How to Use the Vezel Electronic Parking Brake?

Why Won't the Car Starter Work?

The reasons why a car won't start include running out of fuel, a faulty crankshaft position sensor, starter motor failure, a dead battery, or excessive carbon buildup. Running out of fuel: The fuel level is very low, or the fuel gauge shows it's below the red line. Don't wait until the tank is empty to refuel, as this not only affects the engine's lifespan but also the fuel pump's lifespan. Operating the fuel pump without fuel can even be dangerous. Crankshaft position sensor failure: The crankshaft position sensor is one of the most important sensors in an electronically fuel-injected engine, especially in centralized control systems. It is also a shared sensor for the ignition and fuel injection systems. Its function is to monitor the crankshaft position, allowing the engine control unit (ECU) to detect the speed signal. If the crankshaft position sensor fails, the ECU cannot detect the speed signal and thus cannot determine whether to ignite, resulting in the car not starting. Starter motor: First, even though the ignition switch is pressed and the starter motor is spinning at high speed, the engine shows no response. This usually indicates a problem with the starter motor. The DC motor may output kinetic energy, but the transmission mechanism fails to transfer this energy to the engine via the drive gear, often due to wear on the drive gear. Second, pressing the ignition switch doesn't even make the starter motor move. This is typically due to wiring issues, such as a burned-out power supply line from the battery or a faulty starter relay. Dead battery: A car battery can die due to prolonged inactivity, reaching the end of its lifespan, a damaged alternator, insufficient or leaking electrolyte, a blown fuse, corroded battery terminals, or overuse. Additionally, installing aftermarket components like xenon headlights, high-power audio systems, or DVD players can also cause electrical circuit failures. Checking for a dead battery is simple—just press the horn to see if it works. Excessive carbon buildup: Too much carbon buildup can lead to poor spark plug ignition, leaky valves, or inefficient fuel injector operation, causing misfires, sluggish acceleration, engine shaking, or even failure to start. Excessive carbon buildup in the throttle body can block airflow, preventing combustion. If the car won't start due to throttle body carbon buildup, try gently pressing the accelerator—this might help the engine start smoothly.

14

0

Share

What is the cause of fault code C0045?

C0045 fault code indicates an error in the brake pressure sensor B. The issue with the left rear wheel speed sensor could be due to a sensor malfunction, or it might be caused by connector corrosion, loose wiring, or other circuit-related faults. More relevant information is as follows: 1. The Dynamic Brake Control (DBC) system enhances braking effectiveness during emergency braking situations. The brake pressure sensor records the magnitude and speed of changes in brake pressure and transmits these values to the DBC unit. The control unit compares the received information with its stored activation thresholds. DBC is only activated when predefined conditions are met. 2. The dynamic braking system consists of dynamic braking resistors that shorten the mechanical feed distance of the servo motor through energy consumption braking during faults, emergency stops, or power outages. In emergencies, if the brake pedal is pressed quickly and forcefully without a real increase in braking pressure, the Dynamic Brake Control (DBC) immediately generates maximum braking pressure to bring the vehicle to a rapid stop. 3. Even if the driver fails to apply appropriate force to the brake pedal, DBC ensures that the braking distance is minimized. The DBC control unit adjusts the braking pressure according to the vehicle's current speed and the wear level of the brakes. Additionally, the DBC computer collaborates with other chassis control systems in the vehicle, such as the Dynamic Stability Control (DSC) and the Anti-lock Braking System (ABS), to ensure the highest level of driving safety.

17

2

Share

Is the BYD Qin Pro compliant with China's National VI emission standard?

BYD Qin Pro complies with the China National VI emission standard. The China National VI emission standard was established to implement the "Environmental Protection Law of the People's Republic of China" and the "Air Pollution Prevention and Control Law of the People's Republic of China". It aims to prevent environmental pollution caused by exhaust emissions from compression-ignition engines and gas-fired spark-ignition engines, protect the natural ecological environment, and safeguard public health. The BYD Qin Pro is a compact car with the following dimensions: length 4765 mm, width 1837 mm, height 1500 mm, and a wheelbase of 2718 mm. Its body structure is a 4-door, 5-seater sedan with a fuel tank capacity of 50 liters and a trunk capacity of 500 liters.

