···
Log in / Register

How to Use the Buick Excelle Windshield Wipers?

5 Answers
VanGarrett
07/29/2025, 01:51 AM

The method for using the Buick Excelle windshield wipers: The wiper control switch is located on the right side of the steering wheel. Turning it clockwise activates the rear wiper, while turning it counterclockwise turns it off. Pressing the control switch toward yourself activates the front wiper spray, and pushing it toward the dashboard activates the rear wiper spray. Windshield wipers, also known as wiper blades or windscreen wipers, are devices used to wipe away raindrops and dust attached to the vehicle's windshield, improving the driver's visibility and enhancing driving safety. In terms of appearance, the Buick Excelle features a large front grille with chrome trim, and the front headlights are connected to the grille, further highlighting the car's sporty character.

Was this review help?
2
4
Share
RachelFitz
08/12/2025, 04:25 PM

When using the Buick Excelle, I found the wiper operation quite simple—there's a lever control on the right side of the steering wheel. To activate the wipers, pull the lever toward yourself, and it will first spray cleaning fluid followed by a single wipe. For continuous rain, push the lever upward to start low-speed wiping, move it to the middle for intermittent mode (energy-saving for light rain), and push it to the highest position for high-speed wiping. The intermittent frequency can be adjusted via the dashboard settings button to adapt to varying rainfall levels. Daily use requires caution: avoid forcibly activating the wipers on dry glass, as this can damage the rubber blades or motor. During each maintenance check, inspect the wiper blades for wear. If they don’t clean effectively or produce unusual noises, replace them promptly—don’t wait until rainy days cause issues. Before starting, ensure the washer fluid is full; use antifreeze type in winter. Operate only when visibility is clear for safety.

Was this review help?
12
2
Share
Expand All
McAnna
10/03/2025, 03:57 AM

I'm quite accustomed to the Buick Excelle's windshield wipers. The control lever is right next to the steering wheel – just pull it to spray and wipe, perfect for emergencies when visibility gets blurry in the rain. It has three speed settings: push the lever to the middle position for intermittent wiping, ideal for light drizzles; push it to the top for high-speed wiping, most stable during heavy downpours; pull it back to the original position to turn it off. The intermittent timing can be adjusted in the car settings – shorter intervals for light rain, longer for heavy rain. Keeping the spray nozzles clean is crucial to prevent clogging and ensure fluid sprays properly. If the wipers aren't cleaning well, it might be due to aged rubber blades – replacing them before each rainy season is a reliable practice. When the windshield has oily residue, use cleaning fluid to wash it, preventing the wipers from skipping. The operation is simple – turn them on as needed, hassle-free and reassuring.

Was this review help?
15
1
Share
Expand All
DelJulian
11/16/2025, 09:48 PM

When driving the Buick Excelle, the windshield wipers are mainly operated via the stalk: pull to spray and wipe, push to adjust speed levels or intermittent mode. The focus is on safety and convenience. After starting in rainy conditions, switch to the appropriate gear—intermittent mode saves power during light rain, while high-speed mode ensures clear visibility during heavy rain. Use antifreeze washer fluid in winter to prevent freezing, and regularly check the nozzles to avoid clogging. Worn wiper blades can cause streaks, so replace them promptly to prevent accidents in rainy weather. The operation is straightforward and easy to master, making it suitable for beginners.

Was this review help?
3
4
Share
Expand All
PeytonMarie
01/06/2026, 11:25 PM

Using the Buick Excelle wiper is easy: locate the lever on the left side of the steering wheel. Pull the lever once for washer fluid spray and wiping action. Push the lever upward or downward to switch wiping speeds, with three options available—intermittent, low speed, and high speed. Choose the appropriate setting based on rain conditions; the intermittent mode allows you to set the time interval. Before activating the washer function, ensure the windshield washer fluid is topped up, preferably with a winter-grade antifreeze type. Inspect the wiper blades annually and replace them if they don’t clean effectively. The operation is straightforward and requires no second thoughts.

Was this review help?
13
2
Share
Expand All
More Forum Discussions

Why is Continental MC6 inferior to MC5?

As an upgraded product of the MC5, the Continental MC6 is certainly superior in performance to the MC5. The reason why some say the MC6 is inferior to the MC5 is mainly because some drivers have found that after switching to the MC6, this tire is very prone to throwing stones. Not only does it fail to reduce tire noise, but it also has the opposite effect, significantly impacting the driving experience. Below are the functions of car tires: 1. Support the entire weight of the vehicle: Car tires support the entire weight of the vehicle, bear the load of the car, and transmit forces and moments in other directions. 2. Improve vehicle performance: Car tires transmit traction and braking torque to ensure good adhesion between the wheels and the road, thereby improving the car's power, braking, and off-road capabilities; they work together with the car's suspension to mitigate impacts during driving and dampen the resulting vibrations. 3. Prevent early damage to car components: Car tires protect car components from severe vibrations and early damage, adapt to the vehicle's high-speed performance, reduce driving noise, and ensure safety, handling stability, comfort, and fuel economy.
16
1
Share

What is the Principle of Ventilated Seats?

