How to Use Front Parking Sensors?

What Causes Car Brake Lock-Up?

Reasons for car brake lock-up: For cars without ABS, if the brake pedal is pressed too hard while driving, the wheel speed will drop rapidly. When the braking force exceeds the friction between the wheels and the ground, the wheels will lock up. Fully locked wheels can lead to some dangerous situations. If the front wheels lock up, the vehicle will lose steering ability because the front wheels are the steering wheels. In this case, the vehicle will slide forward due to inertia, which can easily cause accidents. If the rear wheels lock up, the vehicle may skid sideways, which is extremely dangerous, especially on rainy or snowy roads. To avoid brake lock-up, try to avoid emergency braking. Anticipate potential hazards in advance and brake early. Brake before turning to reduce speed, not during the turn, as this can prevent wheel lock-up.

10

4

Share

Where is the power steering pump reservoir located on the Tiggo 3?

The power steering pump reservoir of the Tiggo 3 is located in the front engine compartment. The working principle of the car's power steering pump is that when the car is turning, the steering sensor detects the torque and intended direction of the steering wheel. These signals are sent to the electronic control unit via the data bus. The electronic control unit then issues action commands to the motor controller based on the transmitted torque, intended direction, and other data signals. The motor will output the corresponding amount of torque as needed, generating power steering. The Tiggo 3 has a length, width, and height of 4420mm, 1760mm, and 1670mm respectively, with a wheelbase of 2510mm, and a front-engine, front-wheel-drive layout. In terms of appearance, this car features a fashionable and dynamic front grille with piano black paint, newly designed eagle-eye-style headlight clusters, and 17-inch five-spoke aluminum alloy wheels, giving the overall exterior a more youthful and dynamic look.

9

3

Share

What Causes Squeaking Brakes at Low Speeds?

The reasons for squeaking brakes at low speeds: If the car is new, brake noise is normal because new brake pads require a break-in period to increase the contact area between the brake pads and discs, ensuring better braking performance. Additionally, severe tire wear, foreign objects on the brake pads, incorrectly installed or mismatched brake pads, or excessively thin brake pads can also cause brake noise. When you notice brake noise while driving, it's essential to stop and inspect the cause promptly to eliminate potential safety hazards. Foreign objects in the brake discs, such as sand or metal particles, can produce sharp noises when braking. In such cases, using a high-pressure water gun during car washing can help remove these particles. Failing to clean them promptly can accelerate brake pad wear and, in severe cases, damage the brake discs.

14

4

Share

How many cylinders does the Mercedes-Benz C180L engine have?

The Mercedes-Benz C180L is equipped with a four-cylinder engine. In terms of power, this car is powered by a 1.6T turbocharged engine, with a maximum power output of 115 kW and a maximum torque of 250 Nm. The engine is paired with a 9-speed automatic transmission in the drivetrain. The dimensions of the Mercedes-Benz C180L are 4783mm in length, 1810mm in width, and 1442mm in height. The exterior of the Mercedes-Benz C180L is stylish and elegant, giving off a premium look, with a more dynamic front fascia design, and the scratch-resistant paint is a major highlight of its appearance. The interior of the Mercedes-Benz C180L features exquisite craftsmanship, excellent sound system, rich configurations, spacious cabin with ample rear legroom, very good comfort, and a decent trunk space.

18

0

Share

How to Lift the Wiper Blades on a BMW 1 Series?

Method to lift the wiper blades on a BMW 1 Series: First, ensure the car is in the off state but do not press the brake pedal. Press the start button without igniting the engine, just to power on the car. After keeping the car powered on for about 5 seconds, press the start button again to turn off the power. Then, push the wiper control lever all the way up and hold it for 3 seconds, and the wiper blades will lift up. The dimensions of the BMW 1 Series are 4239mm in length, 1748mm in width, and 1421mm in height, with a wheelbase of 2660mm. The luggage compartment volume ranges from 330 to 1150L, and it features a front-engine, rear-wheel-drive layout. In terms of configuration, the BMW 1 Series comes standard with LED headlights, an 8.8-inch central touchscreen display, brake assist, driving assistance imaging, keyless start, driving experience control system, and emergency call function.

19

0

Share

What are the exterior dimensions of the Audi A4L?

The exterior dimensions of the Audi A4L are 4761 mm in length, 1826 mm in width, and 1439 mm in height, with a wheelbase of 2869 mm. The drive configurations include front-wheel drive and front-mounted four-wheel drive. In terms of interior design, this model continues the family-style design with exquisite craftsmanship and high-quality materials. The slightly driver-oriented black center console and the textured black interior give a more comfort-oriented feel. The elegant light gray color scheme across the lineup exudes a sense of stability and sophistication. In terms of power, the Audi A4L is equipped with four-cylinder engines across all variants, including a low-power 2.0-liter turbocharged engine, a mid-power 2.0-liter turbocharged engine, and a high-power 2.0-liter turbocharged engine.

12

1

Share

How to Use Front Parking Sensors?

What Causes Car Brake Lock-Up?

Where is the power steering pump reservoir located on the Tiggo 3?

What Causes Squeaking Brakes at Low Speeds?

How many cylinders does the Mercedes-Benz C180L engine have?

How to Lift the Wiper Blades on a BMW 1 Series?

What are the exterior dimensions of the Audi A4L?

What is the Nissan Bluebird?

Where to Check the National Emission Standard of a Sedan?

How to Determine the Quality of a Car Air Conditioning Compressor?

Can I directly add more coolant if it's low?