···
Log in / Register

Is 105 Degrees Celsius Normal for Magotan's Engine Oil Temperature?

4 Answers
DeJessica
07/29/25 1:25pm

An engine oil temperature of 105 degrees Celsius is normal for the Magotan. Here is relevant information: 1. Normal Temperature Range: The normal operating temperature of engine oil is generally between 70-90 degrees Celsius, with localized areas potentially being higher. However, it typically does not exceed the coolant temperature. Additionally, higher speeds can result in relatively higher temperatures, reaching around 100°-110°C. But if there is a consistent tendency to exceed 120°C, then an inspection is recommended. 2. Engine Specifications: The Magotan is equipped with a 1.8TSI engine, which perfectly combines turbocharging technology with gasoline direct injection (GDI) technology, enabling it to deliver greater power and improved torque characteristics.

Was this review help?
5
0
Share
LeilaMarie
08/14/25 3:55am

I've been driving a Magotan for several years, and an oil temperature of 105°C is considered slightly high but normal in my experience. Generally, oil temperatures between 90°C and 120°C are safe, and 105°C is common in summer or after high-speed driving, especially when the engine is under heavy load. Don’t panic if it occasionally rises to this level, but if it frequently reaches this point, you should check whether the cooling system is functioning properly—for example, whether the radiator is clogged or the fan is operating well—to prevent oil degradation from affecting lubrication. Switching to a higher-quality full synthetic oil can help lower the temperature slightly and extend engine life. Remember to test it during regular maintenance, and don’t wait until the warning light comes on to take action.

Was this review help?
12
0
Share
Expand All
DelRhett
10/10/25 3:01am

As a car owner who cares about vehicle health, I believe an oil temperature of 105°C requires attention but isn't dangerous. In most cases, this falls within the normal range of 90-120°C, but caution is needed when approaching the upper limit. Prolonged high temperatures may thin the oil, reducing its engine protection capability and increasing wear risks. I recommend minimizing prolonged idling in hot weather and avoiding excessive AC use to reduce load. Checking coolant levels and fan performance is simple yet effective, while switching to high-quality oil can significantly improve heat dissipation. During daily driving, proper RPM control is crucial to prevent overheating.

Was this review help?
5
0
Share
Expand All
VonKennedy
11/23/25 4:12am

From my daily car usage, I understand that an oil temperature of 105 degrees is usually fine. The reasonable range is between 85 and 110 degrees, so 105 is just slightly high, especially in stop-and-go city driving conditions. Oil flows faster at high temperatures, which helps with internal engine lubrication, but if it gets too high, it can lead to a drop in viscosity. As long as there's no warning light on the dashboard, there's no need to worry excessively. If necessary, clean the radiator fins to maintain good ventilation.

Was this review help?
5
1
Share
Expand All
More Forum Discussions

What is the minimum speed limit for motorcycles on highways?

Motorcycles must maintain a speed of at least 60 km/h and not exceed 80 km/h. Below are important considerations for motorcycle riding: Riders must wear safety helmets: Article 51 of the Road Traffic Safety Law stipulates: Motorcycle riders and passengers must wear safety helmets as required, especially on highways where helmets are mandatory, and carrying passengers is prohibited. Must ride in the far-right lane: Lane changes or occupying other lanes at will are prohibited. Remember not to carry bulky items, as this can compromise safety. Must possess a motorcycle license: To ride on highways, it is essential to have a motorcycle license. Note that holding other types of driver's licenses (e.g., Class A, B, or C) does not permit motorcycle riding, and doing so will result in a 12-point deduction.
20
0
Share

How to Self-Service Refuel When There's No Staff or Card at the Gas Station?

Before self-service refueling, the vehicle owner should first touch the static electricity discharger to eliminate any potential static electricity on their body, especially during dry seasons like autumn and winter. Determine the type of fuel needed, and insert the fuel card into the card slot with the front side facing up (the side with the chip is the front). If there is a password, enter it first. After inserting the fuel card, the balance on the card will be displayed on the fuel dispenser screen, allowing the owner to select the refueling mode as needed. The refueling process is not complicated: open the fuel tank cap, lift the fuel nozzle, place the nozzle into the fuel tank, then press and lock the trigger. After refueling is complete, remove the fuel nozzle and return it to its original position on the fuel dispenser.
8
0
Share

What is the tire model for the Passat Lingyu?

Passat Lingyu tire models are 205/55R16 and 215/55R16. Meaning of tire model numbers: These numbers respectively mean: 215 indicates the tire section width in mm, generally ranging between 145-285mm in 10mm increments; 70 is the aspect ratio, representing the percentage of the tire sidewall height to the tire section width, with 70 meaning 70%. Precautions for tire specification selection: The purchased tire specifications must first match the original tire specifications of the vehicle. The same axle should be equipped with tires of the same specification, structure, manufacturer, and tread pattern (with consistent load index and speed rating).
8
0
Share

Where is the fuel filler switch on the Bora?

The fuel filler cap of the Bora opens with a simple press when the car is unlocked. This model does not have a separate fuel filler cap switch; the fuel filler cap locks automatically when the car is locked. Introduction to the fuel filler cap: The fuel filler cap refers to the box on the car used for storing gasoline. It is square-shaped, made of stainless steel, and has excellent sealing. It has only a small circular opening, about the size of a bottle cap, for easy storage. It is usually located at the rear of the car. Precautions when refueling: When opening the fuel filler cap to refuel, the fuel nozzle must be correctly placed inside the fuel filler opening. Otherwise, fuel may overflow or splash out of the tank. Overflowing or splashing fuel can cause a fire and burn people. Do not enter the car while refueling. If you must enter the car, close the door and touch a metal surface before touching the fuel nozzle again to remove static electricity from your body. Otherwise, sparks may occur, which could cause a fire during refueling.
20
1
Share

What is the displacement of the Audi A6L-35TFSI?

Audi A6L-35TFSI is 30FSI, which is 2.5L, and 35FSI is 2.8L. Displacement classification: The classification of car grades in China is determined by the size of the displacement. The displacement of a micro car is less than or equal to 1.0L; the displacement of a compact car ranges from 1.0-1.6L; the displacement of a mid-size car ranges from 1.6-2.5L; the displacement of a full-size car ranges from 2.5-4.0L; the displacement of a luxury car is greater than 4.0L. Importance of engine displacement: Engine displacement is one of the most important structural parameters, which represents the size of the engine more than the bore and number of cylinders. Many indicators of the engine are closely related to the displacement. Generally, a larger displacement means the engine releases more energy (converting the chemical energy of fuel into mechanical energy) per unit time, which means better "power performance." It's like comparing a teenage boy to a healthy adult—the adult is naturally more efficient at physical labor. Therefore, off-road vehicles and sports cars usually have relatively large displacements.
18
1
Share

What is the transmission brand of the Geely Vision X6 Pro?

Geely Vision X6 Pro's 6AT transmission brand is Xuanyu Transmission, a subsidiary brand of Geely. Other transmission brands: Transmission brands include ZF, Powertrain, Aisin, Jatco, DSI, Getrag, Allison, Dymos, and GM Transmission. Aisin Transmission: Japan's Aisin is a company specializing in the production of automatic transmissions, established in 1969. Aisin's automatic transmission product lineup is very extensive, covering 4-speed, 5-speed, 6-speed, and 8-speed transmissions. Many Japanese cars, such as Toyota, mostly use Aisin transmissions, and their product quality and performance are well-known to many who have driven Japanese cars.
16
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.