11

3

Share

What is the Difference Between Diesel Engine Oil and Gasoline Engine Oil?

Diesel engine oil and gasoline engine oil differ in heat resistance, viscosity, and additive requirements. Heat Resistance: Diesel engine oil is more heat-resistant than gasoline engine oil. The operating temperature in a diesel engine's crankcase is 20 degrees Celsius higher than that of a gasoline engine, and the piston crown and piston ring area can exceed 50 degrees Celsius higher. Typically, the piston crown temperature in a diesel engine ranges between 200-330 degrees Celsius, while gasoline engines do not exceed 200 degrees Celsius. Therefore, diesel engine oil is less prone to evaporation at high temperatures. Viscosity: Diesel engine oil has higher viscosity than gasoline engine oil. The compression ratio of a diesel engine is twice that of a gasoline engine, generally ranging from 12-22. The main components of a diesel engine endure much higher thermal and pressure impacts compared to a gasoline engine, with loads on the crankshaft bearings reaching 100-200 kg/cm². The extreme pressure can easily squeeze the oil out from between friction surfaces, making the viscosity and lubricity requirements for diesel engine oil stricter than those for gasoline engine oil. If gasoline engine oil is used, the oil film on the crankshaft and connecting rod bearings can easily rupture, leading to lubrication failure and dry friction. Additive Requirements: Diesel engine oil requires higher additive standards. Gasoline engines use Babbitt alloy for bearing materials due to its excellent corrosion resistance. However, diesel engines, which must handle higher bearing loads, temperatures, and faster sliding speeds between friction pairs, use high-performance materials like lead bronze or lead alloys for main and connecting rod bearings. These materials have poorer corrosion resistance, so diesel engine oil contains more anti-corrosion additives to enhance corrosion and wear resistance. Gasoline engine oil lacks these additives, and if used in a diesel engine, the bearings may develop spots, pitting, or even flaking, while the oil quickly becomes contaminated, leading to bearing seizure and other failures.

17

2

Share

How many days in advance can I renew my driver's license before it expires?

You can renew your driver's license three months in advance before it expires. Here are other important notes about it: When your driver's license is about to expire, you must renew it in advance. Otherwise, your license will be in an abnormal status, and if you continue to drive, you will face charges of driving without a license. If the renewal period is exceeded by more than one year: According to the "Regulations on the Administration of Motor Vehicle Driver's Licenses of the People's Republic of China," if the renewal period is exceeded by more than one year, the vehicle management authority shall cancel the motor vehicle driver's license and note it in the registration records. Therefore, all drivers should pay attention to whether their driver's license is about to expire.

7

2

Share

Does Driving with Windows Open Consume More Fuel?

It creates drag, thus consuming more fuel. When driving below 80 km/h, opening windows is indeed more fuel-efficient than using air conditioning. However, when the speed exceeds 80 km/h, the increased wind resistance from open windows makes it less fuel-efficient than using air conditioning. Here are some fuel-saving driving tips: Avoid opening windows on highways: It is not recommended to open windows for ventilation during high-speed driving; instead, use air conditioning for cooling. Maintain a steady speed: Try to keep the car's speed between 65 km/h and 90 km/h. Regularly check tire pressure and wear: Insufficient tire pressure or severe tire wear can lead to increased fuel consumption. Reduce vehicle weight reasonably: Remove items that are not frequently used in the car. Generally, every additional 100 kg of weight increases fuel consumption by 4.4%. Use the correct fuel grade: Fill the car with the recommended gasoline grade; avoid using fuel with a higher or lower grade than required.

12

1

Share

How to Use the Vezel Electronic Parking Brake?

Why Won't the Car Starter Work?

What is the cause of fault code C0045?

Is the BYD Qin Pro compliant with China's National VI emission standard?

What is the Difference Between Diesel Engine Oil and Gasoline Engine Oil?

How many days in advance can I renew my driver's license before it expires?

Does Driving with Windows Open Consume More Fuel?

How to Register a Change in Wheel Size?

What is the difference between automatic transmission and manual transmission?

Is it okay to press the brake when shifting gears in a manual transmission?

What is the purpose of mybmw?