How to use the GAC GS3 navigation system?
1 Answers
GAC GS3 navigation system usage method is as follows: 1. The GAC GS3 center console panel adopts a snap-on design. For complete removal, a pry bar and a Phillips screwdriver are required. 2. Start prying from the bottom of the center console panel. After prying it open, remove the wiring harness and take out the original radio panel. 3. Install the navigation system by connecting the plugs. If unsure, refer to the car navigation manual for guidance. 4. Install the GPS receiving antenna and the rearview camera. 5. Route the rearview camera wiring harness along the door edge seal to the rear seats, then fold down the rear seats and pass it through to the trunk. 6. Install the rearview camera inside the license plate light, then route the camera wiring harness back and complete the installation. 7. Test for any issues. If everything is normal, reinstall in the reverse order of removal.