How to Use the One-Button Start for Haval H6 Automatic Transmission?

What Does the Triangle with Exclamation Mark Symbol Mean?

A triangle with an exclamation mark inside indicates a malfunction in the vehicle's regular performance, components, or functions. Common issues include parking sensor failure, fuel cutoff system intervention or malfunction, exterior light failure, or engine oil pressure sensor failure. Solution: Visit a 4S shop for inspection to identify the source of the fault. The exclamation mark is a common fault indicator in vehicles. Besides the triangle with an exclamation mark, there are four other forms of exclamation mark warnings: a yellow gear with an exclamation mark, a red circle with parentheses and an exclamation mark in the middle, a yellow parenthesis with a horizontal line and an exclamation mark in the middle, and a yellow light bulb with an exclamation mark. Below is a detailed analysis of these four scenarios: Automatic Transmission Fault: A yellow gear with an exclamation mark indicates an automatic transmission fault warning light, signaling a transmission issue or low transmission fluid. Transmission fluid should be replaced promptly. Brake System Fault: A circle with parentheses and an exclamation mark in the middle represents a brake system warning, typically indicating a brake system malfunction or low brake fluid. Immediate inspection of the brake system is required to avoid accidents. Tire Pressure Abnormal: A parenthesis with a horizontal line and an exclamation mark in the middle indicates a tire pressure monitoring warning light, which illuminates when the tire pressure is too low. Check the tire pressure and restore it to the normal range. Lighting Fault: A yellow light bulb with an exclamation mark is a lighting fault indicator, signaling a malfunction in one of the vehicle's lights. Solution: Visit a 4S shop for inspection as soon as possible, or perform a self-check focusing on commonly used bulbs such as turn signals, fog lights, and interior lighting to identify the issue.

6

4

Share

What is the ground clearance of a sports car?

The ground clearance of supercars is never less than 7cm. The LP640 has a minimum ground clearance of 14cm, which reduces to around 10cm when fully loaded. The standard ground clearance for an F1 car is 8cm, and when fully loaded (full fuel + driver), it can be as low as 5-7cm, depending on the specific model and suspension stiffness. Vehicles driven on public roads cannot go below these standards. The chassis serves to support and mount the car's engine and its various components and assemblies, forming the overall shape of the vehicle. It also receives power from the engine to enable motion and ensure normal operation. Additionally, a well-designed chassis can safeguard the driver's life.

17

4

Share

What is the normal tire pressure for a Geely Boyue?

The normal tire pressure for a Geely Boyue is between 2.4-2.5 bar. Due to seasonal factors, the tire pressure can be appropriately increased by 0.2 bar in winter and decreased by 0.1 bar in summer. The tire pressure monitoring system in the Geely Boyue can be viewed on the dashboard, specifically under the special function prompts (tire pressure monitoring, active safety information, including distance alerts, ACC cruise mode, lane departure warning, collision warning, PEPS, etc.). The tire pressure monitoring reset method for the Boyue is relatively simple; just driving for a while will restore it to normal data without any additional settings. If the tire pressure monitoring indicator light comes on (a yellow symbol with an irregular circle, no stamp on top, four small spikes at the bottom, and an exclamation mark inside), there are generally three possible reasons: Abnormal tire pressure. Typically, the system will alert if the pressure is below 1.8 bar or above 3.0 bar. In this case, the tires need to be checked and the pressure adjusted. Tire pressure monitoring not reset. After inflating the tires, if the tire pressure reset is not performed promptly, the system will still record the previous data, causing the tire pressure monitoring light to stay on. Simply performing a tire pressure reset will resolve this issue. Damaged tire pressure sensor. The tire pressure sensor, which monitors tire pressure, is installed inside the tire and connected to the tire inflation valve. If the sensor is damaged during driving (e.g., by hitting a curb), it can trigger the tire pressure warning light. In case of sensor damage, the only solution is to replace it with a new part.

18

1

Share

What are the reasons for the SITRAK turn signal not working?

Open circuit, flasher relay failure, excessive contact gap. The following is the relevant content: 1. Turn signal: The turn signal is an important indicator light that is turned on when a motor vehicle turns to alert vehicles and pedestrians in front, behind, left, and right. The turn signal bulb uses a xenon bulb, controlled by a single-chip microcomputer circuit, working continuously with alternating left and right flashes. The turn signal uses a flasher to achieve light blinking. It can be mainly divided into three types: resistance wire type, capacitor type, and electronic type. 2. Introduction to SINOTRUK SITRAK: SINOTRUK SITRAK was established in 1958 and is a provincial key state-owned sole proprietorship enterprise.

6

4

Share

Why Does the Car Stall During Driving Practice?

During the learning process, stalling is mostly caused by poor coordination between the throttle and clutch. Here are some precautions for beginners: 1. Don't forget to engage the handbrake when parking: Failing to do so may lead to the risk of the car rolling, which can not only damage your own vehicle but also potentially harm others' property or even lives. 2. Don't forget to release the handbrake when starting: When first learning to drive, always follow the correct sequence when starting the car. Regardless of whether the handbrake was engaged when parking, always check and release it before starting. 3. Don't forget to shift to neutral when exiting the car: Forgetting to shift back to neutral or P after parking can easily cause the car to stall.

12

4

Share

How to Distinguish Between Good and Bad Car Air Filters?

Here are the methods to distinguish between good and bad air filters: 1. Water test - this is the most crucial and simplest method, especially for those without experience. Water is the best way to test the quality of an air filter. Place the air filter flat on the ground or a table and sprinkle some water on the filter paper: (1) If the water seeps into the filter paper within 5 minutes, it is made of cotton pulp paper and must not be used. (2) If the water seeps in within 2-5 hours, the filter is made of low-grade wood pulp paper. It can be used but will affect the air compressor's efficiency (higher electricity consumption, less air output). Due to their relatively lower price, such filters are commonly used in the air compressor industry despite their drawbacks. (3) If the water takes 12-15 hours to seep in, it is a mid-grade filter paper. Typically, better-quality domestic machine manufacturers use such filters as original equipment consumables. (4) If the water does not seep in even after 24 hours, it is definitely a high-grade filter paper, usually chosen by high-end machine manufacturers as original equipment consumables. 2. Check the filter paper's uniformity, light transmittance, and surface smoothness by holding it up to a light source. Uniform and fine texture, good light transmittance, and smooth surface indicate high filtration precision and good air permeability. 3. Examine the depth and number of pleats in the filter paper. A deeper and more pleated filter paper indicates a larger filtration area, which generally results in better air permeability.

15

5

Share

How to Use the One-Button Start for Haval H6 Automatic Transmission?

What Does the Triangle with Exclamation Mark Symbol Mean?

What is the ground clearance of a sports car?

What is the normal tire pressure for a Geely Boyue?

What are the reasons for the SITRAK turn signal not working?

Why Does the Car Stall During Driving Practice?

How to Distinguish Between Good and Bad Car Air Filters?

How to Clear the Vehicle Condition Check Code on Golf 7?

What is the ground clearance of the 10th-generation Accord?

What is the fuel tank capacity of the Fengjun 5 in liters?

Does the BMW M2C come with a manual transmission model?