How to Use Zotye Cruise Control?

How Often Should Brake Fluid Be Changed in a Car?

Brake fluid should be changed every two years in a car. The functions of brake fluid include transmitting energy, dissipating heat, preventing corrosion and rust, as well as lubrication. Its characteristics are: 1. Good viscosity-temperature performance, low freezing point, and excellent low-temperature fluidity; 2. High boiling point, no vapor lock at high temperatures; 3. Minimal quality changes, causing no corrosion or deterioration to metal and rubber components. The method for changing brake fluid is: 1. Position the vehicle over an inspection pit or lift it with a jack; 2. Clean the drain port, remove the dust cap, unscrew the drain screw, repeatedly press the brake pedal until the fluid runs clear, then tighten the drain screw; 3. Add new brake fluid.

10

0

Share

How to switch between D gear and S gear?

D gear and S gear can be switched directly. Both D gear and S gear are automatic transmission gears. The gears of an automatic transmission include: 1. P gear (Parking/Starting gear); 2. R gear (Reverse gear); 3. N gear (Neutral gear); 4. D gear (Drive gear); 5. L gear (Low gear); 6. S gear (Sport mode); 7. OD gear (Overdrive gear). The correct way to use an automatic transmission is: 1. Start the vehicle in P or N gear. Remove the gear lever from P gear while pressing the brake, turn on the power, press the brake, shift to N gear, and after ignition, shift to D gear to move forward directly; 2. When switching between N, D, and L gears, there is no need to press the shift button. When shifting from L gear to lower restricted gears, press the shift button. When shifting from lower to higher gears, there is no need to press the shift button; 3. Do not shift into N gear while driving to coast; 4. Do not push into P gear while driving; 5. After driving, the vehicle must be turned off and shifted into P gear before the key can be removed.

8

5

Share

What to Do When the ETC Falls Off?

If the ETC falls off, you need to go to the local customer service center to reactivate it. ETC is an electronic toll collection system that allows vehicles to pass through toll stations without stopping. It uses onboard equipment to identify the vehicle, record information, and automatically deduct the corresponding funds from a pre-linked bank account. It is an electronic toll collection system being actively developed and promoted internationally for use on roads, bridges, and tunnels. The installation method for ETC is as follows: 1. Check the ETC card and electronic tag for any damage. Press the anti-tamper button on the back of the electronic tag, and the red light will briefly illuminate. If the OLED screen displays 'Tag Invalid, Please Insert Card,' it indicates the device is functioning properly. 2. Clean the front windshield, peel off the protective film of the electronic tag, and stick it to the installation position, pressing firmly for about 2 to 3 minutes. 3. Insert the ETC card with the front facing the driver and the back facing the windshield, placing the chip into the electronic tag device.

17

0

Share

What brand is Kumho car tire?

Kumho car tire is a brand under Kumho, which is a South Korean car tire brand. Precautions for tires include: 1. Conduct thorough inspections; 2. Observe the tire sidewalls for cracks and check the tread wear condition, and promptly address any potential hazards; 3. Regularly adjust wheel balance; 4. Periodically rotate tires to ensure even wear. The functions of car tires are: 1. Transmit driving force, braking force, and steering force to enable vehicle operation; 2. Support vehicle load; 3. Reduce and absorb vibrations and impact forces during driving, preventing severe vibrations from damaging car components.

18

0

Share

How to Cancel the Auto Start-Stop Function on Malibu XL?

To cancel the auto start-stop function on Malibu XL, follow these steps: 1. Start the car and long-press the auto start-stop switch; 2. Click the set button on the left multifunction steering wheel until you hear a beep; 3. Press the OK button on the right multifunction steering wheel. The auto start-stop function refers to a system that automatically turns off the engine when the vehicle comes to a temporary stop during driving and restarts it when you continue moving. Precautions for using the auto start-stop function include: 1. Quickly shift to P gear and release the brake when the engine stops; 2. Reduce current consumption; 3. Avoid repeatedly pressing the brake when the engine is off; 4. Wait for the engine speed to drop to zero before engaging the starter gear for restart; 5. Do not activate the auto start-stop system during low-speed parking or when using the air conditioning.

11

3

Share

How many seconds does the Haval H9 take to accelerate from 0 to 100 km/h?

Haval H9's 0-100km/h acceleration time is 9.53 seconds. Below are relevant details about the 0-100km/h acceleration: Transmission self-protection: During initial acceleration, the Haval H7's dual-clutch transmission engages in self-protection, releasing full power after approximately half a second. This results in slight front-wheel slippage, with a final 0-100km/h acceleration time of exactly 9 seconds. Smooth start: The engine speed is limited to 2200rpm during initial acceleration, resulting in a relatively gentle start. The tires experience only minimal slippage before regaining traction. The tachometer's redline is at 5500rpm, and the transmission upshifts at 5000rpm.

16

1

Share

How to Use Zotye Cruise Control?

How Often Should Brake Fluid Be Changed in a Car?

How to switch between D gear and S gear?

What to Do When the ETC Falls Off?

What brand is Kumho car tire?

How to Cancel the Auto Start-Stop Function on Malibu XL?

How many seconds does the Haval H9 take to accelerate from 0 to 100 km/h?

How to Open the Toyota Hood?

What are the specifications of the Toyota Prado 2700?

How to Open the Front Hood of Great Wall Haval H6?

What is the emergency rescue phone number on the highway?