How to use the cruise control on Roewe RX5?

What does the red exclamation mark in Audi A3 mean?

The red exclamation mark indicates a very serious problem in the corresponding system. When this occurs, do not continue driving. Pull over safely and contact a professional for assistance immediately to prevent unpredictable risks to both the vehicle and personal safety. An exclamation mark on the car dashboard indicates an abnormality or malfunction in the corresponding system. There are many dashboard warning lights with exclamation marks, such as the tire pressure indicator, lighting fault indicator, steering system fault indicator, brake system fault light, transmission fault indicator, and wiper fault indicator. Below is a detailed explanation of the exclamation mark warning lights: General Fault: A triangle with an exclamation mark inside indicates a general performance or component malfunction. Common issues include parking sensor failure, fuel cutoff system intervention or failure, external light failure, or engine oil pressure sensor failure. Visit a 4S shop for inspection to identify the source of the fault. Automatic Transmission Fault: A yellow gear with an exclamation mark inside is the automatic transmission fault warning light, indicating a transmission malfunction or low transmission fluid level. Replace the transmission fluid promptly. Brake System Fault: An exclamation mark inside a circled parenthesis indicates a brake system warning, such as brake system failure or low brake fluid level. Inspect the brake system immediately to avoid accidents. Tire Pressure Anomaly: An exclamation mark below a horizontal line inside a parenthesis is the tire pressure monitoring warning light, which illuminates when the tire pressure is too low. Check the tire pressure and restore it to the normal range. Lighting Fault: A yellow bulb with an exclamation mark is the lighting fault indicator, signaling a malfunction in the vehicle's lights. Solution: Visit a 4S shop for inspection or check commonly used bulbs like turn signals, fog lights, or interior lights to identify the issue. Additionally, during daily vehicle use, dashboard warning lights are categorized into yellow and red for different severity levels: Yellow indicates a fault in the corresponding system that is not critical. Reduce speed and proceed to a repair shop to address the issue and eliminate potential hazards. Note: When starting the car, all warning lights will illuminate briefly for a system self-check and then turn off. If a light does not turn on during ignition, remains lit, or lights up while driving, it indicates a fault in the related system. Seek professional assistance promptly to inspect and resolve the issue for safety.

1

Share

What Causes the Popping Sound from Accord's Exhaust Pipe?

Whether the popping sound from the exhaust pipe is normal depends on the location and volume of the sound. Here are the details: 1. The sound from the exhaust pipe depends on two aspects: one is the material of the exhaust pipe and its sound tuning, and the other is the installation of the exhaust system. 2. The popping sound may originate from the blow-off valve on the mixer. If the vehicle is equipped with a turbocharger, pressing the accelerator with an aftermarket blow-off valve installed can also produce a popping sound. If the sound comes from the blow-off valve on the mixer, it is normal. If the sound is near the exhaust pipe, improper installation may be the cause, and it is recommended to visit a 4S store for inspection and repair.

20

1

Share

Where to Renew Driver's License in Dandong?

To renew a driver's license in Dandong, you should bring the relevant documents to the local Vehicle Management Office for processing. Below is an introduction to driver's licenses: 1. Introduction: A driver's license (full name: Motor Vehicle Driver's License), also known as a "driver's permit," is a document issued by the government's transportation department to individuals who qualify to drive, usually in the form of a card. 2. Types: To obtain a driver's license, one must meet the minimum age requirement and pass a driving test. The license usually specifies the types of motor vehicles the holder is permitted to drive, such as motorcycles, passenger cars, trucks, buses, etc. 3. Process: Only after a driver has completed study, training, and assessment will the Traffic Police Department of the Public Security Bureau issue a qualified driver's certificate.

13

1

Share

What are the foot movements for reverse parking?

Press the clutch with your left foot and the brake with your right foot, slowly release the clutch, and reverse the car slowly. When reaching the designated position, gently press the brake all the way down. Below is an introduction to reverse parking: 1. Introduction: Reverse parking is a mandatory test item for obtaining a small car driver's license after 2013. It assesses the driver's ability to operate the vehicle in a designated area. Reverse parking is an evaluation point in the driver's test, which involves maneuvering the vehicle correctly into the garage from both sides while in motion. 2. Classification: The most common types of reverse parking are three. The first is the 'non'-shaped reverse parking, commonly seen in large shopping malls. The second is the roadside 'one'-shaped reverse parking, also known as parallel parking. The third is the less common diagonal reverse parking.

2

5

Share

Why Did a New Car Become a Dead Title Car?

A new car turning into a dead title car might be due to purchasing a vehicle of unclear origin, inability to locate the original owner, or unresolved debt disputes. Below are some important considerations for using a new car: 1. Avoid Overloading: Carrying excessive weight during the break-in period can damage mechanical components. Since the powertrain parts of a new car have not yet fully worn in, aggressive acceleration can cause irreversible damage. Therefore, it's essential to adhere to the principle of 'slow and steady' during the break-in period. 2. Speed Limits for New Cars: There are speed restrictions during the break-in period. Domestic cars generally have a limit of 40~70 km/h, while imported cars usually cap at 100 km/h. When the throttle is fully open, the speed should not exceed 80% of the maximum speed. The recommended engine RPM during the break-in period is between 2000~4000 RPM.

20

2

Share

What does the u180187 fault code mean?

It is recommended to use a fault diagnostic tool to read the fault code and determine its specific meaning. Here is a relevant introduction about automotive fault codes: 1. Meaning: An automotive fault code is a code that reflects a fault analyzed by the vehicle's computer ECU after a fault occurs. Common fault codes are usually caused by sensor malfunctions or poor sensor performance. However, some mechanical faults cannot be read by the ECU. The vehicle's dashboard may display some basic fault indications, but these are only a small part. The main diagnosis still requires the use of a decoding tool. There are many types of decoding tools, such as X-431 and KT300, but their working principles and the fault codes they read are the same. 2. Classification: Fault codes are divided into real codes, historical codes, and intermittent codes. Real codes are easy to detect, historical codes, as the name suggests, are unresolved fault codes from the past, while intermittent fault codes are not fixed.

6

3

Share

How to use the cruise control on Roewe RX5?

What does the red exclamation mark in Audi A3 mean?

What Causes the Popping Sound from Accord's Exhaust Pipe?

Where to Renew Driver's License in Dandong?

What are the foot movements for reverse parking?

Why Did a New Car Become a Dead Title Car?

What does the u180187 fault code mean?

Why Does the Car Window Glass Fog Up When Using Air Conditioning in Summer?

Why is there no file number on the vehicle license?

Are Normal Windshield Wipers Silent?

What are the length, width, and height dimensions of the Mercedes-Benz GLC300L Dynamic model?