Seat ventilation is achieved by adding fans to the back of the seat cushion and backrest foam. The fans draw in air and direct it into the ventilation layer. The airflow then permeates upward through the ventilation layer, passes through the heating pad, and flows toward the surface of the seat cover (which is made of perforated leather). This allows passengers to use the ventilation function in hot weather to dissipate sweat from the hips and back, providing a comfortable experience. The following are the performance requirements: 1. Ventilation system noise: When the seat is unloaded, the working noise of the ventilation device must be less than 50 decibels. 2. Operating voltage range: The ventilation device operates within a voltage range of +9V to +16V. When the voltage falls below the operating range, low-voltage protection will automatically short-circuit, causing the ventilation device to stop working. 3. Entry and exit simulation test: A standard dummy hip is swung within a certain angle, rotating the dummy hip from the inner side of the seat cushion to the outer side. One cycle is completed when the hip rotates to the outermost position. A specified number of cycles must be performed. After the test, the ventilation function must remain intact. 4. Knee test: A simulated knee ball joint is loaded with a certain force onto the seat cushion (over the area with the ventilation device). One cycle consists of up-and-down movements, and a specified number of cycles must be performed. After the test, the ventilation function must remain intact.
10
5
Share

What are the requirements for car loans in Chongqing?

Purchasers must be at least 18 years old and be Chinese citizens with full civil capacity. Purchasers must have a relatively stable job and a relatively stable economic income or possess assets that are easy to liquidate. During the loan application period, purchasers must deposit an amount lower than the down payment stipulated by the bank in their account at the bank's savings counter. They must also provide the bank with a guarantee approved by the bank. The following are some considerations when buying a car: 1. Body paint: Check the flatness of the body panels and bumpers; there should be no abnormal dents or bulges. Also, carefully inspect the paintwork, especially in areas that are prone to scratches during transportation. The surface color should be consistent, even, full, smooth, and free of pinholes, pits, wrinkles, bubbles, streaks, or scratches. 2. Car interior: The door windows should move up and down freely, reaching the top when raised and the bottom when lowered. The front seats should move freely back and forth with multiple fixed positions for passengers to choose the appropriate seating position. The doors and interior soft panels should be properly installed and should not come loose when pushed. 3. Chassis and battery: New cars may also leak oil, so check underneath for any oil spots or stains on the chassis. There’s not much to inspect on a new car battery, just check if the terminals are corroded and if the small window is green. Note that battery terminals are usually loose, so make sure to tighten them before driving away.
17
1
Share

What Causes the Car to Shake When the Air Conditioner is Turned On?

When the car shakes as soon as the air conditioner is turned on, it can be attributed to the following reasons: 1. Excessive compressor pressure: If idle shaking occurs immediately after turning on the air conditioner, it is likely due to issues with high and low pressure. Therefore, it is essential to check the air conditioner's high and low pressure to see if the pressure is too high. Excessive pressure increases the engine load, thereby affecting the car's stability. 2. Throttle needs cleaning: If idle shaking occurs when starting the car and turning on the air conditioner, it is crucial to check whether the throttle is clean. A dirty throttle can cause the engine to idle shake, leading to the car shaking phenomenon.
18
3
Share

Is Mobil Super 2000 a Full Synthetic Oil?

Mobil Super 2000 is a semi-synthetic engine oil. Here are some extended details: 1. If your engine uses mineral oil, even if you only drive 5,000 kilometers a year, manufacturers recommend an oil change every three months. 2. If you use semi-synthetic oil, even if the mileage hasn't been reached, maintenance is required every six months. 3. If you use full synthetic oil and drive less than 10,000 kilometers a year, you still need an annual oil change. 4. Generally, civilian engine oils are categorized into mineral oil, semi-synthetic oil, and full synthetic oil. The performance ranking of these oils is full synthetic > semi-synthetic > mineral.
8
5
Share

Is seat ventilation provided by AC air or natural air?

Seat ventilation generally uses natural air. Here is more information about seat ventilation: 1. Working principle: Seat ventilation is achieved by adding fans to the back of the seat cushion and backrest foam. The fans draw in air and direct it into the ventilation layer. The airflow then permeates upward through the ventilation layer, passes through the heating pad, and flows to the surface of the seat cover (the seat cover is made of perforated leather). 2. Advantages: When a passenger sits on the seat, the back of the body is in close contact with the seat surface, and the air in the contact area does not circulate, which is not conducive to sweat evaporation and can cause discomfort. The ventilation function effectively improves the air circulation in the contact area between the body and the seat surface, ensuring a dry and comfortable experience even during long rides.
20
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.