How to Use the Cruise Control in the Mazda 3 Axela?

1 Answers
SanCamilla
07/29/25 12:45pm
Here is how to use the cruise control in the Mazda 3 Axela: 1. Press the "ON" button on the multifunction steering wheel to activate cruise control, then use the "+" and "-" buttons to adjust the speed. Once set, the car will maintain the speed selected by the driver. 2. Press "CANCEL" to deactivate cruise control, and press "RES" to resume it. 3. Use the "SET" button to set the cruising speed. This should be done before activating cruise control. Precautions for using cruise control. Cruise control will automatically deactivate when the brake pedal is pressed, or it can be manually canceled by pressing "CANCEL". It is best to use cruise control on simple, flat road conditions. Avoid using it during rain, snow, or on slopes, as this increases safety risks. In case of emergencies, the driver may not react in time. Cruise control can increase fuel consumption, especially when going uphill, as it maintains a constant throttle input. To avoid higher fuel consumption, avoid frequent use of cruise control.
Was this review help?
7
3
Share
More Forum Discussions

How many seats does the Audi Q7 have?

Audi Q7 is available in 5-seat and 7-seat configurations. Here is more relevant information: 1. Exterior of the new Audi Q7: The exterior dimensions of the new Audi Q7 are 5052mm in length, 1968mm in width, and 1741mm in height, with a wheelbase of 2994mm, showing little change compared to the previous generation Q7. The overall exterior style of the new Q7 continues Audi's family design, with more angular lines and exaggerated hexagonal chrome decorations added to the front grille. 2. Audi Q7's four-wheel steering system: The Audi Q7 is equipped with a four-wheel steering system. At low speeds, the rear wheels turn in the opposite direction during steering, reducing the turning radius and the width of the driving trajectory. At high speeds, the rear wheels turn in the same direction, improving wheel response speed, dynamic performance, and stability. Additionally, the four-wheel steering system effectively assists the intelligent parking system and trailer assist system.
2
0
Share

Any Tips for Memorizing the Route Map in Driving Test Subject 3?

You can use paper to note down the sequence of road sections, such as straight driving first, followed by traffic lights, then passing through deceleration zones, etc. Reasons for nervousness: Unfamiliarity with the Subject 3 route is not the most important cause of nervousness; lack of technical proficiency is. However, this statement isn't entirely accurate either, as all learners are beginners with generally average skills. Some responsible instructors may take students around the test route several times before the exam to familiarize them with the venue, while others might even allow students to take the test without any simulation training. Maintaining a good mindset: If you encounter an irresponsible instructor, you should spend more time during regular practice to memorize driving techniques. Some students perform effortlessly during training but repeatedly struggle in the actual exam, so cultivating a good mindset is also crucial.
9
5
Share

What does the scheduled session for Subject One mean?

Subject One exam sessions refer to the different exam time slots scheduled by the vehicle management office for the same day's Subject One test. Each session lasts 45 minutes, and the number of sessions per day is determined by the office based on its capacity. For example, the first session typically starts at 9:00 AM, while the second session usually begins at 10:00 AM. Here are specific details about the driving test: 1. Subjects: The exams are conducted in the order of Subject One, Subject Two, Subject Three, and Subject Four. 2. Retakes: For Subject Two and Subject Three, candidates can only take each exam up to five times. If they fail after the fifth attempt, they must re-enroll and pay the tuition fee again. According to the Ministry of Public Security's Orders No. 123 and 124, if a candidate fails the fifth scheduled exam for Subject Two or Subject Three, all previously passed subjects will be invalidated. To obtain a driver's license, the candidate must re-register and pay the tuition fee to the driving school.
11
2
Share

What is the correct parking procedure for an automatic transmission car?

Correct parking procedure for an automatic transmission car: 1. Press the foot brake to stop the car, shift the gear from D to N; 2. Pull up the handbrake, turn off the engine and release the foot brake, but do not turn off the power; 3. Press the foot brake again, shift the gear from N to P, release the foot brake, turn the key back to turn off the power and pull out the key. Correct starting procedure for an automatic transmission car: 1. Turn the ignition key to the second position (power mode), let the car's computer system self-check for at least 6 seconds, press the foot brake, shift the gear from P to N; 2. Release the foot brake, turn the ignition key to the start position to start the engine; 3. Press the foot brake, release the handbrake, shift the gear from N to D, slowly release the foot brake to start, then smoothly press the accelerator according to road conditions to drive safely.
17
3
Share

How to Tell if an Exam Car is Started or Not?

Check the tachometer on the dashboard; the needle on the dashboard is at zero when the car is not started. Here are some solutions for a car that won't start: 1. Insufficient car battery power or low fuel: Depending on your situation, you can seek help from nearby car owners for emergency measures like jump-starting, borrowing fuel, or towing. 2. Steering wheel locked and unable to start: Try turning the key while gently shaking the steering wheel. 3. Incorrect gear position: Shift to the correct gear and then attempt to start the car. Here is additional information on reasons why a car may not start: 1. Electrical or electronic faults: Blown fuse, open circuit in the high-voltage coil, open circuit in the low-voltage circuit, detached central ignition wire, leaking distributor head, damaged spark plug. 2. Fuel system issues: Malfunctioning fuel pump, blocked fuel line, clogged fuel filter, carbon buildup on spark plugs, damaged fuel injector.
6
0
Share

How to start a Kia K5 with a dead battery?

If the battery of a Kia K5 is dead, you can start it by jump-starting with another vehicle. Here's how to jump-start the car: 1. Open the hoods of both vehicles. Connect the negative terminal of the jumper cable to the negative terminal of the dead battery, and the other end to the negative terminal of the assisting vehicle's battery. Similarly, connect the positive terminal of the jumper cable to the positive terminal of the dead battery, and the other end to the positive terminal of the assisting vehicle's battery. 2. Start the engine of the assisting vehicle and rev it slightly, then try to start the car with the dead battery. The Kia K5 is a mid-size sedan with body dimensions of 4980mm in length, 1860mm in width, and 1445mm in height, with a wheelbase of 2900mm. It is equipped with a 1.5T turbocharged engine and a 2.0T turbocharged engine, paired with a 7-speed dual-clutch transmission and an 8-speed automatic transmission.
1
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.