How to Use the One-Button Start in Hongqi H5?

What is the state of the throttle valve after the engine shuts down?

When the car is turned off, the throttle valve is operational and remains in the closed position. Introduction to the throttle valve: The throttle valve is a controllable valve that regulates the entry of air into the engine. Once the air enters the intake pipe, it mixes with gasoline to form a combustible mixture, which then ignites to perform work. Connected to the air filter at the top and the engine block at the bottom, it is often referred to as the throat of the car engine. Classification of throttle valves: Throttle valves are categorized based on their intake methods into straight-through and bypass types. The straight-through throttle valve maintains the same opening degree when the engine is off as it does during idle, while the bypass throttle valve adjusts the amount of air intake through the bypass air passage via the idle control valve.

9

4

Share

Will deformed engine mounts affect the operation of the half-shaft?

Deformed engine mounts will affect the operation of the half-shaft. Reasons for the impact: When the transmission mount starts to fail, severe shaking and vibration occur, causing resonance with the vehicle body and increasing vibrations inside the car. If the transmission mount completely fails, it can affect gear shifting, making it difficult to shift gears. Additionally, each gear shift causes the transmission to jerk, creating a noticeable impact inside the vehicle. Over time, this can lead to issues with the transmission's shifting mechanism. Repair recommendations for damaged mounts: If abnormalities are detected, it is advisable to visit a 4S store or a professional auto repair shop as soon as possible for a thorough inspection by a qualified technician. Once the issue is identified, appropriate solutions should be implemented based on the specific problem to avoid unnecessary complications.

14

5

Share

What is the service life of rear tires?

Tire lifespan is generally 6-8 years. While tire manufacturers do not provide a definitive statement, it is commonly recommended to use tires for 3-5 years or 60,000-80,000 kilometers before considering replacement based on mileage or wear condition after inspection. Influencing factors: Tire longevity depends on various factors such as climate, road conditions, driving habits, installation, maintenance, etc. Of course, replacement isn't strictly required after exactly 3 years or 60,000 km - if issues like sidewall punctures or tire bulges occur during daily use, immediate replacement is necessary. Tires aren't expensive, but safety is paramount. Replacement criteria: According to international regulations, tires must be replaced when the tread depth wears down to 1.6 millimeters under normal usage conditions.

10

3

Share

Can a Faulty Fuel Injector Cause Engine Misfire?

A faulty fuel injector can cause engine misfire and may also lead to some other symptoms. Engine Vibration: When a car's fuel injector is damaged and fuel injection becomes uneven, the engine may exhibit symptoms such as operational vibration during operation. Reduced Power and Increased Fuel Consumption: As the fuel injector deteriorates, the fuel injection volume and pressure cannot be guaranteed, leading to symptoms like decreased vehicle power and increased fuel consumption. Increased Exhaust Emissions Pollution: Malfunctions in the engine's fuel injector will inevitably affect the mixing and combustion of the combustible air-fuel mixture, resulting in increased pollutant emissions from the vehicle's exhaust. Engine Misfire: If the fuel injector of a particular cylinder is severely damaged, the engine is highly likely to experience misfire, which can cause severe engine vibration.

17

5

Share

Can the Daytime Running Lights of an Electric Vehicle Be Turned Off?

Electric vehicle daytime running lights can be turned off by following these steps: First, insert the ignition key with the ignition switch in the off position. Move the turn signal switch to the left turn position, then pull the high beam lever upwards to keep the high beam lights on. Next, turn on the ignition switch and hold it for about 5 seconds. Finally, return the ignition switch to its original position, and the daytime running lights will be turned off. Daytime running lights are a new type of signal light primarily used during daytime driving and can also be utilized in foggy or rainy weather conditions to make oncoming vehicles aware of your presence. These lights are typically preset by the manufacturer as a default setting.

13

4

Share

How Many Kilometers Should a Heavy Truck Go Before Changing Engine Oil?

Heavy trucks generally require an engine oil change every 5,000 kilometers. Below is relevant information about automotive engine oil: 1. Importance: Engine oil is extremely crucial for the engine. Inside the engine, it not only serves as a lubricant but also performs functions such as cleaning, sealing, buffering, rust prevention, and heat dissipation. 2. Working Principle: When the engine is running, the oil forms a thin film on the surfaces of various components within the engine, preventing direct contact and friction between these parts. 3. Regular Replacement Needed: The performance of engine oil degrades over time with use, necessitating regular replacement. Prolonged intervals between oil changes can accelerate engine wear.

18

1

Share

How to Use the One-Button Start in Hongqi H5?

What is the state of the throttle valve after the engine shuts down?

Will deformed engine mounts affect the operation of the half-shaft?

What is the service life of rear tires?

Can a Faulty Fuel Injector Cause Engine Misfire?

Can the Daytime Running Lights of an Electric Vehicle Be Turned Off?

How Many Kilometers Should a Heavy Truck Go Before Changing Engine Oil?

How many years is the license renewed if 12 points are deducted within 10 years?

What kind of slippers can be worn while driving?

What car is the one with 'very' at the back?

What is the battery model for BYD F3 key?