How to Use the Seat Heating Function in Lynk & Co 03?

Can I leave my driver's license at home if I have an electronic one?

In cities where electronic driver's licenses have been implemented, you can travel without carrying a paper driver's license. Electronic Driver's License: The electronic driver's license, commonly known as e-license, provides drivers with online 'show license and code' services to better facilitate public affairs and travel. It will be fully promoted nationwide in 2022. Usage Scope of Electronic Driver's License: The electronic driver's license is universally applicable in all networked traffic areas across the country. However, according to regulations, it is still advisable to carry the physical driver's license and vehicle registration certificate with you (or in the car). The electronic driver's license can be used in multiple scenarios such as law enforcement management and public services. During law enforcement inspections, if a driver presents an electronic driver's license, the public security traffic management department will no longer check the paper driver's license.

15

3

Share

What is the main function of the throttle?

The throttle is a controllable valve that regulates the entry of air into the engine. After entering the intake pipe, the air mixes with gasoline to form a combustible mixture, which then burns to perform work. It is connected to the air filter at the top and the engine block at the bottom, often referred to as the throat of the car engine. More related information is as follows: 1. There are two types of throttles: the traditional cable-operated type and the electronic throttle. In traditional engines, the throttle control mechanism operates via a cable (flexible steel wire) or linkage rod, with one end connected to the accelerator pedal and the other to the throttle linkage plate. 2. The electronic throttle primarily uses a throttle position sensor to adjust the throttle opening angle based on the engine's energy requirements, thereby regulating the amount of air intake.

11

5

Share

Is Slow Tire Leakage a Quality Issue for New Cars?

It is not a quality issue. During daily vehicle use, conducting necessary travel inspections is crucial. The phenomenon of slow tire leakage is not uncommon, and the specific reasons for slow leakage can be summarized as follows: Tire valve area: The original vehicle comes with an external protective cap for the tire valve. If it is missing or falls off, dirt and debris can easily enter the valve core, accelerating internal seal aging, rust, etc., which can easily lead to air leakage. Therefore, in addition to taking preventive measures, regular inspections are also essential. Obvious punctures or penetrations on the tread: Obvious punctures or penetrations on the tread, such as those caused by foreign objects, can result in slow leakage when the object is not removed. Identifying this point allows for repair to stop the leakage.

4

5

Share

How Often Should a New Battery Be Charged?

For the first charge, continuously charge for more than 12 hours. Subsequent charges only require 6 to 8 hours. The battery should be charged when its power drops to 60%. When not in use, maintain charging twice a month to prevent self-discharge. Battery Charging Precautions: New batteries often do not reach full capacity after the first charge and should undergo a discharge cycle. Discharge at a 20-hour rate (i.e., discharge with a current equal to 1/20 of the rated capacity until the single-cell voltage drops to 1.75V), then recharge until fully charged. If the capacity remains below 90% of the rated capacity after one charge-discharge cycle, perform another cycle. Battery Maintenance Methods: Wipe the exterior of the battery with a damp cloth to remove dust, grease, white powder, and other contaminants that may cause leakage from the panel and terminals (positive and negative poles). Regular cleaning prevents the accumulation of white acidic corrosion powder on the terminals and extends the battery's lifespan.

4

1

Share

What does Honda Cruise mean?

Honda CRUISE indicates that the cruise control is currently active, allowing the driver to maintain a fixed speed without pressing the accelerator pedal. To activate Honda's cruise control, press the cruise control switch on the steering wheel, and the cruise control system indicator will appear on the instrument cluster. Press the accelerator pedal until the vehicle reaches the desired speed (30 km/h). Press the "SET" side of the "RES/SET (Resume/Set)" switch on the steering wheel and release it, then you can release the accelerator pedal. To temporarily deactivate the system, press the brake pedal or move the cruise control switch to the "OFF" position. To resume the set cruising speed, release the brake or clutch pedal and press the resume function button again. The cruise control system is not suitable for all situations. In principle, cruise control should be used on highways or fully enclosed roads, as complex road conditions on non-enclosed roads can compromise traffic safety. When using the cruise control system, always set an appropriate speed based on road limits, traffic flow, road conditions, and other factors. Avoid using cruise control when driving on slopes, slippery roads, or winding roads to prevent safety incidents.

18

5

Share

How to Adjust Tire Wear?

Tire wear adjustment methods are as follows: 1. Adjust tire pressure. Both overinflation and underinflation can cause uneven tire wear. When tire pressure is too low, the tire bends inward, which can lead to severe wear on the tire edges. When tire pressure is too high, the central tread of the tire will experience accelerated wear. Therefore, it's important to regularly check whether the tire pressure is at a normal level. Generally, inflating or deflating according to the vehicle's specified tire pressure is sufficient. 2. Perform wheel balancing regularly. Due to manufacturing processes or certain external factors, the mass distribution of wheel components may become uneven. When car wheels rotate at high speeds, this can create dynamic imbalance. To prevent or correct this condition, counterweights are added during dynamic conditions to balance the wheel edges, thereby avoiding uneven tire wear. 3. Perform wheel alignment regularly. Wheel alignment enhances driving safety, extends tire lifespan, reduces fuel consumption, minimizes tire wear, and decreases suspension component wear. Therefore, it's essential to schedule regular wheel alignment at 4S shops or professional repair facilities.

3

0

Share

How to Use the Seat Heating Function in Lynk & Co 03?

Can I leave my driver's license at home if I have an electronic one?

What is the main function of the throttle?

Is Slow Tire Leakage a Quality Issue for New Cars?

How Often Should a New Battery Be Charged?

What does Honda Cruise mean?

How to Adjust Tire Wear?

How to Adjust the Rearview Mirror Inside the Car?

What Should Novice Drivers Pay Attention to When Driving on the Road?

What is the walking speed when a bulldozer tows a vehicle?

Are Semi-Slick Tires Slippery in the Rain?