How to Use Cruise Control in the Honda Avancier?

How to Read the Audi Oil Dipstick?

Check the oil level using the dipstick, with the ideal standard being that the oil level is between the upper and lower limits. Here is some relevant information: 1. Precautions: The recommended oil volume for an Audi A3 is between 3.5-4.0 liters. When adding oil, it's best to drain the old oil completely, then pull out the dipstick to check. Avoid overfilling, as excess oil can harm the engine. Adding around 3.8 liters is optimal. 2. Observation Method: The dipstick has upper and lower limit markings at its tip. Observe the portion wetted by oil. If the oil level is between the marks, the amount is correct. If it's above the upper limit, there's too much oil; if below the lower limit, there's too little, and you'll need to add an appropriate amount.

10

4

Share

Where is the Mazda 5 Cabin Air Filter Located?

Mazda 5 Cabin Air Filter is located near the left foot of the front passenger seat. Open a triangular cover panel, which consists of upper and lower filter elements. The glove compartment needs to be pressed down to see it. Functions of the cabin air filter: 1. Provide fresh air; 2. Ensure safety and hygiene; 3. Adsorb harmful substances; 4. Filter solid impurities. Taking the 2013 Mazda 5 as an example, its body structure is a 5-door 7-seat MPV, with body dimensions of: length 4585mm, width 1750mm, height 1620mm, wheelbase 2750mm, front track 1530mm, rear track 1520mm, fuel tank capacity 60L, and curb weight 1557kg.

10

5

Share

What to Do When Water Leakage from the Car Sunroof Causes Water Accumulation in the Floor Mats?

When water leakage from the car sunroof causes water accumulation in the floor mats, the following measures should be taken: 1. Immediately clean up the accumulated water inside the car and use a car vacuum to dry it: After wiping it clean, the vehicle should be promptly air-dried to evaporate any remaining water inside. If there is not much water inside, there is no need to remove the seats, but if there is a significant amount of water, the seats should be removed for drying. 2. While air-drying the seats, you can also check the electronic components inside the car: Look for any signs of short circuits or malfunctioning. If any issues are found, they should be replaced or repaired.

18

5

Share

Is It Normal for a Car to Shake When Turning Off?

It is not normal for a car to shake when turning off. Reasons for shaking: 1. Engine misfire, which mainly refers to one or more cylinders in the engine not working properly, often related to ignition coil failure; 2. Aging or loosening of engine mounts, which are the rubber blocks between the engine and the frame. Once these mounts age or loosen, the engine's vibration will become significantly worse. Replacing the mounts will greatly reduce the effect; 3. Issues with the ignition system. Check the working condition of the spark plugs, high-voltage wires, and ignition coils. Poor performance of the ignition system or bad spark plug firing can also cause such faults. Check if the spark plugs have excessive carbon buildup and replace them if necessary.

12

4

Share

What does Chery New Energy RVM mean?

Chery car RVM light on means there is a vehicle in the rear blind spot, please pay attention. Here is the relevant information: 1. RVM: RVM stands for Rear-Vehicle-Monitoring-System, its function is to remind you to pay attention to safety when there is a vehicle in the rear blind spot during lane changing. 2. Principle: This system uses sub-millimeter wave radar installed on the rear bumper to detect the left and right lanes and the distance between the rear vehicles. When changing lanes poses a danger, it alerts the driver by flashing indicator lights and sounding an alarm. This system adopts a 24GHz sub-millimeter wave radar with a wide sensing range and is less affected by bad weather and sunlight, ensuring high-precision detection of vehicles approaching from the rear even at high speeds.

12

4

Share

What Causes Coolant Leaks?

Coolant leaks can be caused by: 1. Sealing issues in the cooling system; 2. Loose connections between the antifreeze tank and radiator in the cooling system; 3. Aging and cracking of rubber hoses or corrosion and perforation of the radiator. The functions of coolant include: 1. Preventing freezing and expansion damage to the radiator and engine cylinder block during cold weather; 2. Protecting metal components from corrosion and rubber parts from aging; 3. Reducing scale buildup to avoid clogging circulation pipes and impairing the cooling system's heat dissipation; 4. Preventing engine overheating to ensure normal operating temperature; 5. Providing lubrication for the water pump, thermostat, and other components.

9

4

Share

How to Use Cruise Control in the Honda Avancier?

How to Read the Audi Oil Dipstick?

Where is the Mazda 5 Cabin Air Filter Located?

What to Do When Water Leakage from the Car Sunroof Causes Water Accumulation in the Floor Mats?

Is It Normal for a Car to Shake When Turning Off?

What does Chery New Energy RVM mean?

What Causes Coolant Leaks?

What Causes Body Vibration at Idle Speed?

How to Remove the Wiper Blades of Volkswagen Lavida?

How to Deal with Continuous Central Lock Alarm?

How long after the DMV accepts the application can I schedule the subject 1 test?