Solutions for windshield washer not spraying water: 1. If only one side of the washer has a problem: (1) Use a sewing needle, pin, or very thin steel wire to poke. (2) First spray out the remaining windshield washer fluid, then use an air gun to blow into the clogged nozzle. 2. If both sides have spraying issues, it might be due to low washer fluid, hose, filter, or motor problems. Follow these steps: (1) Check if the washer fluid is low and refill it before trying again. (2) Inspect the hose for damage or loose connections. (3) Check the motor and its wiring. Have someone operate the spray button inside the car while another person opens the engine compartment to listen for any sound from the washer motor. If the sound is very weak, the motor might be faulty. If there's no sound and the wiring is fine, it's likely a motor failure. (4) If the issue is with the washer motor itself, first check if the filter is clogged. A clogged filter can be repaired, such as by removing the hose from the nozzle side, opening the washer fluid filler port, and using an air gun to blow through the hose. The water in the washer tank will be blown out through the filler port, and any dirt on the filter will also be expelled. For other issues, it's best to consult professionals at a 4S shop.

5

4

Share

What Causes Crankshaft Oil Seal Leakage?

Crankshaft oil seal leakage can be attributed to the following reasons: 1. Failure to use non-petroleum-based lubricants: During the pressing process of the crankshaft oil seal, the absence of non-petroleum-based lubricants can lead to the oil seal becoming loose or even falling off after the engine has been in use for some time (for instance, some engine manufacturers may opt for engine oil instead of the relatively more expensive non-petroleum-based lubricants to reduce production costs). 2. Improper installation: If the parallelism between the pressing surface of the rear oil seal and the installation surface of the rear oil seal seat does not meet the technical requirements specified in the assembly drawing, the lip of the rear oil seal may experience uneven force deformation. Over time, this can cause the lip to deform or even result in the entire oil seal twisting, leading to oil seal damage and engine oil leakage. 3. Prolonged usage: Extended use of the engine can cause the rear oil seal to naturally age, developing cracks at the lip area, which results in oil leakage.

6

1

Share

What are the reasons for a car not supplying fuel and failing to start?

There are several reasons why a car may not supply fuel and fail to start: 1. Incorrect gear position: For automatic transmission cars, the gear must be in P (Park) or N (Neutral) to start. If it is in R (Reverse) or D (Drive), the car will not start. Some manual transmission cars may also fail to start if the clutch is not depressed. 2. Dead battery: This could be due to a drained battery caused by leaving the headlights on for an extended period or the battery reaching the end of its lifespan. It is generally recommended to replace the battery every 2 years. Additionally, installing aftermarket components such as xenon headlights, high-power audio systems, or DVD players can also lead to electrical issues in the car. Checking for a dead battery is simple—just press the horn. 3. Spark plugs: Often, the first component to check is the spark plug, as it is a crucial part of the car's ignition system. The ignition system is key to whether the car's engine runs or not, so the proper functioning of the spark plug directly affects the vehicle's performance and efficiency. 4. Carbon buildup: Excessive carbon buildup in the engine can also prevent the car from starting. A common solution is to drive at high speeds regularly, which helps reduce carbon deposits.

15

2

Share

Can Frequent Oil Changes Remove Sludge?

Frequent oil changes can remove sludge. The stronger the circulating capacity of the engine oil, the more it accelerates the cleaning effect. If the oil viscosity is high, the oil circulation speed slows down, reducing the number of times it passes through the filter, and it cannot promptly carry away metal wear particles, carbon particles, dust, and other impurities from the friction surfaces, resulting in poor cleaning performance. Therefore, low-viscosity oil circulates faster and provides better cleaning than high-viscosity oil. More details are as follows: 1. Causes of sludge formation: Carbonaceous substances formed after combustion, gum-like substances generated by lubricant oxidation, metal shavings from friction between parts, and contaminants mixed with water in the lubricant combine to form sludge. 2. Prolonged sludge buildup can suffocate the engine: These sludge deposits and contaminants gradually accumulate on the friction surfaces of the parts, and severe gum formation can cause piston rings to stick, preventing the engine from operating normally and even damaging components. 3. These contaminants must be cleaned from all aspects: This cleaning task is performed by the lubricating oil. Thus, the engine oil carries away contaminants from the friction surfaces and delivers them to the oil pan. When passing through the oil filter, these contaminants are trapped, while the clean oil continues its cleaning function. This cyclic process ensures the parts remain clean and operate normally.

4

1

Share

Is 180 Horsepower Sufficient for Pulling Ten Tons of Cargo?

What Causes the Reversing Radar to Beep Abnormally?

What is the USB-like object that comes with the Volvo S90 key?

How to Solve the Problem of Windshield Washer Not Spraying Water?

What Causes Crankshaft Oil Seal Leakage?

What are the reasons for a car not supplying fuel and failing to start?

Can Frequent Oil Changes Remove Sludge?

How to Remove a Wheel?

What car is the Mitsubishi license plate side-mounted on?

What brand are the tires on the 16 Emgrand?

What does it mean when a vehicle status shows as seized?