If I didn't pay or take the test, does it mean I'm not enrolled in driver's license registration?

2 Answers
LeEzra
08/27/25 8:42am
If you have made an appointment, you must take the test; if not, you can simply cancel the registration. The full name of a driver's license is a motor vehicle driving license, also known as a "driver's license," which is a certificate required by law for motor vehicle drivers. Currently, obtaining a driver's license involves four subjects. The content and passing standards for these subjects are uniformly set nationwide, and the examination sequence follows Subject 1, Subject 2, Subject 3, and Subject 4 in order. Only after passing the previous subject can you proceed to the next. Below are the examination contents for each subject: 1. Subject 1 examination content: Mainly tests basic knowledge such as road traffic safety laws and regulations, traffic signals and their meanings, and traffic rules. 2. Subject 2 examination content: Five mandatory items—reverse parking, parallel parking, stopping and starting on a slope, turning at a right angle, and driving along a curve—are tested, with additional items in some regions. 3. Subject 3 examination content: Includes 16 driving skills such as vehicle preparation, starting, driving straight, gear shifting, changing lanes, pulling over, going straight through intersections, turning left and right at intersections, crossing pedestrian crossings, passing school zones and bus stops, meeting oncoming vehicles, overtaking, making U-turns, and simulating lighting conditions. 4. Subject 4 examination content: Mainly includes safe and civilized driving requirements, safe driving knowledge under adverse weather and complex road conditions, emergency handling methods for situations like tire blowouts, and post-accident handling knowledge. Like Subject 1, it is a theoretical test.
Was this review help?
6
3
Share
SanAngelo
09/09/25 7:20am
From the perspective of the driver's license application process, if you've only filled out the registration form without paying any fees or taking any exams, it doesn't count as an official registration. The registration typically involves three essential steps: submitting required documents, paying the fees, and taking the exams—none of these can be skipped. I once helped a friend with a similar situation and found that while the driving school system might retain your information, unpaid applications go into a pending status and eventually expire if left unattended for too long. You should promptly contact your local driving school or traffic department to re-submit the form and complete the payment. Remember, exams are the core part of driver training—without them, the registration is meaningless and may delay your subsequent learning progress. It's advisable not to procrastinate; address this early to avoid disrupting your driving plans. Safe driving starts with building a solid foundation.
Was this review help?
2
1
Share
Expand All
More Forum Discussions

How to Restart After Stalling a Manual Transmission Car?

After stalling a manual transmission car, quickly pull up the handbrake, shift to neutral, and turn the key to the off position. Press the clutch with your left foot (some cars require the clutch to be pressed to start the engine), and place your right foot on the brake pedal (it cannot be pressed down at this time). Use the key to start the engine, press the brake, release the handbrake, shift into gear, release the clutch, and start moving.
12
4
Share

What is the safest method for running battery cables into the cabin?

Route the cables from the firewall near the co-pilot's air filter to the engine bay, cover with heat shrink tubing and corrugated conduit, connect to a circuit breaker and fuse holder, then to the positive terminal. Inside the cabin, connect to a relay, control the relay switch, run the cables along the plastic housing of the co-pilot's footwell to the co-pilot's seat, and connect the wiring to the co-pilot's seat. Connect the positive and negative 16-gauge power cables to a two-in-one-out splitter, then connect the original power cables from the thick padding of the center armrest to the splitter to complete the wiring.
8
1
Share

How to Solve Abnormal Speed Signal in Auman Trucks?

You can inspect the vehicle speed sensor and its wiring harness. The speed sensor is usually installed on the transmission housing. Check for issues such as loose or corroded connectors, broken wires, etc. Perform repairs or replacements. You can also visit an auto repair shop to have a technician resolve the issue.
14
2
Share

How to Handle Small Car Paint Scratches?

After noticing the scratched area on the car paint, observe whether it is located on the front bumper, rear bumper, or other parts of the vehicle. Generally, the front bumper, rear bumper, and fuel tank cover of a car are made of plastic, and the paint layer is relatively thin. If the scratch is minor and you don't want to go for professional repair, you can purchase a touch-up paint pen to handle it. However, if the scratch is on metallic or pearl paint, it is necessary to go to a 4S shop for a spray paint treatment. Typically, 4S shops perform spray painting on the entire panel.
9
1
Share

What transmission does the Touran use?

The Touran is equipped with a 7-speed dual-clutch transmission. This model series uses a 1.4-liter turbocharged engine across all variants, and the dual-clutch transmission is particularly well-suited for pairing with small-displacement turbocharged engines. The dual-clutch transmission is currently a highly popular type of transmission, developed based on manual transmissions. Its structure is quite similar to that of a manual transmission, with the main difference being that the dual-clutch transmission has one additional clutch and an extra set of gear-shifting control mechanisms. In a dual-clutch transmission, one clutch controls the even-numbered gears, while the other clutch manages the odd-numbered gears. This type of transmission connects to the engine via clutch plates, resulting in relatively high transmission efficiency.
5
5
Share

How to Remove the Passenger Side Glove Box of Baojun 730?

Removing the passenger side glove box of the Baojun 730 is very simple. During the removal process, you need to apply force to both sides of the glove box and then pull it outward directly to detach it. The Baojun 730 is a family MPV product under SAIC-GM-Wuling Baojun, with body dimensions of 4780mm in length, 1820mm in width, and 1755mm in height. The Baojun 730 is an MPV model equipped with two engines: one is a 1.5-liter naturally aspirated engine, and the other is a 1.5-liter turbocharged engine. The front suspension of the Baojun 730 is a MacPherson independent suspension, and the rear suspension is a multi-link independent suspension.
2
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.