In the simulated lighting test for Subject 3, do you need to switch back to low beam before turning off the high beam?
3 Answers
After completing the simulated lighting test for Subject 3, there is no need to switch off the high beam before turning off the low beam. You can directly turn off the lights. Below are the key operational points for the simulated lighting test: Check the headlight status: Before the test begins, ensure that the headlights are in the low beam state when turned on, and make sure all lights are in the off position. After alternating between high and low beams: After alternating between high and low beams, ensure the lights remain in the low beam state; otherwise, it will be considered a failure. Same operation: If the previous voice command operation is the same as the next one, remain unchanged. For example, if two consecutive operations require turning on the low beam, stay still and wait for the next voice command. No premature response: You must perform the operation within 5 seconds after the voice command is completed. Do not respond prematurely to avoid mistakes or misjudgments, nor delay beyond the time limit.
When I took the lighting test for the third driving test subject back then, I paid special attention to this issue. The examiner strictly emphasized the standard procedure: after turning on the high beams, you must first switch back to the low beam position before turning off the main light switch. Directly turning off the lights might be considered unsafe operation and result in point deductions, because suddenly turning off high beams would make the light disappear instantly, which could easily cause glare or blurred vision for oncoming vehicles during night driving. This is not only a test requirement but also a key aspect of actual driving safety. Recalling the test scenario, simulated lighting operations include manipulating the light lever in a simulator or real vehicle. Beginners should practice multiple times to develop this habit, which can improve the pass rate. I've been doing this consistently since passing my test to ensure smooth light transitions and reduce dangerous situations.
I just passed my driving test not long ago, and the simulated lighting section was the most nerve-wracking part for me. The instructor repeatedly emphasized: once you use the high beams, you must first switch back to the low beams before turning off the main switch. Turning off the lights directly is considered an error in the exam and may directly lead to failure, as it overlooks safety considerations, such as avoiding sudden strong light stimulation for oncoming drivers. During practice, I would simulate the action on the light lever on the left side of the steering wheel, gently pushing it back to the low beam position before turning off the lights, which felt easier to master. The exam also involves the speed and accuracy of light responses, and practicing this detail more can help new drivers develop good habits, ensuring no misunderstandings of intentions in real driving situations.
